Fe–Mn–Al–C Alloys: a Study of Their Corrosion Behaviour in SO2 Environments

The corrosion reaction of four Fe–Mn–Al alloys exposed to a cycling, dry–humid, SO₂ (0.001% by volume) polluted atmosphere was studied. ICEMS, XPS, AES-SAM and transmission Mössbauer spectroscopy at different temperatures were employed to characterize the corrosion products. The analytical results indicate that (i) ferrihydrite is the main component of the rust; (ii) there is an abundant presence of Mn²⁺ and SO₃ ^2–/SO₄ ^2– on the top of the corrosion layer, the concentration of SO₄ ^2– increasing with the number of cycles; and (iii) the magnetic hyperfine pattern exhibited by the series of low-temperature spectra of the rust is quite different from that observed in the rust formed under similar corrosive environments on iron and weathering steel. This latter finding is correlated with a slow rate of transformation of the Fe³⁺ species formed at the early stages of corrosion into -FeOOH, the usual final product of this type of corrosion processes. The sulphate anions, abundant inside the electrolyte during the wet periods, could be incorporated to the ferrihydrite structure being responsible for the Mössbauer spectral pattern recorded from the corrosion products at low temperatures.     

Recent Developments in Synchrotron Mössbauer Reflectometry

Hyperfine Interactions - Synchrotron Mössbauer Reflectometry (SMR), the grazing incidence nuclear resonant scattering of synchrotron radiation, can be applied to perform depth-selective phase...     

Disordered Magnetic Phase in Partially Oxidized Bulk Nanocrystalline Iron

Magnetically frozen partially disordered state was observed in nanocrystalline bulk iron prepared by ball-milling of microcrystalline Fe. Role of nanostructure and oxidized fraction is pointed out. Altough we have found a small constituent which is proportional to 1/T in the ZFC curve, the magnetization scaling with T ^3/2 at high fields and the hysteretic behavior in FC-ZFC curves signalizes the presence of frozen ferromagnet at low temperatures.     

Magnetization and Specific Heat of UCo0.95T0.05Al (T = Fe, Ni) Single Crystals

We present the first single-crystal study of Fe and Ni doped U(Co_1-x T _x )Al compounds in comparison to the parent compound, the itinerant 5f-electron metamagnet UCoAl. Magnetization and specific-heat data measured in the temperature range of (1.8-300) K and in fields up to 10 T are analyzed and discussed. Both compounds exhibit a strong uniaxial anisotropy with the dominating magnetic response along the c-axis of the hexagonal ZrNiAl-type structure. Ni substitution yields an increase of the critical field for metamagnetism; UCo_0.95Fe_0.05Al is ferromagnetic below 30 K. Temperature evolution of the entropy change between 0 and 10 T points to involvement of magnetic correlations or spin fluctuations in the paramagnetic compounds UCoAl and UCo_0.95Ni_0.05Al.     

Superconductivity in non-stoichiometric and tin-substituted La2CuO4: preparation, characterization, Mössbauer and microwave-absorption studies

Two samples of non-stoichiometric La₂CuO₄ were synthesized, one with La/Cu<2, and the other with 10% Sn substituting Cu. They were investigated by X-ray diffraction, Mössbauer spectroscopy, and microwave-absorption techniques. The microwave-absorption data indicated that they were both superconducting, with the transition temperatures T_c of 40.5 and 41.5 K, the one doped with Sn possessing the higher T_c. The Mössbauer spectra revealed that there exist two kinds of Sn(IV) atoms disordered with Cu. Their isomer shift, δ=−0.244(4) mm/s, is in agreement with Sn(IV) coordinated by oxygen. One site was characterized by a single Mössbauer line, being associated with a weakly distorted environment, wherein the Sn, coordinated more symmetrically, is surrounded by four Cu²⁺ ions. On the other hand, the other site, characterized by a Mössbauer doublet exhibited a quadrupole splitting Δ=1.07(2) mm/s, being associated with a highly distorted coordination, explained to be due to Sn occupying two adjacent cationic sites. To our knowledge, such a substitution for copper ions not resulting in a decrease of T_c has not been reported previously.     

On the interaction of two beating electrostatic waves with plasma electrons

This paper is devoted to the study of the interaction of particles with two beating plasma waves. We follow the instructional article by Ott and Dum. According to them, the sum of wave actions during the interaction is constant, supposing the effect of trapped particles on the beat can be neglected. In the present paper, this problem is solved more generally, just for the case of trapped and also untrapped particles in the wave. Our study shows that the sum of wave actions is constant also in the case when the influence of the trapped particles on the amplitudes of two waves was considered. On the contrary this conclusion is not valid if it is supposed that two original waves are amplitude modulated e.g. by the influence of the interaction of the beat with particles. The author is deeply indebted to Dr. Ladislav Krlín for guidance and encouragement throughout the course of this work.     

Infrared picosecond absorption spectroscopy of microcrystalline silicon: separation between carrier recombination in crystalline and amorphous fractions

We have studied ultra-fast carrier dynamics of photo-excited carriers in hydrogenated microcrystalline silicon prepared by a very high frequency glow-discharge technique. We report on direct observation of two types of dynamics using selective photo-excitation in picosecond pump and probe measurements. One type of the observed dynamics has been found to be independent of the sample preparation, while the other reflects the relative weights of crystalline and amorphous fractions. We propose a simple rate-equation model that describes the carrier dynamics in microcrystalline silicon in terms of the composition of those in Si microcrystallites and in the a-Si:H tissue which surrounds the microcrystallites. The model without any fitting parameters reproduces the experimental data very well when the dynamics are scaled with relative volume fractions as obtained from Raman spectra. Received: 23 November 2000 / Accepted: 17 March 2001 / Published online: 23 May 2001     

Magnetic Study of Doped Ba Ferrites Prepared by Citrate Method

The M-type barium ferrite is doped with either Co²⁺-Ti⁴⁺ or Co²⁺-Zr⁴⁺ pairs to reduce its intrinsically high uniaxial magnetic anisotropy in order to make fine particles for magnetic recording. The magnetic parameters were investigated by magnetic measurements and the Mössbauer spectroscopy. Compounds (BaF) obtained from BaCo _x (Ti,Zr) _x Fe_12-2x O₁₉ with 0x1.0 have been prepared by the modified citrate method with the initial ratio of Ba:Fe equal to 1:10.8. The substitution of Co - Ti or Co - Zr for Fe³⁺ ions affects mainly the positions 2a and 4f ₂. Ba ferrite with the substitution x 0.8 is promising for perpendicular recording media applications.     

Time-Resolved Fluorescence Spectroscopy Study on the Photophysical Behavior of Quantum Dots

Room-temperature time-resolved luminescence measurements on single CdSe/ZnS quantum dots (QDs) are presented. Fluorescence emission spectra were recorded over periods of up to 30 minutes with a time resolution as small as 6 ms. For QDs in ambient air, a clear 30–40 nm blue shift in the emission wavelength is observed, before the luminescence stops after about 2–3 minutes because of photobleaching. In a nitrogen atmosphere, the blue shift is absent while photobleaching occurs after much longer times (i.e., 10–15 minutes). These observations are explained by photoinduced oxidation. The CdSe surface is oxidized during illumination in the presence of oxygen. This effectively results in shrinkage of the CdSe core diameter by almost 1 nm and consequently in a blue shift. The faster fading of the luminescence in air suggests that photoinduced oxidation results in the formation of non-radiative recombination centers at the CdSe/CdSeO_x interface. In a nitrogen atmosphere, photoinduced oxidation is prevented by the absence of oxygen. Additionally, a higher initial light output for CdSe/ZnS QDs in air is observed. This can be explained by a fast reduction of the lifetime of the long-lived defect states of CdSe QDs by oxygen.     

Application of the stabilization method to interacting resonances

The stabilization method is applied to the case of interacting resonances in the photo-dissociation of van der Waals clusters composed by a rare gas atom bound to a dihalogen molecule. The study of an illustrative two-dimensional model consisting in a T-shaped NeI₂ molecule shows the adequacy of the method whenever the projection of the stabilization wave functions on the assumed prepared initial state is accounted for. The agreement of the fragmentation cross-sections with some previous results using the effective resolvent method and accurate close-coupling calculations is excellent. The method reveals its utility as a complementary tool since allows, through the analysis of the stabilization wave function in terms of zero-order levels, a precise characterization of the resonant states involved. Received 5 April 2002 / Received in final form 24 May 2002 Published online 19 July 2002