基于虚拟中心电流法的 HL-2M快控电源数学模型

针对中国环流器2号M(HL-2M)装置中用于核聚变物理实验等离子体的垂直不稳定性控制的快控电源拓扑结构，充分考虑线圈的自感与互感对输出的影响，构建出数学模型，首次提出并运用虚拟中心电流法，使得控制算法更加简单，采用多输入多输出的控制方法，利用2个参量控制3个变量。本文基于基本供电方案得到多线圈耦合电压，基于快控电源拓扑推导出快控电源电路方程，再将其合并得到最终的线圈电压数学模型，最后进行仿真验证。结果表明数学模型搭建正确，为今后进行进一步计算提供了坚实的基础。     

Calculations on polarization properties of alkali metal atoms using Dirac–Fock plus core polarization method

A semi-empirical atomic structure model method is developed in the framework of a relativistic case. This method starts from Dirac-Fock calculations using B-spline basis set. The core-valence electron correction is then treated in a semiempirical core polarization potential. As an application, the polarization properties of alkali metal atoms, including the static polarizabilities and long-range two-body dispersion coefficients, have been calculated. Our results are in good agreement with the results obtained from ab initio relativistic many-body perturbation method and the available experimental measurements.     

氢键准则在DMSO水溶液中应用的评价

利用分子动力学模拟方法, 分别采用几何准则和能量准则分析了不同浓度下的二甲基亚砜(DMSO)水溶液的氢键统计和动力学等特性. 结果显示, 两种氢键准则可以很好地反映出溶液的氢键性质随浓度的变化趋势. 通过分析比较发现, 由于几何准则不能有效地排除具有弱对势能的分子对, 因此其统计的氢键数量要大于能量准则的结果.此外, 能量准则对于分子间相对取向的区分存在不足, 进而引起氢键寿命的计算结果偏大.因此,为使氢键分析更加准确, 本文建议使用几何-能量混合型氢键准则.     

以四乙基氢氧化铵为模板并通过转晶法合成高硅铝比的SSZ⁃13沸石分子筛

使用四乙基氢氧化铵为有机模板剂,以低硅铝比(nSiO2/nAl2O3)的Y分子筛为铝源,通过转晶法制备结晶度良好的SSZ?13沸石分子筛。从凝胶配比方面考察了不同原料组成对分子筛合成的影响,并通过X射线衍射(XRD)、扫描电子显微镜(SEM)及电感耦合等离子体(ICP)表征水热反应过程中的物相、形貌、硅铝比等变化,揭示分子筛合成过程。氨选择性催化还原(NH3?SCR)反应显示该分子筛具有优异的催化活性,为其工业上的广泛应用提供了可能性。     

New bifurcations of basin boundaries involving Wada and a smooth Wada basin boundary

This paper demonstrates and analyses double heteroclinic tangency in a three-well potential model, which can produce three new types of bifurcations of basin boundaries including from smooth to Wada basin boundaries, from fractal to Wada basin boundaries in which no changes of accessible periodic orbits happen, and from Wada to Wada basin boundaries. In a model of mechanical oscillator, it shows that a Wada basin boundary can be smooth.     

(一)-△~(9(12))-CapneUene类的合成中间体——光学活性5-甲基-8-羟基双环[3,3,0]2一辛酮的不对称合成研究

通过手性硝基烯胺(4)与α-甲基-δ-戊内酯烯醇锌盐发生加成消除反应解决了倍半萜Capnellene类合成中构筑不对称季碳这个难题,对映体过量(e. e. )为94％。由L-脯氨酸经14步实现了(一)-△~(9(12))-Capnellene类的合成中间体——光学活性5-甲基-8-羟基双环[3 3,0]-2-辛酮(13)的对映选择合成。     

筒仓效应观测仪的设计及其应用

设计并制作了观测静态颗粒物质筒仓效应的实验系统,应用该装置研究了筒仓效应的尺寸依赖性.实验结果表明:圆柱形容器中的颗粒物质对于容器底部的饱和压力依赖于容器直径的3次方,而改变填入颗粒的直径时则饱和压力并无明显改变.     

Growth and Characterization of A1GaN/A1N/GaN HEMT Structures with a Compositionally Step-Graded A1GaN Barrier Layer

A new A1GaN/A1N/GaN high electron mobility transistor （HEMT） structure using a compositionally step-graded A1GaN barrier layer is grown on sapphire by metalorganic chemical vapour deposition （MOCVD）. The structure demonstrates significant enhancement of two-dimensional electron gas （2DEG） mobility and smooth surface morphology compared with the conventional HEMT structure with high A1 composition A1GaN barrier. The high 2DEG mobility of 1806 cm2/Vs at room temperature and low rms surface roughness of 0.220 nm for a scan area of 5μm×5 μm are attributed to the improvement of interracial and crystal quality by employing the stepgraded barrier to accommodate the large lattice mismatch stress. The 2DEG sheet density is independent of the measurement temperature, showing the excellent 2DEG confinement of the step-graded structure. A low average sheet resistance of 314.5Ω/square, with a good resistance uniformity of 0.68%, is also obtained across the 50 mm epilayer wafer. HEMT devices are successfully fabricated using this material structure, which exhibits a maximum extrinsic transconductance of 218 mS/ram and a maximum drain current density of 800 mA/mm.     

关于数列{2~n}

易知等比数列{2~n}前n项的和为S_n=a_(n+1)-2。对于这个关系式,我们有三点联想。 (一)简便求和。若a_5=32,则S_4=30。 (二)判定由关系式a_(n+1)=rS_n+S给出的数列是否为等比数列。事实上a_(n+1)=rS_n+S (1) a~n=rS_(n-1)+S (2) (1)-(2)得a_(n+1)-a_n=r(s_n-S_(n-1))=ra_n a_(n+1)/a_n=r+ 因此,r≠-1,a_1=S,{a_n}为等比数列。 (三)等比数列前n项和公式的新法推导。     

Kinetic model of gas phase polymerization of 1,3-butadiene catalyzed by supported rare earth coordination system

Gas phase polymerization of 1,3-butadiene (Bd) catalyzed by supported rare earth coordination system is studied and a new kinetic model is proposed. Four elementary reactions or processes: the process of exposure and activation of potential active catalytic center, propagation, deactivation and chain transfer reaction to alkyl aluminum, are considered in this model. Some important parameters, such as monomer-consuming rate, are well expressed as the functions of macroscopic polymerization conditions such as pressure, temperature, and duration. The model can simulate the whole polymerization procedure satisfactorily.