Elektrische Charakterisierung von Hochfrequenz-Niederdruck-Gasentladungen

In recent years there has emerged significant interest in low pressure radio frequency (rf) glow discharges which are used widely particulary in IC fabrication. Various parameters of the rf glow discharge have been found to be useful for its electrical characterization; however, there is no uniformity and agreement. Extensive experimental investigations on various discharge systems have shown, that the self-bias on the rf driven electrode, the complex conductivity and the breakdown characteristic are preferable parameters of rf discharges. Advantageously the self-bias and the complex conductivity should be presented in dependence on the pressure and the applied rf voltage. The discharge current cannot be measured quite accurately due to currents via leaky capacitors and the deviations from a sinusoidal form of the current due to nonlinearities.     

Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China     

Electro-optic pulse response of ferroelectric liquid crystals

The electro-optic response of ferroelectric smectic C* liquid crystals has been studied. Anomalous switching behaviour of such materials which possess a negative dielectric anisotropy has been reported. These materials show a minimum in response time at a sufficiently high field. We present results showing the dependency of this minimum upon spontaneous polarisation and the effect of AC bias. Calculations based upon the equation of motion of the director around the cone are presented which describe this effect and its dependence on the relative magnitudes of the spontaneous polarization and dielectric anisotropy of the material. Good agreement with the experimental results is found.     

Chaos-controlling technique for suppressing self-modulation in backward-wave tubes

A method for suppressing self-modulation in backward-wave tubes is proposed. Additional delay is introduced into the feedback circuit, owing to which the output signal amplitude affects the electron beam current that enters into the interaction space. Numerical simulations demonstrate that the operating current in the single-frequency oscillation mode may be increased roughly twofold.     

1,1,3-Trimethyl-3-phenylindan as a Luminescent Additive to a Plastic Scintillator Based on Poly(methyl Methacrylate)

The luminescence and scintillation properties of poly(methyl methacrylate) containing 1,1,3-trimethyl-3-phenylindan were studied.     

Effects of tributyltin(IV) chloride on the gametes and fertilization of Ascidia malaca (Ascidiacea: Tunicata)

Ascidia malaca gametes before fertilization incubated in 10^?5 or 10^?7 M solutions of tributyltin(IV) chloride, TBTCl, for 3 h appear highly damaged under transmission electron microscopy observation. Also, the fertilization process is affected by the compound: the damaged spermatozoa are present in the vitelline coat and the egg does not cleave. An increase of microbodies, structurally similar to peroxisomes, have been detected in the egg peripheral cytoplasm, probably in relation to their role in alleviating damage to some cellular components. The results have shown that the reproduction of ascidians under unfavourable environmental conditions is prevented. Copyright © 2003 John Wiley & Sons, Ltd.     

Dynamic mechanical thermal analysis transitions of partially and fully substituted cellulose fatty esters

The main transitions of cellulose fatty esters with different degrees of substitution (DSs) were investigated with dynamic mechanical thermal analysis. Two distinct main relaxations were observed in partially substituted cellulose esters (PSCEs). They were attributed to the glass‐transition temperature and to the chain local motion of the aliphatic substituents. The temperatures of both transitions decreased when DS or the number of carbon atoms (n) of the acyl substituent increased. Conversely, all the transitions of fully substituted cellulose esters occurred within a narrow temperature range, and they did not vary significantly with n. This phenomenon was explained by the formation of a crystalline phase of the fatty substituents. The presence of few residual OH groups in PSCEs was responsible for a large increase in the storage bending modulus, and it eliminated the effect of n on damping. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 281–288, 2003