高稳定性CaO-ZrO2固体碱催化剂的表征和催化性能

用共沉淀法经高温焙烧制备了CaO摩尔分数从10%至50%的CaO-ZrO₂系列催化剂, 将其应用于碳酸丙烯酯和甲醇酯交换合成碳酸二甲酯过程, 并通过XRD, FT-IR, BET, ICP, CO₂-TPD, XPS等表征手段研究了催化剂的物性及其催化性能随组成变化的的规律. 结果表明, 当CaO摩尔分数高于30%时, 表面出现游离的CaO, 虽然具有强碱性和高活性, 但是稳定性差; 而当CaO摩尔分数低于30%时, Ca^2＋进入ZrO₂晶格, CaO与ZrO₂形成连续固溶体, 并且随着CaO含量的增加, 晶格氧的电荷密度增加, 催化剂的碱性增强, 使得CaO-ZrO₂催化剂在碳酸丙烯酯和甲醇酯交换合成碳酸二甲酯过程中获得了高活性和高稳定性.     

小分子配体诱导合成N,N-二苄基二硫代氨基甲酸镉(II)配合物及晶体结构

4,4'-联吡啶与二苄基二硫代氨基甲酸镉配合物[Cd(DBTC)₂]₂ (1)反应得到加合物[Cd(DBTC)₂(4,4'-bipy)] (2) (DBTC＝N,N-二苄基二硫代氨基甲酸), 通过晶体结构分析及红外光谱等研究其结构与性质. 结果表明: 引入小分子配体会破坏[Cd(DBTC)₂]₂ (1)的二聚结构, 加入吡啶则得到单核的吡啶加合物[Cd(DBTC)₂py] (3), 而引入4,4'-联吡啶后其结构变为新型的一维链状结构的配位聚合物2, 这种结构在二硫代氨基甲酸金属配合物中少见报道. 也比较了不同配体如吡啶及4,4'-联吡啶对Cd(II)及Zn(II)配合物结构的影响.     

Pr0.6-xNdxSr0.4FeO3-δ电极材料的光谱及性能研究

以柠檬酸-硝酸盐自蔓延燃烧法合成了ABO₃型钙钛矿结构的Pr_0.6-xNd_xSr_0.4FeO_3-δ(x=0.0～0.6)系列稀土复合氧化物粉体。利用傅立叶变换红外光谱(FTIR)和激光共焦拉曼光谱(LRS)对产物的晶体结构进行了表征。分别采用热膨胀仪测定烧结陶瓷体的热膨胀系数(TEC)；TG-DTA记录材料的热稳定性；XRD研究阴极材料与中温电解质Sm_0.2Ce_0.8O_1.9(SDC)及La_0.8Sr_0.2Ga_0.8Mg_0.2O_3-δ(LSGM)的化学相容性；SEM观察阴极/电解质复合材料的断口形貌。结果表明，该系列样品在高、低温热循环过程中化学稳定、晶型稳定；在室温至1 100 ℃范围内的平均热膨胀系数为1.16 × 10^-5 K^-1，与SDC及LSGM的热膨胀系数十分接近。阴极/电解质混合粉体1 200 ℃煅烧10 h，XRD未检测到新物质；SEM显示复合层断面界面清晰，没有相互扩散现象。该体系有望成为以SDC或LSGM为电解质的中温固体氧化物燃料电池合适的阴极材料。     

SYNTHESES OF STYRENE-METHYL METHACRYLATE BLOCK COPOLYMER BY POLYAZOAMIDE AS INITIATOR

Polyazoamide(PAA) was used as initiator to prepare block copolymer P(MMA-b-St) byfree radical polymerization. The fraction of block copolymer was about 50%. The structureof the block-copolymer was characterized by IR and the results of ~1H-NMR and GPCshowed that the content of the block and the molecular weight (M_w) of the prepolymerand block copolymer could be controlled by varying the mol ratio of styrene/PAA andMMA/prepolymer. DSC and TEM results revealed that the block copolymer has twoseparated glass transition temperatures and phase separation within the domain structure.     

利用DPN技术直接构建磁性纳米图形

在纳米尺度下构建有序的磁性模板和图形是当前的研究热点之一 [1,2 ] .这种模板在生物样品的分离[1] 、磁电子学研究和信息存储 [2 ] 等领域具有重要意义 .目前 ,光刻 [3] 、微触点印刷 [4 ] 和自组装 [5] 等多项技术已被用来构建各种纳米模板 .1 999年 ,美国西北大学 Mirkin小组 [6 ]发明的 Dip- pen纳米刻蚀技术 (简称 DPN技术 )更在可控组装方面显示出巨大优越性 .这项技术是在一定驱动力作用下 ,使吸附在原子力显微镜 ( AFM)针尖上的分子“墨水”逐渐转移到基底表面上 ,实现纳米模板的可控构建 .与传统技术相比 ,DPN技术可在纳米尺…     

NANOSECOND KINETIC ABSORPTION AND CALORIMETRIC STUDIES OF CYCLOPENTENONE: THE TRIPLET, SELF-QUENCHING, AND THE PREDIMERIZATION BIRADICALS

The photolysis of 2-cyclopentenone has been studied by a combination of kinetic absorption spectrophotometry and time-resolved photoacoustic calorimetry. The lifetime of the cyclopentenone triplet is strongly concentration dependent and corresponds to a value of 380 +/- 75 ns at infinite dilution in acetonitrile. The biradical intermediate (or pair of isomeric biradicals) immediately preceding formation of photodimer forms with very high efficiency upon quenching of triplet cyclopentenone by a second ground state cyclopentenone molecule and has an energy of 47 kcal/mol relative to two molecules of reactant. Quenching of the cyclopentenone triplet by conjugated dienes is much slower than expected, which is the reason that early estimates of the triplet lifetime were much too short.     

在线标准加入火焰原子吸收光谱法测定钮扣电池中铅和镉

应用火焰原子吸收光谱(FAAS)法测定了钮扣电池中铅和镉的含量,对测定条件作了较详细的研究。用在线双毛细管标准加入法消除了基体的干扰。按所述方法测定电池样品中铅和镉,测定结果的RSD依次为3.58%和5.87%,铅和镉的浓度水平分别为5.4×10-3%和2.3×10-4%(质量分数),回收率结果为93.0%~100.1%(铅)和95.0%~101.0%(镉)。     

金负载量对低温水煤气变换Au/α-Fe2O3催化剂结构和性能的影响

采用共沉淀法制备了低温水煤气变换Au/α-Fe2O3催化剂。通过正交实验优化催化剂的还原活化条件，考察了金负载量对催化剂性能的影响。采用BET、XRD、UV-VIS、XRF、H2-TPR和O2-TPO等表征手段对催化剂的结构进行分析，并与其催化性能进行关联。结果表明，（1）采用10%-H2/N2还原气将催化剂在150 ℃原位还原9 h，其催化活性最高；（2）金的最佳负载量为8.00%，此时在催化剂制备过程中金的流失量较少，金粒子较小，也有利于抑制催化剂在反应过程中烧结；（3）TPR-TPO结果表明，金的负载量为8.00%时，Au/α-Fe2O3催化剂具有较易被还原、不易被氧化的性质，从而显示出最高催化活性。（4）Au/α-Fe2O3催化剂中的金以单质金（Au0）形式存在；其高活性与Au0-Fe3O4间的协同作用有关。     

Synthesis and Crystal Structure of a Tetranuclear Silver Complex with Bis（diphenylphosphino） amine-dioxide as a Tridentate Ligand

1 INTRODUCTION The coordination chemistry of the nitrogen-contai- ning diphosphine ligand bis(diphenylphosphino)ami- ne (Ph2PNHPPh2) has recently received much atten- tion because the P atoms can bridge metal centers in μ-bonding mode to form bi- or polynuclear complex- es[1~10]. It has been shown that the acidity of N–H proton would promote functionalization on the ligand backbone[4, 5, 11]. Although a few complexes contain- ing deprotonated tridentate Ph2PNPPh2 have been synthesi…     

REE AND Sr, Nd, Pb ISOTOPIC GEOCHEMISTRY OF HUANGYISHAN BASALT, KUANDIAN, LIAONING, NORTHEAST CHINA

In the light of major element geochemistry, mineral chemistry and REE and isotopic data, the small but apparent isotopic differences between the Cenozoic volcanic rocks east and west of the Tancheng-Lujiang fault are believed to be caused by the mixing and metasomatism of crustal and mantle material in tho mantle source region in response to Pacific plate subduction. The presence of phlogopite and pargasite in mantle xenoliths lends strong support to mantle metasomatism.