A reliable ab initio potential energy surface and vibrational states for the ground electronic state of HgH2(X1Sigma+g)

A three-dimensional global potential energy surface for the ground (X (1)Sigma(+)(g))electronic state of HgH(2) is constructed from more than 13,00 ab initio points. These points are generated using an internally contracted multireference configuration interaction method with the Davidson correction and a large basis set. Low-lying vibrational energy levels of HgH(2), HHgD, and HgD(2) calculated using the Lanczos algorithm are found to be in good agreement with the available experimental band origins. The majority of the vibrational energy levels up to 9000 cm(-1) are assigned with normal mode quantum numbers. Our results indicate a gradual transition for the stretching vibrations from the normal mode regime at low energies to the local mode regime near 9000 and 8000 cm(-1) for HgH(2) and HgD(2), respectively, as evidenced by a decreasing energy gap between the (0,0,n(3)) and (1,0,n(3)-1) vibrational states and bifurcation of the corresponding wave functions.     

Degradation of ferric EDTA by Burkhol cepacia

EDTA, the target compound of this study from the effluent of secondary biotreatment units, can be biodegraded by special microorganisms. So far, there are three species of microorganisms—Agrobacterium, Gram-negative BNCI, and DSM9103—that can degrade EDTA and are published in the literature. We have successfully isolated a bacterial strain that can degrade EDTA. It was identified as Burkhol cepacia, an aerobic species, elliptically shaped with a length of 5–15 μm. The growth medium contains 1000 mg/L of ferric-EDTA as carbon source, 750 mg/L of (NH₄)₂SO₄+(NH₂)₂CO as nitrogen source, and 1000 mg/L of KH₂PO₄ as phosphorus source, and mineral factors such as Fe and Mg. Incubated at pH, 7.0, 30°C, and 150 rpm on a shaker for 15 d, the average specific growth rate of this microbe is 0.135 d⁻¹, which shows that the respective degradation efficiency of Fe-EDTA and Cu-EDTA is 90 and 75% individually.     

Infrared and electronic spectra of copper (II) complex of maleonitriledithiolate and 4,4'-dimethyl-2, 2'-bipyridine and their theoretical studies

The molecular structure and binding, as well as infrared and electronic spectroscopic properties for the title complex Cu(mnt)(dmbpy)(mnt(2-)=maleonitriledithiolate, dmbpy=4,4'-dimethyl-2,2'-bipyridine) were studied in this paper. With semi-empirical PM3 and non-empirical DFT (B3LYP/6-311G*) methods, the molecular geometry of the complex was optimized and corresponding vibrational spectra in the gaseous state were obtained. The calculated results derived from DFT were more reasonable than those from PM3. The point group of Cu(mnt)(dmbpy) in isolated gaseous state was C(2), in which Cu(II) adopted a distorted tetrahedral geometry and the dihedral angle between the N(2)Cu and S(2)Cu planes was about 29.814 degrees. And a complete assignment to the IR spectra of such a complicated molecule was exhibited. With ZINDO/S method an electronic spectrum was calculated. The results showed that the calculated values generally agreed with the observed ones. And a detailed explain was made on its electronic spectra.     

Novel synthesis of 2-oxo-3-butynoates by copper-catalyzed cross-coupling reaction of terminal alkynes and monooxalyl chloride

A general and efficient Cu(I)-catalyzed cross-coupling reaction of terminal alkynes and monooxalyl chloride for the synthesis of 2-oxo-3-butynoates and 2-oxo-3-butynoamides was developed. Readily available starting materials, the mild reaction conditions, wide functional group tolerance, and the obviation of stoichiometric organolithium or magnesium reagents combine to highlight this reaction.     

Carbon anode materials from polysiloxanes for lithium ion batteries

Three kinds of silicon-containing disordered carbons have been prepared by pyrolysis of polysiloxanes with different amounts of phenyl side groups. X-ray powder diffraction, X-ray photoelectron spectroscopy and electrochemical capacity measurements were performed to study their behaviors. Graphite crystallites, micropores, and silicon species affect their electrochemical performances. All of them present high reversible capacities, >372 mAh/g. Since the graphite crystallites are very small, they contribute very little to reversible capacity. The number of micropores produced by gas emission during the heat-treatment process decides whether they exhibit reversible capacity. Si mainly exists in the form C–Si–O and influences the irreversible capacity. There is no evident capacity fading in the first ten cycles, indicating promising properties for these disordered carbons.     

A new serratane-type triterpene from Lycopodium phlegmaria

A new serratane-type triterpene, lycophlegmarin (1), has been isolated from Lycopodium phlegmaria L. Four known related triterpenoids were also found from the title plant. The structure of the new compound was elucidated on the basis of detailed spectroscopic analysis and chemical method. Lycophlegmarin exhibited modest growth-inhibitory activity in vitro against human hepatoma cells BEL 7402.     

用θ-2θ型衍射仪测定溶液结构的新方法

叙述了用θ－２θ型Ｘ射线衍射仪精确测定电解质溶液结构的新实验技术。设计制作了具有恒温功能的超厚液体样品池，并建立了样品池窗口强度的校正方法。优化了液体Ｘ射线衍射数据和结构参数精细化的计算机程序，获得了非常令人满意的实验结果。由θ－２θ型Ｘ射线衍射仪精确测定的径向分布函数与θ－θ型衍射仪自由散射比较，表明ＤＲＦ分辨率有所提高。     

Can TMS and DSS be used as NMR references for cyclodextrin species in aqueous solution?

Tetramethylsilane (TMS) can be included by -cyclodextrin (-CD), and sodium 2,2-dimethylsilapentane-5-sulphonate (DSS) can form inclusion complexes with - and -CD. The NMR chemical shifts are changed considerably as a result of the strong interaction between CD and the guest compound in the inclusion complexes. A downfield shift of as much as 0.63 ppm shift downfield has been observed for the protons of external TMS in CD aqueous solution. In view of this, the question arises of whether TMS and DSS can be used as internal references. DSS in D₂O is suggested as an external reference for aqueous cyclodextrin solution in NMR measurements.     

Adsorption of NH3 onto activated carbon prepared from palm shells impregnated with H2SO4

Adsorption of ammonia (NH3) onto activated carbons prepared from palm shells impregnated with sulfuric acid (H2SO4) was investigated. The effects of activation temperature and acid concentration on pore surface area development were studied. The relatively large micropore surface areas of the palm-shell activated carbons prepared by H2SO4 activation suggest their potential applications in gas adsorption. Adsorption experiments at a fixed temperature showed that the amounts of NH3 adsorbed onto the chemically activated carbons, unlike those prepared by CO2 thermal activation, were not solely dependent on the specific pore surface areas of the adsorbents. Further adsorption tests for a wide range of temperatures suggested combined physisorption and chemisorption of NH3. Desorption tests at the same temperature as adsorption and at an elevated temperature were carried out to confirm the occurrence of chemisorption due to the interaction between NH3 and some oxygen functional groups via hydrogen bonding. The surface functional groups on the adsorbent surface were detected by Fourier transform infrared spectroscopy. The amounts of NH3 adsorbed by chemisorption were correlated with the contents of elemental oxygen present in the adsorbents. Mechanisms for chemical activation and adsorption processes are proposed based on the observed phenomena.     

The Neutral Part of the Bark of Pinus Luchuensis Mayer

The neutral part of the acetone extract from the bark of Pinus luchuensis Mayer has been investigated and found to consist of alkanes (C₂₂–C₃₄) and triterpenes of serratene type. The triterpenes are 3β–methoxyserrat–14–en–21–one, serrat–14–en–3, 21–dione, 3β–hydroxyserrat–14–en–21–one, 3β–21α–dimethoxyserrat–l4–ene and 3β–methoxyserrat–14–en–21α–ol.