分数维方法研究GaAs薄膜中的极化子

本文采用分数维方法, 在讨论Al_0.3Ga_0.7As衬底上GaAs薄膜的分数维基础上, 计算了GaAs薄膜中的极化子结合能和有效质量. 随着薄膜厚度的增加, 极化子结合能和质量变化单调地减小. 当薄膜厚度L_w<70 Å并且衬底厚度L_b<200 Å时, 衬底厚度的变化对薄膜中极化子的结合能和质量变化的影响比较显著, 随着衬底厚度的增加, 薄膜中极化子的结合能和质量变化逐渐变大; 当薄膜厚度L_w>70 Å或者衬底厚度L_b>200 Å时, 衬底厚度的变化对薄膜中极化子的结合能和质量变化的影响不显著. 研究结果为GaAs薄膜电子和光电子器件的研究和应用提供参考. 关键词： 分数维方法 GaAs薄膜 极化子 低维异质结构     

MP-C60(M=Cu,Co)化合物的合成、表征及光电性能研究

卟啉和金属卟啉不仅是良好的电子给予体,而且在紫外可见光区有着非常广泛的吸收,这有利于太阳能的利用.富勒烯(C60)由于自身独特的结构而成为较好的电子受体.近年来,大量共价键连卟啉-富勒烯D-A化合物被合成与研究[1-4].通过柔性连接体形成的卟啉-富勒烯化合物有利于增加给-受体间电子的流动性,使化合物具有优良的光电转换性能[2].中间体和产物的合成见图1.1和2的合成、纯化参照文献[2].3的合成:在N2下把37.2mg对羟基苯甲醛、75.2mg2、过量灼烧的无水碳酸钾加入30mL DMF中,80°C反应8h后,甲苯和蒸馏水分液,粗产品用硅胶柱层析,甲苯淋洗,…     

GaAs薄膜的有效量子限制长度及其极化子特性

本文用分数维方法研究Al_xGa_1-xAs衬底上GaAs薄膜中的极化子特性, 提出了确定GaAs薄膜的有效量子限制长度的一个新方法, 解决了原来方法中在衬底势垒处有效量子限制长度发散的困难, 得到了Al_xGa_1-xAs衬底上GaAs薄膜中的极化子的维数和结合能. 关键词： 分数维方法 极化子 GaAs薄膜     

An analog of double electromagnetically induced transparency with extremely high group indexes

An asymmetric metamaterial exhibiting an analog of double electromagnetically induced transparency(EIT) in the middle-infrared region is reported.The metamaterial consists of two-layered arrays of Ushaped rings embedded in a medium,with the lower layer rotated by 90°.Our simulations demonstrate that both maximum group indexes are extremely high at the two EIT-like positions.The group index reaches about thrice the currently reported maximum value at the high-frequency EIT-like position.The transmittance at the two transparency positions also possesses extremely high Q factors,which is conducive to controlling the propagation of electromagnetic waves.     

Fabrication of rhenium Josephson junctions

Rhenium is a superconductor with a relatively weak tendency to oxidize, which is advantageous in superconducting quantum circuit and qubit applications. In this work, Re/A1-A1Ox/Re Josephson tunnel junctions were fabricated using a selective film-etching process similar to that developed in Nb trilayer technology. The Re films had a superconducting transition temperature of 4.8 K and a transition width of 0.2 K. The junctions were found to be highly reproducible using the fabrication process and their characteristics had good quality with a low leakage current and showed a superconducting gap of 0.55 meV.     

Mode locked Er-doped fiber laser with single-wall carbon nanotube saturable absorber

A mode locked Er-doped fiber laser based on a single-wall carbon nanotube saturable absorber is demonstrated. A high quality single-wall carbon nanotubes （SWCNTs） absorber film is fabricated by a polymer composite. The pulse duration is 488 fs with 9.6-nm spectral width at the center of 1564 nm. The repetition rate is 30.4 MHz. The maximum output power is 3 mW. And the single pulse energy is 0.1 nJ.     

互感系数M12=M21的证明

从定义、磁能、磁矢势、磁偶极子、自由能5个方面出发分别证明了互感系数M12=M21,并对几种证明方法进行了分析对比,提出了自己的看法.     

The research on temperature measurement based on polarization dependent loss

This paper analyzes the properties of reflected polarization dependent loss of apodized fiber Bragg gratings with temperature effective. We simulates reflected spectrum and polarization dependent loss of the apodized fiber Bragg gratings. The reflected spectrum and polarization dependent loss are measured under different temperatures. The analysis results show that reflected polarization dependent loss presents two peaks which shift an equal proportion to long wavelength with temperature increasing and have very good stability so we propose an idea that use polarization dependent loss as temperature sensor measurement parameters. The results show that the accuracy of measurement can be increased almost by one order of magnitude.     

Optical transmission through an interface between subwavelength slits

This paper studies optical transmission through an interface between two slits with different widths in a sheet composed of an ideal conductor. Such a structure is of potential use in fabricating optical diode and may be the simplest one compared to other designs. Our calculations show that there is a critical wavelength. When the light wavelength is below the critical wavelength, the transmissivity is unidirectional. The expression of the stable transmissivity as a function of the ratio of the widths of the two slits was obtained analytically. Particularly, at the critical wavelength, the transmissivities are zero. This phenomenon has great potential for application in the manufacture of wavelength blockers.     

Laser output of radial-slab solid-state laser

In this letter, numerical simulation and experimental study of a radial-slab solid-state laser are presented. The laser includes four crossing-slabs pumped by four Xe flashlamps. The numerical simulation of coherent intensity in the near field and the far field indicates that the laser with the structure can improve the quality of output beam compared with incoherent beam combination. The radial-slab solid-state laser is fabricated, and initial experiments are carried out at a pulse repetition of 1 Hz. Nine beams in the near field and one combined beam in the far field are obtained in our initial experiment. The experimental results are consistent with the numerical analysis in the coherent condition. The results show that coherent beam combination is obtained by this laser.