Large-volume injection electrothermal AAS combined with tungsten-treated pyrolytic graphite furnace: determination of cadmium in tap, snow and river water samples with phosphate modifier.

A large-volume (100 microl) injection-ETAAS with W-treated PG furnace combined with a phosphate modifier was applied to the determination of unpolluted levels of Cd in tap, snow and river-water samples. The limit of detection of 1.1 ng l(-1) was observed for a 4 w/v% NH4H2PO4 modifer. Matrix interference studies were tested for major ion species well found in fresh water. The direct determination of Cd in certified river water (12 +/- 2 ng l(-1)) was carried out and the observed value was in agreement with the certified one. The good recoveries of Cd added to real environmental water samples were also observed. This method was applied to the determination of Cd in unpolluted environmental water samples.     

Non-destructive rapid analysis of brominated flame retardants in electrical and electronic equipment using Raman spectroscopy.

Using Raman spectroscopy without any preparation, we analyzed the brominated flame retardant, polybromodiphenyl ethers (PBDEs), which has been prohibited by the European Union. The typical Raman bands of PBDEs, which are clearly different from those of other brominated flame retardants, are from 100 to 300 cm(-1). In our analysis, the detection limit was about 100 ppm, and the analysis took about 1 min, whereas the usual method of solvent extraction using gas chromatography/mass spectroscopy takes 50 h.     

Structural characterization of polypyrrole in the solid state by high resolution 15N NMR spectroscopy [II]

The solid-state ¹⁵N CP/MAS NMR spectra and ¹⁵N spin-lattice relaxation times (T₁) of doped and dedoped ¹⁵N-labeled polypyrroles prepared by electrochemical polymerization, have been measured by means of high-resolution solid-state ¹⁵N NMR. The ¹⁵N signal of polypyrrole consists of four peaks decomposed by line shape analysis. The four peaks obtained have been assigned to the various structures of polypyrrole. Further, the half-width of the ¹⁵N NMR spectra of polypyrroles is discussed as related to the electrical conductivity. © 1995 John Wiley & Sons, Inc.     

Separation of fulvic acid from soil extracts based on ion-pair formation with a cationic surfactant.

A novel method for separating fulvic acid (FA) from soil extracts is proposed. The FA, defined as the acid-soluble fraction of an alkaline extract of soil, was separated based on the precipitation of an ion-pair with a cationic surfactant, such as domiphen bromide. The precipitate was dissolved in aqueous HCl to produce H+ -type FA and a surfactant chloride (SUR-Cl). SUR-Cl, in the aqueous solution, was removed by extraction with CHCl3. After the aqueous phase was passed through a cation-exchanger (H+ -type), H+ -type FA (FA-SUR) was obtained as a powder by lyophylization. The chemical characteristics of FA-SUR were compared with an FA sample separated according to the method of the International Humic Substances Society using a DAX-8 resin (FA-DAX). The oxygen content, O/C atomic ratio and total acidity of the FA-SUR were significantly larger than the corresponding values for FA-DAX. The solid-state CPMS 13C NMR spectra indicated that the higher oxygen content of the FA-SUR could be due to alcoholic hydroxyl groups and polysaccharides as well as carboxylic groups. These results show that FA-SUR is more polar and hydrophilic than FA-DAX.     

Mass spectral study on thiazolo[3,2-a]benzimidazoles. Studies on heterocyclic compounds. IV

Condensation of α-halocarbonyl compounds and 2-mercaptobenzimidazole gives thiazolo-[3,2-a]benzimidazoles. This condensation occurred at the mercapto group of the benzimidazole followed by cyclization to form the thiazole ring. This was confirmed by the examination of the mass spectra of 2- and 3-methylthiazolo[3,2-a]benzimidazoles, 2- and 3-phenylthiazolo[3,2-a]-benzimidazoles, and their derivatives.     

Enzymatic sulfation of polyphenols related to tannins by arylsulfotransferase.

This report discusses a novel type of arylsulfotransferase (AST) which was derived from human intestinal bacterium sulfated polyphenolic compounds when p-nitrophenyl sulfate (PNS) was taken as a donor substrate. (+)-Catechin, (+/-)-catechin, (-)-epicatechin and (-)-epicatechin gallate were better substrates than tyramine. (-)-Epigallocatechin and (-)-epigallocatechin gallate were slightly worse substrates than tyramine. Although gallic acid was a bad substrate, alkyl gallate esters were better substrates than tyramine. The degree of acceptor specificity increased in proportion to the length of the alkyl group up to the carbon number of five. Pedunculagin, geraniin and corilagin were less effective than tyramine. Rosmarinic acid and penta-O-galloyl-beta-D-glucose were similarly well sulfated. Two products, 4'-monosulfate and 4',5-disulfate of (+)-catechin, were detected at a two-fold molar excess of PNS over (+)-catechin. When (+)-catechin-4'-monosulfate as an acceptor was enzymatically sulfated with PNS as a donor, only the 4',5-disulfate was produced. Thus, arylsulfotransferase was useful for the convenient preparation of sulfate esters of polyphenols at their specific hydroxyl groups.     

Radiation-induced solid-state polymerization of trioxane under high pressure

The in-source polymerization of trioxane in the solid state was investigated over a wide range of temperature and pressure, i.e., from 30 to 140°C and up to 7000 kg/cm², respectively. In the polymerization that was carried out slightly below the melting point under pressure, the higher the pressure, the higher the rate of polymerization. It was confirmed that the maximum rate of solid-state polymerization of trioxane occurs near the melting points, even under elevated pressure. The rate of polymerization decreased with increasing pressure at constant temperature. The shape of the time–conversion curves may be classified into two types, i.e., one which is typical of high pressure and low temperature, and the other which is typical of low pressure and high temperature. Changes in the shape of the conversion—intrinsic viscosity curves occurred coincidentally. Thus, three regions for the different “polymerization characteristic” were determined as functions of polymerization temperature and pressure. Explanations are given for the above-mentioned polymerization characteristic.     

Fundamental equilibrium analysis on the ion-pair extraction of dibenzo-18-crown-6 complex of alkali metal ions with picrate ion into 1,2-dichloroethane

The ion-pair extraction equilibria of dibenzo-18-crown-6 (DB18C6) complexes of Na⁺, K⁺, Rb⁺ and Cs⁺ (M⁺) with picrate ion (Pic⁻) into 1,2-dichloroethane (1,2-DCE) have been studied at 25.0°C. In the case of the Rb⁺ and Cs⁺ systems, the extraction results were interpreted by taking into consideration the formation of a (DB18C6)₂ -M⁺ complex in 1,2-DCE. The thermodynamic constants of extraction, , and ion-pair formation in 1,2-DCE, , of ion pairs of the DB18C6-M⁺ complexes with Pic⁻ were determined. By using the distribution coefficient of M⁺·Pic⁻ the thermodynamic formation constants of the DB18C6-M⁺ complexes in 1,2-DCE, , were evaluated. Consequently the component equilibrium constants of the ion-pair extraction were completely determined and a contribution of these constants to the difference of value was discussed. The value in 1,2-DCE is quite high compared with that in solvating solvents and log decreases linearly with increasing Gutmann donor number of solvents.     

Kinetics of polymer translocation through a pore

We theoretically study kinetics of a polymer threading through a pore embedded in a flat membrane. We numerically solve three coupled kinetic equations for the number n(1) of polymer segments in one side of the membrane and expansion factors of the polymer chain in each side of the membrane. We find the time evolution n(1) proportional to t(1/(1+nu)) at late stages and the translocation time tau(t) is scaled as tau(t) proportional to 1+nu) for large number n of the polymer segments, where nu is the effective size exponent of the radius of gyration of the polymer. When the polymer is translocated into a region with a good solvent condition (nu=3/5), we obtain n(1) proportional to t(5/8) and tau(t) proportional to n(8/5).