中国邮路问题的一个解法

本给出中国邮路问题的一个解法。虽然它仍只是初始方案，但因考虑了问题的足够信息，因而这种方案至少拉近了与最优解的距离。     

MC模式下顾客需求与厂商供应的纳什均衡

在大规模定制(MC，Mass Customization)模式下，基于市场需求的复杂化，厂商对个性化的顾客需求很难做出及时准确的反应，而且由于其自身生产能力的限制，不可能对所有的个性化用户进行一一地满足，只可能对已经存在的个性化需求，根据自身的生产能力和规模，以利润最大化及顾客对产品的满意度为目标，对个性化需求进行较准确地预测，从而正确指导生产。本通过博弈论的方法，提出了一个基于顾客对产品的满意度及企业的利润的一个非合作博弈模型，并给出求解纳什均衡的方法。     

合作联盟资源集成计划一种新方法

合作联盟里，资源集成计划往往是联盟成员群体谈判博弈的结果。本以两人博弈为例，对联盟的资源集成计划给出一个谈判博弈模型，能够较好地模仿和反映合作联盟资源整合计划的制订过程。     

Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

利用场发射显微镜研究O2对单壁碳纳米管场发射的影响

利用场发射显微镜和四极质谱计研究了充入高纯O2的四极质谱和O2对单壁碳纳米管场发射的影响.单壁碳纳米管经过约1000℃的热处理得到清洁态场发射像后，充入O2，分别测量了O2吸附和脱附后场发射的I V特性.实验观测到在单壁碳纳米管上O2的吸附使场发射电流减小，说明逸出功增加.在10-4Pa的O2压强下对单壁碳纳米管进行约1000℃的热处理，可以产生氧化刻蚀作用，观测到场发射像的变化，并测量了氧化刻蚀产生的I V特性变化. 关键词： 单壁碳纳米管 场发射显微镜 场发射 四极质谱     

In-Situ Intrinsic Interface Strength Measurement at Elevated Temperatures and its Relationship to Interfacial Structure

A previously developed laser spallation technique has been modified to measure the tensile strength of thin film interfaces in-situ at temperatures up to 1100°C. Tensile strengths of Nb/A-plane sapphire, FeCrAl/A-plane sapphire and FeCrAlY/A-plane sapphire were measured up to 950°C. The measured strengths at high temperatures were substantially lower compared with their corresponding strengths at ambient temperature. For example, at 850°C, the interface tensile strength for the Nb/sapphire (151 ± 17 MPa), FeCrAl/sapphire (62 ± 8 MPa) and FeCrAlY/sapphire (82 ± 11 MPa) interface systems were lower by factors of approximately, 3, 5, and 8, respectively, over their corresponding ambient values. These results underscore the importance of using such in-situ measured values under operating conditions as the failure criterion in any life prediction or reliability models of such coated systems where local interface temperature excursions are expected. The results on alloy film interfaces also demonstrate that the presence of Y increases the strength of FeCrAl/Al₂O₃ interfaces.     

70K温区混合工质分凝分离循环节流制冷机实验研究

混合工质节流制冷机正在许多方面获得越来越广泛的应用。文中设计了一种新型的混合工质分凝分离循环 ,建立了实验系统 ,并在 70 K温区进行了实验。实验结果表明 ,节流制冷机可以达到 6 5 .3K的低温 ,并在 72 K温度提供 1W的制冷量 ,输入功率为 5 0 0 W。     

社会经济管理系统和谐性模型的构建与分析

本文从非线性自然观的视野。引用与分析了社会经济系统功能模型与效应模型。构建了系统和谐状态模型与和谐状态可信度模型，形象地说明了企业系统的和谐既是一个随机不确定状态。又是企业和谐力量与不和谐力量相互抗争干涉的过程。依据协同学原理提出了企业系统和谐演进的机制，表明企业系统的和谐发展是子系统和谐协同的过程。即子系统竞争合作的过程。文中所构建的模型，从理论上清晰地说明了企业系统和谐有序运行的机理，为如何构建和谐企业。提供了建设性的思考。     

Giant Magneto-Impedance of Co50Ni22Ga28 Alloy with High Chemical Ordering

The microstructure of CosoNi22Ga28 ribbon with the L10 structure is examined. The band-like morphology is observed. These bands with the width in a range of 40-200 nm appear along the transverse direction of the ribbon. The giant magnetoimpedance （GMI） effect in this alloy is measured. The results show that Co5oNi22Ga28 exhibits a sharp peak of the GAI effect. The maximum GAH ratio up to 360% is detected. The GMI effect measured versus temperature shows large jumps of the magnetoimpedance amplitude at the reversal martensitic transformation temperature 240℃ and Curie temperature 375℃C respectively. The jump ratios of the magnetoimpedance amplitude examined at these temperatures are about 5 and 10, respectively.     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.