Volumetric Properties of the Ternary System 1,4-Dioxane + Butyl Acrylate + Ethyl Acrylate and Its Binary Butyl Acrylate + Ethyl Acrylate at 298.15 K

Densities of the ternary system 1,4-dioxane + butyl acrylate + ethyl acrylate and its binary butyl acrylate + ethyl acrylate have been measured in the whole composition range, at 298.15 K and atmospheric pressure, using an Anton Paar DMA 5000 oscillating U-tube densimeter. The calculated excess molar volumes of the binary system are positive and were correlated with the Redlich–Kister equation and with a series of Legendre polynomials. Several models were used to correlate the ternary behavior from the excess molar volume data of their constituent binaries and were found equally good to fit the data. The best fit was based on a direct approach, without information on the component binary systems.     

Flow injection determination of bismuth in urine by successive retention of Bi(III) and tetrahydroborate(III) on an anion-exchange resin and hydride generation atomic absorption spectrometry

Bismuth as BiCl₄⁻ and BH₄⁻ ware successively retained in a column (150 mm × 4 mm, length × i.d.) packed with Amberlite IRA-410 (strong anion-exchange resin). This was followed by passage of an injected slug of hydrochloric acid resulting in bismuthine generation (BiH₃). BiH₃ was stripped from the eluent solution by the addition of a nitrogen flow and the bulk phases were separated in a gas–liquid separator. Finally, bismutine was atomized in a quartz tube for the subsequent detection of bismuth by atomic absorption spectrometry. Different halide complexes of bismuth (namely, BiBr₄⁻, BiI₄⁻ and BiCl₄⁻) were tested for its pre-concentration, being the chloride complexes which produced the best results. Therefore, a concentration of 0.3 mol l⁻¹ of HCl was added to the samples and calibration solutions. A linear response was obtained between the detection limit (3σ) of 0.225 and 80 μg l⁻¹. The R.S.D.% (n = 10) for a solution containing 50 μg l⁻¹ of Bi was 0.85%. The tolerance of the system to interferences was evaluated by investigating the effect of the following ions: Cu²⁺, Co²⁺, Ni²⁺, Fe³⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, and Mg²⁺. The most severe depression was caused by Hg²⁺, which at 60 mg l⁻¹ caused a 5% depression on the signal. For the other cations, concentrations between 1000 and 10,000 mg l⁻¹ could be tolerated. The system was applied to the determination of Bi in urine of patients under therapy with bismuth subcitrate. The recovery of spikes of 5 and 50 μg l⁻¹ of Bi added to the samples prior to digestion with HNO₃ and H₂O₂ was in satisfactory ranges from 95.0 to 101.0%. The concentrations of bismuth found in six selected samples using this procedure were in good agreement with those obtained by an alternative technique (ETAAS). Finally, the concentration of Bi determined in urine before and after 3 days of treatment were 1.94 ± 1.26 and 9.02 ± 5.82 μg l⁻¹, respectively.     

Delocalization in platinum-alkynyl systems: a metal-bridged organic mixed-valence compound

A complex featuring two triarylamine redox centers bridged by Pt, trans-bis(triethylphosphine)-bis{4-[bis(4-methoxyphenyl)amino]phenylethynyl} platinum(II), has been synthesized as a model system for pi-conjugated Pt-containing polymers. Analysis of the intervalence charge-transfer band displayed by its mixed-valence monocation affords a quantitative assessment of electronic delocalization through the Pt bridge; this is found to be only slightly smaller than that determined for a benzene-bridged analogue. These results are supported by density functional theory calculations, which show that the active orbitals involved in the electron-transfer process in both cases have similar delocalization through the bridging unit.     

Allocolchicinoid synthesis via direct arylation

[reaction: see text] A formal enantioselective synthesis of allocolchicine and a synthesis of a C-ring analogue have been achieved by employing an intramolecular direct arylation of an aryl chloride to form the biaryl carbon-carbon bond and the seven-membered ring.     

Comparison of low-order multireference many-body perturbation theories

Tests have been made to benchmark and assess the relative accuracies of low-order multireference perturbation theories as compared to coupled cluster (CC) and full configuration interaction (FCI) methods. Test calculations include the ground and some excited states of the Be, H(2), BeH(2), CH(2), and SiH(2) systems. Comparisons with FCI and CC calculations show that in most cases the effective valence shell Hamiltonian (H(v)) method is more accurate than other low-order multireference perturbation theories, although none of the perturbative methods is as accurate as the CC approximations. We also briefly discuss some of the basic differences among the multireference perturbation theories considered in this work.     

Enantioselective approaches to potential MetAP-2 reversible inhibitors

[reaction: see text] Enantioselective deprotonation of 4-substituted cyclohexanones and highly stereoselective conjugate addition of higher order mixed cuprates were the key steps in a concise synthesis of fumagalone-related molecules. The origin of the (low) biological activity of the new compounds as compared to fumagalone is briefly discussed.     

Intramolecular [4 + 2] cycloadditions of 1,3-enynes or arylalkynes with alkenes with highly reactive cationic phosphine Au(I) complexes

New Au(I) complexes with bulky, biphenyl phosphines are the most reactive catalysts for the cyclizations of enynes. 1,6-Enynes with an aryl ring at the alkyne give 2,3,9,9a-tetrahydro-1H-cyclopenta[b]naphthalenes by a 5-exo-dig cyclization followed by a Nazarov-type ring expansion. 1,8-Dien-3-ynes also cyclize by a 5-exo-dig pathway to form hydrindanes.     

Dosage de traces de fer total dans les vins

Résumé Le dosage électrophotocolorimétrique des traces de fer total dans les vins au moyen de l'orthophénanthroline a été peu étudié jusqu'à présent. Sous un titre général le mémoire expose les conclusions auxquelles ont abouti diverses recherches consacrées à l'étude du dosage en question. L'application raisonnée de la méthode deBencze a permis d'établir une technique d'évaluation photocolorimétrique du fer dans les vins et les jus de fruits. Intéressante par sa simplicité et sa rapidité d'exécution, la technique en question indique le moyen de doser cet élément directement dans les liquides obtenus à partir des vins, suivant le procédé du traitement oxydatif au perhydrol. Ce traitement a permis de revaloriser le dosage du fer au point de vue de la rapidité par rapport à la minéralisation sèche, sans apporter en même temps des complications dans les manipulations analytiques et sans affecter la sensibilité et la précision de la réaction colorimétrique.

---

Summary There has been little study of the electrophotocolorometric determination of the total iron content of wines by means of orthophenanthroline. Under a general title, the paper gives the general conclusions reached as a result of various studies of this determination. An intelligent application of theBencze method has resulted in a photocolorimetric evaluation of iron in wines and fruit juices. Characterized by simplicity and rapidity, this technique provides a means of determining this element directly in the liquids obtained from wines after oxidative treatment with perhydrol. This procedure compares, favorably with respect to speed with mineralization by the dry method, but is free from the complications in the analytical manipulations and there is no adverse effect on the sensitivity and the precision of the colorimetric reaction.

---

Zusammenfassung Die elektrokolorimetrische Bestimmung der geringen Gesamtmengen an Eisen in Wein mit Hilfe von o-Phenanthrolin wurde bisher nur wenig untersucht. Die beim Studium dieses Verfahrens gesammelten Erfahrungen werden in Form eines allgemeinen Überblicks mitgeteilt. Die Anwendung der Methode vonBencze führte zur Ausarbeitung einer Arbeitsvorschrift zur kolorimetrischen Bestimmung des Eisens in Wein und Fruchtsäften. Diese ist wegen der Einfachheit und Geschwindigkeit ihrer Durchführung von praktischem Interesse. In der durch Oxydation des Weines mit Wasserstoffperoxyd erhaltenen Lösung kann das Eisen unmittelbar bestimmt werden. Diese Art des Aufschlusses ist besser geeignet als die trockene Veraschung, ohne die Empfindlichkeit oder die Genauigkeit der Farbreaktion zu beeinträchtigen.

     

Biological UV dosimeters in the assessment of the biological hazard from environmental radiation

To determine the impact of environmental UV radiation, biological dosimeters that weight directly the incident UV components of sunlight have been developed, improved and evaluated in the frame of the BIODOS project. Four DNA-based biological dosimeters ((i) phage T7, (ii) uracil thin layer, (iii) spore dosimeter and (iv) DLR-biofilm) have been assessed from the viewpoint of their biological relevance, spectral response and quantification of their biological effectiveness. The biological dosimeters have been validated by comparing their readings with weighted spectroradiometer data, by comparison with other biological doses, as well as with the determined amounts of DNA UV photoproducts. The data presented here demonstrate that the biological dosimeters are potentially reliable field dosimeters for measuring the integrated biologically effective irradiance for DNA damage.     

Single molecule spectroscopy as a probe for dye-polymer interactions

Experimental (Single Molecule Spectroscopy) and theoretical (quantum-chemical calculations and Monte Carlo and molecular dynamics simulations) techniques are combined to investigate the behavior and dynamics of a polymer-dye molecule system. It is shown that the dye molecule of interest (1,1'-dioctadecyl-3,3,3',3'-tetramethylindo-dicarbocyanine) adopts two classes of conformations, namely planar and nonplanar ones, when embedded in a poly(styrene) matrix. From an in-depth analysis of the fluorescence lifetime trajectories, the planar conformers can be further classified according to the way their alkyl side chains interact with the surrounding poly(styrene) chains.