Influence of Fe2O3 and V2O5 on Crystalline Structure of Mg-Al Spinel Synthesized by Waste Aluminum Slag

Mg-Al spinel is synthesized by using industrial waste-residue and basic magnesium carbonate in the aluminum factory as the main raw materials. The influence of V2O5 and Fe2O3 mineralizers on the structure, cell parameters and microscopic morphology of synthesized Mg-Al spinel has been discussed. The Mg-Al spinel is characterized by using XRD, SEM and relevant analytical software, such as Philips plus, Rietveld quantification and so on. The experimental results show that certain amounts of V2O5 and Fe2O3 are beneficial to the formation of Mg-Al spinel, and the optimum addition of V2O5 and Fe2O3 is respectively 2wt% and 3wt%. V2O5 has few effects on cell parameters of Mg-Al spinel; but Fe2O3 can form solid solution with Mg-Al spinel in which Mg-Fe spinel can also dissolve to form continuous solid solution. Therefore, with the increase of Fe2O3 content, the cell parameters of Mg-Al approximately present linear increase.     

Studies on the Structure and Properties of Cordierite Synthesized by Talc-Magnesite

Homogeneous cordierite has been synthesized at low cost by talc-magnesite and coal gangue as the main raw materials. The mechanism of synthesizing cordierite under such a com- posing system of raw materials, and the effect of temperature on the crystal cell parameters and microstructure and thermal expansion coefficient of cordierite crystal have been studied via testing methods of XRD, SEM, etc. The result shows that the homogeneous cordierite can be synthesized by the systematic composing materials of “talc-magnesite—coal gangue—talc” with heat pre- servation at 1350 ℃ for 1 h; as the keeping time is prolonged, Al3+ and Mg2+ in cordierite crystal are replaced by a few impurity ions such as Fe3+, Fe2+, etc., and the crystal cell parameters of cordierite present an increase trend; as the high-temperature heat preservation is prolonged, the content of glassy phase in the sample is increased, its density is improved, and its thermal expansion coeffi- cient presents an increase trend.     

Structure and Aromaticity of AlCO-substituted Semibullvalene

The structures, energies and aromaticity (the nuclear-independent chemical shifts, NICS) of AlCO-substituted semibullvalenes were investigated at the B3LYP/6-311+G** level. Similar to BCO-substituted analogues, [2,6]-AlCO-semibullvalene is neutral bishomoaromatic. The NICS values reveal that the aromaticity of AlCO-substituted structures is smaller than that of BCO analogues.     

Growth, Band Structure and Optical Properties of LiSrBO3 Crystal

The bulk crystal of LiSrBO3 (8.39 g) with a size of 21mm×20mm×15mm was grown by high temperature solution growth method. The relationship between growth habit and crystal structure was discussed. The transmission spectrum shows an UV absorption edge at about 300 nm. The melting temperature of this crystal was determined to be 942 ℃ by DTA-TG measurement. The band structure of the LiSrBO3 crystal was studied by means of the first principle method. An indirect band gap was found to be about 4.0 eV,and a low dielectric constant was estimated to be about 1.9 in terms of theoretical results.     

基于离子迁移谱的假币用纸快速检测及溯源

该文采用离子迁移谱（IMS）对20种假币用纸进行分析,通过快速检测假币用纸中的可挥发性组分,构建假币用纸的指纹谱图库。基于主成分分析（PCA）和层次聚类分析（HCA）对迁移时间8～17.5 ms范围的迁移谱信息进行处理,从而对假币用纸进行分类。PCA可将同种假币用纸聚类,HCA则可进一步将20种假币用纸准确分类,其对6个未知来源的半成品假币的分类正确率达83.33%。结果表明,IMS快速检测分析是比较和分类假币用纸的有效方法。     

固相萃取/气相色谱-质谱法测定燃香烟气中9种大麻素类新精神活性物质

建立了同时测定燃香烟气中9种大麻素类新精神活性物质的气相色谱-质谱（GC-MS）分析方法。样品在燃香烟气收集装置中经溶剂提取,浓缩离心后,采用HLB固相萃取小柱净化,毛细管色谱柱Agilent HP-5MS毛细管柱（30 m×0.25 mm×0.25μm）分离,使用电子轰击电离（EI）源检测,SIM模式进行质谱监测,内标法对9种大麻素类化合物进行定量。结果表明,9种大麻素类化合物在27 min内完成分离分析,并在0.01～4.0 mg/L范围内具有良好的线性关系,相关系数（r2）均不小于0.999 5,方法的检出限（LOD,S/N=3）和定量下限（LOQ,S/N=10）分别为0.003～0.06 mg/L和0.01～0.2 mg/L。在阴性样品中进行1、2和10倍定量下限的加标回收实验,9种大麻素类化合物的回收率为74.8%～114%,相对标准偏差（RSD,n=6）为1.6%～9.1%。采用该方法对10种市售的燃香样品进行测定,均未检出大麻素类化合物。建立的方法操作简便,可快速对燃香烟气中大麻素类化合物进行定性和定量分析,且能满足发烟量大燃香的检测需求。该方法的建立为我国燃香中大麻素类...     

表层取样法结合气相色谱-串联质谱测定竹木砧板中19种防腐防霉剂残留

建立了表层取样/气相色谱-串联质谱(GC-MS/MS)测定竹木砧板中19种防腐防霉剂残留的方法。通过表层取样法制备样品后先进行酸化,然后利用乙酸乙酯-正己烷(2∶8,体积比)混合溶剂提取,经方法优化后无需进行衍生化反应及净化操作,采用多反应监测扫描(MRM)模式检测,基质匹配溶液外标法定量。结果表明,19种组分在0.005～200.0μg/mL范围呈良好的线性关系(r²> 0.990),检出限(LOD,S/N=3)为0.001～0.17 mg/kg,定量下限(LOQ,S/N=10)为0.003～0.55 mg/kg;在低、高2个不同加标水平下,19种目标物的回收率为65.8%～97.2%,相对标准偏差(RSD,n=6)为4.3%～13%。利用该方法对市售竹木砧板和一次性筷子样品进行检测,发现非定型包装竹木砧板中存在五氯酚残留量高的风险隐患,可为相关部门提供风险预警。     

一种制备单分散SiO2空心微球的新方法

在乙醇/氨水介质中, 分别以分散聚合和无皂乳液聚合方法制得的不同粒径聚苯乙烯(PS)微球为模板, 以正硅酸乙酯(TEOS)为前驱体, 通过控制介质中氨水的初始体积, 一步法制得了不同粒径的单分散SiO2空心微球. 整个过程无需添加其它溶剂溶解或高温煅烧的方法来除去模板微球. 对SiO2空心微球进行测试表征, 提出了SiO2空心微球的可能形成机制.     

无患子皂苷成分的串联质谱分析

我们采用电喷雾串联质谱直接对无患子总皂苷中各皂苷成分进行鉴定. 该方法方便快捷, 适合于无患子或其它皂苷混合物的快速分析.     

纳米尺寸聚苯乙烯-丙烯酸彩色高分子微球的合成与表征

以苯乙烯、丙烯酸、分散蓝染料为原料,采用分步聚合的方法合成了彩色具有核–壳结构的分散蓝/聚苯乙烯–丙烯酸高分子微球。通过TEM测得其颗粒尺寸约为200nm,分散均匀;通过FTIR对颗粒的组成结构进行表征,并对其合成过程进行探讨。