Selective Determination of Nanogram γ-Globulin in Human Blood Serum by Resonance Light Scattering of Functionalized Nano-PbS

Functionalized nano-PbS has been prepared and characterized. The functionalized nanoparticles have good dispersibility in water. Reaction of functionalized nano-PbS with γ-globulin (γ-IgG) results an enhanced resonance light scattering (RLS) around 385nm.However, when the content of HSA is lower than 0.5μg/ml^-1 the RLS enhancement is very weak and is nonlinear to concentration of HSA. Based on these results, a new direct quantitative determination method for γ-globulin in blood serum samples without separation is established.Under optimal conditions, the enhanced RLS intensity is in proportion to the γ-IgG concentration in the range 10-500ng/mL. The limit of detection is 2.75ng/mL. This method is proved to be very sensitive, rapid, simple and selective for detection of γ-IgG in blood serum.     

芴取代的有机膦化合物的合成及发光性能

合成了以芴为取代基，P原子为核的一类新型有机膦化合物．此类化合物的HOMO值在-5．35～-5．24eV之间．在二氯甲烷中的最大紫外吸收光谱峰值在313～351nm之间，荧光光谱峰值在334～397nm之间．利用此类小分子与纯聚芴进行掺杂，制作了有机电致发光器件．低HOMO值有机膦化合物的引入有效地降低了聚芴发光器件的开启电压，提高了器件的发光效率．     

黄芩苷元的Mannich反应

利用天然产物黄芩苷元（baicalein)在A环8－位碳上进行Mannich反应，合成 了11个新的Mannich碱化合物。反应温和，产物易纯化，收率达80％以上。同时考 察了伯胺与甲醛配比为1：2时，产物为二氢苯并E嗪类化合物和黄芩苷元A环上5－ ，6－，7－位羟基对8－位氢进行Mannich反应活性的影响。并对Mannich碱化合物 2b和2j进行盐酸成盐4b和4j，初步考察了它们的溶解度与黄芩苷元的差别。     

一种新的液晶高分子——丁酸壳聚糖的合成与表征

甲壳素几乎不溶于任何溶剂,由于其脱乙酰化产物壳聚糖含自由氨基,能被酸质子化而溶解,所以壳聚糖的应用领域远多于甲壳素.但是壳聚糖也仅能溶于酸性介质中,并不能溶于纯水和普通有机溶剂,因而人们对甲壳素或壳聚糖进行各种化学改性[1,2],寻求溶解性更好尤其能溶于水的衍生物,以扩大其应用范围.本文按文献[2～4]方法合成了O-丁酰化壳聚糖(简称丁酸壳聚糖),首次报道它具有溶致液晶性.     

N-TiO2/ZnO复合纳米管阵列的掺杂机理及其光催化活性

以ZnO纳米柱阵列为模板, 采用溶胶-凝胶法制备出TiO2/ZnO和N掺杂TiO2/ZnO的复合纳米管阵列. 扫描电镜(SEM)、X射线光电子能谱(XPS)和紫外-可见漫反射吸收光谱(UV-Vis)的结果表明: 两种阵列的纳米管均为六角形结构, 直径约为100 nm, 壁厚约为20 nm; 在N-TiO2/ZnO复合纳米管阵列中, 掺入的N离子主要是以N-Ox、N-C和N-N的形式化学吸附在纳米管表面, 仅有少量的N离子以取代式掺杂的方式占据TiO2晶格O的位置; 表面N物种形成的表面态能级和取代式掺杂导致带隙的窄化, 增强了纳米管阵列的光吸收效率, 促进了光生载流子的分离. 光催化实验结果表明, N离子的掺杂有利于N-TiO2/ZnO复合纳米管阵列光催化活性的提高.     

EPM-g-GMA接枝率的测定及其增韧PBT的力学性能和形态结构研究

在同向双螺杆挤出机中通过熔融接枝反应制备了EPM g GMA ,将其与PBT在转矩流变仪中熔融共混可以获得增韧的PBT工程塑料 .实验中EPM g GMA接枝率的测定采用红外工作曲线法 ,选用CCl4 做溶剂以避免溶剂对样品吸收峰的干扰 .随着EPM g GMA接枝率的增加 ,PBT EPM g GMA的缺口冲击强度相应提高 ,共混物中EPM g GMA的粒径尺寸减小 ,当EPM g GMA的接枝率为 4 7mL 1 0 0gEPM时 ,EPM g GMA的粒径尺寸可达 0 5 μm ,PBT EPM g GMA的缺口冲击强度达到 5 1 6kJ m2 ,是纯PBT的 3 1倍     

N-TiO2/ZnO复合纳米管阵列的掺杂机理及其光催化活性

以ZnO纳米柱阵列为模板, 采用溶胶-凝胶法制备出TiO2/ZnO和N掺杂TiO2/ZnO的复合纳米管阵列. 扫描电镜(SEM)、X射线光电子能谱(XPS)和紫外-可见漫反射吸收光谱(UV-Vis)的结果表明: 两种阵列的纳米管均为六角形结构, 直径约为100 nm, 壁厚约为20 nm; 在N-TiO2/ZnO复合纳米管阵列中, 掺入的N离子主要是以N-Ox、N-C和N-N的形式化学吸附在纳米管表面, 仅有少量的N离子以取代式掺杂的方式占据TiO2晶格O的位置; 表面N物种形成的表面态能级和取代式掺杂导致带隙的窄化, 增强了纳米管阵列的光吸收效率, 促进了光生载流子的分离. 光催化实验结果表明, N离子的掺杂有利于N-TiO2/ZnO复合纳米管阵列光催化活性的提高.     

N-TiO2/ZnO复合纳米管阵列的掺杂机理及其光催化活性

以ZnO纳米柱阵列为模板, 采用溶胶-凝胶法制备出TiO2/ZnO和N掺杂TiO2/ZnO的复合纳米管阵列. 扫描电镜(SEM)、X射线光电子能谱(XPS)和紫外-可见漫反射吸收光谱(UV-Vis)的结果表明: 两种阵列的纳米管均为六角形结构, 直径约为100 nm, 壁厚约为20 nm; 在N-TiO2/ZnO复合纳米管阵列中, 掺入的N离子主要是以N-Ox、N-C和N-N的形式化学吸附在纳米管表面, 仅有少量的N离子以取代式掺杂的方式占据TiO2晶格O的位置; 表面N物种形成的表面态能级和取代式掺杂导致带隙的窄化, 增强了纳米管阵列的光吸收效率, 促进了光生载流子的分离. 光催化实验结果表明, N离子的掺杂有利于N-TiO2/ZnO复合纳米管阵列光催化活性的提高.     

Effect of microcrystallite preparation conditions on the formation of colloid crystals of cellulose

Stable colloidal suspensions of cellulose microcrystallites may be prepared from filter paper by sulfuric acid hydrolysis. Above a critical concentration, the suspensions form a chiral nematic ordered phase, or colloid crystal. The preparation conditions govern the properties of the individual cellulose microcrystallites, and hence the liquid crystalline phase separation of the cellulose suspensions. The particle properties and the phase separation of the suspensions were strongly dependent on the hydrolysis temperature and time, and on the intensity of the ultrasonic irradiation used to disperse the particles. The particle size of the microcrystallites was characterized with transmission electron microscopy and photon correlation spectroscopy. The surface charge was determined by conductometric titration. It was possible to fractionate the microcrystallites by size using the partitioning between isotropic and liquid crystalline phases; the longer microcrystallites migrate to the liquid crystalline phase     

Surface chemistry of nanoscale Fe_3O_4 dispersed in magnetic fluids

The interaction between stabilizers and nanoparticles is one of the important factors to prepare stable magnetic fluids. The magnetic nano-size Fe3O4 core with single domain and the average grain size around 8-12 nm were prepared by chemical precipitation method. The O/Fe molar ratio of the particle surface was measured by X-ray photoelectron spectroscopy (XPS). The heat effects of stabilizers ad- sorption on nanoparticles were measured by solution calorimetry. The excess amount of oxygen was possibly the result of the hydroxygen formed on the surface of the nanoparticles. The heat effects showed that compounds containing carboxyl groups can be adsorbed chemically on magnetite by forming chemical bonds. The other stabilizers involving NH-groups, such as polyethylene-imine, can be adsorbed physically. The exothermic value is about half of the former case.