催化剂组成和反应条件对W-Fe-MgO催化分解甲烷制备单壁碳纳米管的影响

 采用“柠檬酸法”制备的W-Fe-MgO催化剂,在小型流化床反应器中分别以Ar和H2为载气在1073～1373 K下催化甲烷分解制单壁碳纳米管(SWCNTs). 实验结果表明,用H2作载气制备SWCNTs的最佳温度为1373 K,在Fe∶Mg摩尔比≤10∶100时,催化剂上的碳产率随其W载量的增加而显著增大,产物中的SWCNTs含量也保持在较高水平,最高碳产率可达55%(相对于催化剂的质量分数). 而使用Ar载气时最佳反应温度为1073 K, 用W∶Mg摩尔比为1∶100的催化剂可制得SWCNTs含量较高的产物,而W∶Mg摩尔比超过1∶100的催化剂上产物中的SWCNTs含量显著下降. 根据XRD和XPS实验结果推测了W-Fe-MgO催化剂上生长SWCNTs的活性相.     

正庚烷在超稳Y沸石(USY)负载超强酸催化剂上加氢异构化

The Pt-bearing SO₄^2-/ZrO₂ superacid catalysts supported on ultra stable Y (USY) zeolite were prepared by impregnation and characterized by X-ray diffraction, nitrogen adsorption and Hammett indicators. Their catalytic activities were evaluated in the hydroisomerization of n-heptane with an atmospheric fixed-bed reactor. The catalysts possessed a high surface area, superacidity and well maintained pore structure of USY support. The supported catalysts with a suitable SO₄^2-/ZrO₂ loading exhibited a higher catalytic activity and selectivity than the unsupported SO₄^2-/ZrO₂ catalyst or the Pt supported on USY catalyst without superacid. At the reaction temperature of 220 ℃, over the catalyst with a Pt loading of 0.8wt% and ZrO₂ loading of 10wt%, the conversion of n-heptane could be as high as 35.2% with a selectivity of 87.9% for isomerization products.     

反相高效液相色谱法测定血浆中氢溴酸右美沙芬浓度

报道了反相高效液相色谱法测定血浆中氢溴酸右美沙芬 ( DM)方法。采用Novapak C84μm,1 5 0 mm× 3.9mm i.d.分析柱 ,以乙腈∶水 =5 0∶ 5 0 ( V/V ,加0 .5 % HAc,三乙胺调节 p H至 4.3)为流动相 ,荧光检测器检测 ,DM的最小检出浓度为 0 .2 ng/m L。方法回收率为 93.71 % ,变异系数 3.5 3% ,操作简便 ,灵敏度高 ,适于血浆中 DM测定及药代动力学研究     

利用光学显微镜研究溶剂诱导的梯形苯基聚倍半硅氧烷结晶

通过溶剂诱导结晶的方法研究了梯形苯基聚倍半硅氧烷(PPSQ)的球晶结构. 采用光学显微镜研究了溶液的浓度、溶剂的挥发时间以及温度等影响因素对梯形苯基聚倍半硅氧烷的球晶结构形貌的影响. 实验结果表明:稀释溶液浓度与提高结晶温度在改变球晶的形态方面具有相同的效果. 球晶的尺寸会随着溶液浓度的降低或者结晶温度的升高而增加. 这都归因于梯形苯基聚倍半硅氧烷在二甲苯中的溶解度的增加. 在不改变其它结晶条件的情况下,延长溶剂的挥发时间也会形成更大的球晶. 当在光学显微镜下旋转样品时球晶的结构不会发生改变,这表明球晶具有均一的晶体学取向结构. 负性球晶的特征也表明梯形苯基聚倍半硅氧烷的分子链是沿着球晶的切线方向排列. 考虑到梯形苯基聚倍半硅氧烷具有刚性的分子链,还提出了梯形苯基聚倍半硅氧烷可能的球晶结构模型.     

锂离子电池负极材料Li4Ti5O12的半固相法制备及碳包覆改性

由半固相法制得锂离子电池负极材料Li4Ti5O12,并研究了Li4Ti5O12的碳包覆改性.采用XRD、SEM、TEM以及HRTEM观察和分析产物的相结构与形貌.采用恒流充放电、循环伏安法和交流阻抗技术测试了材料的电化学性质.结果表明,Li4Ti5O12因颗粒团聚电化学性能严重下降,该电极在0.1C和0.5C首周期放电容量分别为121.7和87.6 mAh·g-1;碳包覆Li4Ti5O12/C材料呈球形分布,能抑制颗粒团聚,该电极倍率<0.5C时的放电比容量大于180 mAh·g-1,超过Li4Ti5O12的理论放电比容量(175 mAh·g-1);在1C、5C和10C倍率下,其容量仍保持在136、79.9和58.3 mAh·g-1,碳包覆改性材料具有优异的循环寿命和高倍率性能.     

负载型钙钛矿La0.8Sr0.2MnO3/SBA-15催化燃烧甲苯的研究

采用逐层负载-孔道内氨/水蒸气原位羟化法制备了一系列负载型钙钛矿La_0.8Sr_0.2MnO₃/SBA-15催化剂,用XRD、BET、TG-DTG、XPS、H₂-TPR等手段对催化剂的物性结构等进行了表征,并在常压连续流动固定床反应器上评价了该催化剂对甲苯催化燃烧的催化性能。结果表明,逐层负载-孔道内氨/水蒸气原位羟化法的使用有助于活性组分La_0.8Sr_0.2MnO₃进入SBA-15的孔道,并在SBA-15上形成钙钛矿结构。La_0.8Sr_0.2MnO₃/SBA-15上钙钛矿结构的形成和晶格氧的出现,可为催化剂提供较多的活性中心,有利于其催化燃烧甲苯的活性。     

测定盐酸西布曲明的电位传感器的研制与应用

以四苯硼酸钠与盐酸西布曲明生成的离子缔合物为电活性物质,研制了盐酸西布曲明传感器。试验表明:盐酸西布曲明聚氯乙烯(PVC)膜传感器对盐酸西布曲明具有良好的选择性和电位响应特性。在pH 5的溶液中,电极电位呈现近能斯特响应,线性范围为1.0×10-6～1.0×10-1mol.L-1,斜率为50 mV.pc-1(26℃),检出限(3S/N)为5.62×10-7mol.L-1。将电极用于药物中盐酸西布曲明含量的测定,测得回收率为97.3%～100.2%,测定值的相对标准偏差(n=5)均小于2%。     

Growth and Spectral Properties of Yb^3＋-doped Ba3Gd（BO3）3 Crystal

Crystal of Yb3+-doped Ba3Gd(BO3)3 has been grown by the Czochralski method. The spectroscopic characterizations have been investigated at room temperature. The Yb3+:Ba3Gd(BO3)3 crystal exhibits broad absorption at 976nm with FWHM of 7nm and large overall spitting of 2F7/2 manifold (823cm-1). The absorption and emission cross sections are 5.09×10-21cm2 at 976nm and 0.97×10-21cm2 at 1040nm,respectively. The fluorescence lifetime is 2.84 ms.     

Thermochemical Study of Coordination of Holmium Chloride Hydrate with Diethylammonium Diethyldithiocarbamate

The complex of holmium chloride hydrate with diethylammonium diethyldithiocarbamate (D-DDC) was synthesized via mixing their solutions in absolute alcohol under a dry N2 atmosphere. The elemental and chemical analyses show that the complex has the general formula Et2NH2[Ho(S2CNEt2)4]. It was also characterized by IR spectroscopy. The enthalpies of the dissolution of holmium chloride hydrate and D-DDC in absolute alcohol at 298.15 K o and the enthalpy changes of liquid-phase reactions of the formation of Et2NH2[Ho(S2CNEt2)4] at different temperatures were determined by microcalorimetry. On the basis of experimental and calculated results, three thermodynamic parameters (the activation enthalpy, the activation entropy and the activation free energy), the rate constant and three kinetic parameters (the apparent activation energy, the pre-exponential constant and the reaction order) of the liquid-phase reaction of the complex formation were obtained, The enthalpy change of the solid-phase complex formation reaction at 298.15 K was calculated by means of a thermochemical cycle.     

激光诱导击穿光谱在核分析实验教学中的应用

为了适应核物理与核分析实验教学的需要,本文将激光诱导激光光谱测量以创新实验的形式引入到核工程类专业实验中.通过将纳秒激光脉冲与不同靶材作用,测量样品中各类元素的LIBS谱线,结合理论分析提取激光等离子体的电子温度和等离子体密度.假设单一元素谱线获得的等离子体密度为混合样品等离子体密度,计算得到未知重元素Fe的原子谱线展宽参数.