Measurement Accuracy in Phase-Shifting Point Diffraction Interferometer with Two Optical Fibers

A phase-shifting point diffraction interferometer (PS/PDI) with point sources of two single mode optical fibers has been developed, which will be appropriate for the surface figure measurement of large aperture optics on a sub-nanometer scale. To reduce the measurement error factors, a fiber optic plate (FOP) is used as a projection plane for interference pattern. Errors caused by imperfection of optical alignment, such as position of point sources and tilt of FOP, are minimized by analyzing the measured phase data with an original method. Measurement accuracy in the PS/ PDI is estimated with the interference pattern produced by the two optical fiber sources. If inhomogeneity of the FOP and a systematic error of the PS/PDI are eliminated, the measurement accuracy of the present system is estimated to be less than 4nm P-V and 0.7nm rms, respectively, at a measurement wavelength of 632.8 nm.     

Qβ measurements of 158, 159Pm , 159, 161Sm , 160-165Eu , 163Gd and 166Tb using a total absorption BGO detector

Q _β values of the neutron-rich isotopes of ^160-165Eu and ¹⁶³Gd were measured for the first time using a total absorption bismuth germanate (BGO) detector, and previously obtained data on ^{158, 159}Pm , ^{159, 161}Sm and ¹⁶⁶Tb were re-analyzed. These radioactive sources were prepared by an on-line mass separator (Tokai-ISOL) following the ²³⁸U (p,f reaction. The deduced Q _β values are the following: 6085(80)keV for ¹⁵⁸Pm , 3805(65)keV for ¹⁵⁹Sm , 5460(140)keV for ¹⁵⁹Pm , 4705(60)keV for ¹⁶⁰Eu , 5065(130)keV for ¹⁶¹Sm , 3705(60)keV for ¹⁶¹Eu , 5575(60)keV for ¹⁶²Eu , 4690(70)keV for ¹⁶³Eu , 3170(70)keV for ¹⁶³Gd , 6430(70)keV for ¹⁶⁴Eu , 5800(120)keV for ¹⁶⁵Eu , and 4695(70)keV for ¹⁶⁶Tb . Moreover, the deduced mass excesses and two-neutron separation energies ( S _2n values) were compared with those of the atomic mass evaluations and theoretical predictions.     

Pressure-Sensitive Paint measurement of the flow around a simplified car model

In applying Pressure-Sensitive Paint (PSP) to low-speed flow wind tunnel testing, it is important to minimize any measurement uncertainties. There are various error sources such as camera noise, misalignment of images due to model displacement and temperature distribution over the model. Among these factors, the effects of temperature distribution change during tests on pressure measurement accuracies were studied in the present paper. Pressure and temperature distributions over a simplified car model (1/10 scale Ahmed model) were measured using PSP and Temperature-Sensitive Paint (TSP). Sequential images were acquired at the same intervals over the entire test period, including for the conditions before and after the tunnel run. As a result, it was found that the measurement error caused by temperature distribution over the model could be reduced using a single-point temperature measurement. In addition, by measuring surface temperature distributions on the model using TSP, it was proved that the most accurate pressure measurement could be made by rationing the wind-off image acquired immediately after shutting down the tunnel to the wind-on image acquired immediately before shutting down the tunnel. Using the present measurement technique, complicated pressure fields over the Ahmed model were successfully visualized.     

Improvement of pharmaceutical potential of all-trans retinoic acid with hydroxypropyl-��-cyclodextrin

2-Hydroxypropyl-??-cyclodextrin (HP-??-CyD) includes all-trans retinoic acid (RA), covering the double-bond area of RA with substituted hydroxypropyl groups on CyD ring, as proved by the nuclear Overhauser effect (NOE) between methylene protons on the hydroxypropyl groups and the proton on RA. The formation of an inclusion complex results in hydrophilicity and stability. The effect of RA/HP-??-CyD and that of RA without HP-??-CyD on wrinkle scores and skin elasticity during skin treatment were identical, and the cutaneous stimulus was reduced comparing with RA. The results indicated that the RA/HP-??-CyD complex should help to realize new approaches in skin rejuvenation therapy.     

Azo benzene derivatives

Pressure-volume isotherms for 4-(trans-4-butylcylohexyl)benzonitrile were measured by means of piston-cylinder method. This substance has a monotropic nematic phase at atmospheric pressure. But over a pressure, the nature of isotropic to nematic phase transition changed from monotropic to enantiotropic phase transition. It is the first observation in P-V-T experiments that the monotropic isotropic-nematic transition changes enantiotropic under pressure.     

Asymptotic profiles of steady Stokes and Navier–Stokes flows around a rotating obstacle

We analyze the spatial anisotropic profiles at infinity of steady Stokes and Navier–Stokes flows around a rotating obstacle. It is shown that the Stokes flow is largely concentrated along the axis of rotation in the leading term and that a rotating profile can be found in the second term. The leading term for Navier–Stokes flow will be an adequate Landau solution. The proofs rely upon a detailed analysis of the associated fundamental solution tensor.     

A characterization of isotropic immersions by extrinsic shapes of smooth curves

In this paper we show that an isometric immersion is isotropic in the sense of O'Neill if and only if it preserves logarithmic derivatives of first geodesic curvatures of some curves.