Alloying by high dose ion implantation of iron into magnesium and aluminium

Alloys of the systems Fe–Al (mixable over the whole concentration range) and Fe–Mg (insoluble with each other) were produced by implantation of Fe ions into Al and Mg, respectively. The implantation energy was 200 keV and the ion doses ranged from 1 × 10₁₄ to 9 × 10₁₇cm^-2The obtained implantation profiles were determined by Auger electron spectroscopy depth profiling. Maximum iron concentrations reached were up to 60 at.% for implantation into Al and 94 at.% for implantation into Mg. Phase analysis of the implanted layers was performed by conversion electron Mössbauer spectroscopy and X‐ray diffraction. For implantation into Mg, two different kinds of Mössbauer spectra were obtained: at low doses paramagnetic doublets indicating at least two different iron sites and at high doses a dominant ferromagnetic six‐line‐pattern with a small paramagnetic fraction. The X‐ray diffraction pattern concluded that in the latter case a dilated αiron lattice is formed. For implantation into Al, the Mössbauer spectra were doublet structures very similar to those obtained at amorphous Fe–Al alloys produced by rapid quenching methods. They also indicated at least two different main iron environments. For the highest implanted sample a ferromagnetic six‐line‐pattern with magnetic field values close to those of Fe₃Al appeared.     

Synthesis, structure, and antimetastatic activity of thetrans-[Pt(NC5H4C(O)NHC2H4ONO2)2Cl2] complex

Thetrans-[Pt(NC₅H₄C(O)NHC₂H₄ONO₂)₂Cl₂] complex (2) was prepared by the reaction of nicorandyl (N-nitroethoxynicotinamide), which is widely used in cardiology, with K₂PtCl₄ in water. The structure of2 was established by X-ray structural analysis. It was found that complex2 exhibits high antitumor activity, in particular, antimetastatic activity, unlike the analogous Cu^II complex with bromine atoms. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1672–1675, September, 1997.     

Investigation of the chemical state of copper in Cu/SiO2 composite films by x-ray photoelectron spectroscopy

The concentration and chemical state of copper in the subsurface region of Cu/SiO₂ composite films obtained by simultaneous magnetron sputtering from two sources (Cu and SiO₂) are determined by x-ray photoelectron spectroscopy (XPS). It is established that copper in the as-grown film is primarily in the form of unoxidized atoms dispersed in a SiO₂ matrix. Annealing of the film results in practically no oxidation, but about 70% of the copper atoms condense into metallic clusters with sizes below 10 Å in the subsurface region and about 50 Å in the bulk of the film. The changes in the binding energy of core electrons, and especially in the energies of Auger electrons, are so large in this situation that photoelectron and Auger spectroscopy are efficient methods for monitoring the chemical state of this composite material.     

Formation of a two-dimensional periodic structure of local melting regions on a silicon surface upon pulsed light irradiation

The first results regarding the formation of a two-dimensional periodic structure of local melting regions on a silicon surface upon pulsed light irradiation are presented. The conditions are established, and the mechanism of the formation of such structures is discussed. Zh. Tekh. Fiz. 67, 97–99 (December 1997)     

State of and prospects for XeF(C−A) optically pumped lasers

Experimental and theoretical results are presented on an XeF(C?A) blue-green laser driven by 5-kJ energy. The laser was pumped by a ferrite-induced discharge of 90 cm in length. The output energy of 0.22 J was obtained with a plane-parallel resonator. A program to simulate laser operation has been developed. Numerical results for a wide range of conditions are compared with experiments performed by us and by other authors. It is found that intracavity refractive losses limit laser operation for XeF pressures above 3 torr. The laser efficiency strongly depends on the discharge-to-cavity length ratio. Possible ways to increase the laser power and efficiency are discussed.     

Experimental studies of microwave amplification in the ion-focusedregime

Studies of microwave amplification with an in-focused electron beam drawn from an induction injector are reported. A free-electron laser (FEL) operating at 9.4 GHz and employing ion-focusing within the interaction region has achieved power in excess of 30 MW at 9.4 GHz, with a beam energy of 0.8 MeV and current of 0.7 kA. Peak gain is 20 dB/m, with no saturation after 15 wiggler periods. Also reported are the first evolution and detuning data for an ion-channel laser/maser (ICL). Two shortcomings of the prematurely halted ICL studies are poor frequency discrimination and a large axial plasma gradient. Prospects for operation with an upgraded 1.6 MeV accelerator are discussed     

5-[5-R-furfurylidene]-2,2-dimethyl-1,3-dioxane-4,6-diones 5. Nucleophilic replacement of halogen in the furan ring

Halogen in positions 3 and 5 of the furan ring in ftirfurylidenedioxanediones is readily replaced by dithiocarbonate, dithiocarbatnate, dithiophosphate, thiocyanate, and azide anions, and by thiourea, and secondary and tertiary amines. The conformation of the initial halogen derivative is retained in the substitution products.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 3, pp. 327–334, March, 1994.