Continuous operation up to 3 kHz in a discharge-pumped XeCl excimer laser

Continuous operations at a high repetition rate up to 3 kHz for discharge-pumped XeCl excimer laser are presented. The dependence of the clearing ratio on laser-gas pressure and input energy densities is studied. It was found that suitable laser-gas pressures minimize the clearing ratio for various input-energy densities. It is also shown that few density disturbances in the discharge region are induced by gas heating in a discharge-pumped XeCl excimer laser with low input-energy density     

Lamellar thickening in nascent poly(acrylonitrile) upon annealing

No systematic study has been reported on the lamellar thickening in atactic poly(acrylonitrile) (PAN) upon annealing because PAN, in the form of solution‐cast films or their drawn products, generally shows no small‐angle X‐ray scattering (SAXS) maximum corresponding to the lamellar thickness. In this work, PAN crystals were precipitated during the thermal polymerization of acrylonitrile in solution. The nascent PAN film, obtained by the filtration of the crystal suspension, exhibited a clear SAXS maximum revealing the lamellar structure. The lamellar thickening upon annealing of the nascent PAN films was studied in the temperature range 100–180 °C, where the degradation was minimal, as confirmed by the absence of an IR absorption band at 1605 cm⁻¹ ascribed to the cyclized nitrile groups. Above 190 °C, the degradation of the samples was significant, and the SAXS became too broad to determine the scattering maximum. The long period was significantly affected by the annealing time (t_a) and the temperature (T_a). Depending on t_a, three stages were observed for the lamellar thickening behavior. The lamellar thickness stayed constant in stage I (t_a = 0.5–3 min, depending on T_a), rapidly increased in stage II (t_a = 0.5–8 min), and stayed at a constant value characteristic for each T_a at yet longer t_a's in stage III. The lamellar thickness characteristic for T_a increased rapidly with increasing T_a at 165 °C (or higher), which was 152 °C lower than the estimated melting temperature of PAN (T_m = 317 °C). A possible mechanism for such lamellar thickening in PAN far below the T_m is discussed on the basis of the enhanced chain mobility in the crystalline phase above the crystal/crystal reversible transition at 165–170 °C detected by differential scanning calorimetry and wide‐angle X‐ray diffraction. The structural changes associated with annealing are also discussed. © 2000 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 38: 2571–2579, 2000     

Generation and detection of the radical cation and the dication derived from 4,9‐diethyl[1,4]dihydrodithiino[5,6‐f]benzotrithiole and its 5‐oxide

4,9‐Diethyl[1,4]dihydrodithiino[5,6‐f]benzotrithiole (DTBT) gave a radical cation, DTBT(•+), and a dication, DTBT(2+), on treatment with a single‐electron oxidizing reagent. Both compounds showed an ESR signal, whereas the dication, generated by this procedure, was silent for ¹H NMR. Hydrolysis of DTBT(2+) gave DTBT 1‐oxide (DTBT 1‐O) and 2‐oxide (DTBT 2‐O) together with DTBT and a mixture of several dioxides. A singlet‐state dication, DTBT(2+)‐S, which was generated upon treatment of DTBT 5‐oxide (DTBT 5‐O) with concentrated D₂SO₄, was detected by ¹H and ¹³C NMR. After 20 h, the NMR signals disappeared while the solution was active for ESR. The results suggest that (i) a species generated from DTBT by oxidation with the single‐electron oxidizing reagent is a triplet‐state dication, DTBT(2+)‐T, and (ii) DTBT(2+)‐S, initially generated, gradually isomerizes to DTBT(2+)‐T in the solution, and DTBT(2+)‐T forms a partial spin pair. © 2008 Wiley Periodicals, Inc. Heteroatom Chem 19:394–401, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/hc.20445     

High-spin radical cations of a dendritic oligoarylamine

A new dendritic oligoarylamine, N,N,N',N',N",N"-hexakis[4-(di-4-anisylamino)phenyl]- 1,3,5-benzenetriamine (BTA) 2, which contains a 1,3,5-benzenetriamine molecular unit as an potential precursor of a high-spin molecule and three oligoarylamine moieties as spin-carrying units surrounding the core BTA, has been prepared by the sequential palladium-catalyzed amination reactions. The redox property has been investigated by cyclic voltammetry, and the highly charged states up to the hexacation are accessible to 2. The polycationic high-spin species have been generated by stepwise chemical oxidation, and the electronic structures have been examined in detail by the continuous wave (CW) and pulsed ESR spectroscopy in comparison with the previously studied 1. The pulsed ESR technique enabled us to determine the definite spin multiplicity of the generated polycationic species of 2. It was confirmed that the dominant oxidized species observed by the two- and three-electron oxidations were assigned to the spin triplet 2(2+) and the spin quartet 2(3+), respectively. Moreover, these high-spin polycationic species turned out to be far more stable as compared to 1, and the isolation of 2(3+) as the SbCl(6)(-) salt has been accomplished. The temperature dependence of the magnetic susceptibility for the 2(3+)(SbCl(6)(-))(3) salt revealed that the intramolecular ferromagnetic interaction exists in 2(3+), and moreover, the trication 2(3+) was found to be deformed in the solid state.     

Visualization of acetylcholine distribution in central nervous system tissue sections by tandem imaging mass spectrometry

Metabolite distribution imaging via imaging mass spectrometry (IMS) is an increasingly utilized tool in the field of neurochemistry. As most previous IMS studies analyzed the relative abundances of larger metabolite species, it is important to expand its application to smaller molecules, such as neurotransmitters. This study aimed to develop an IMS application to visualize neurotransmitter distribution in central nervous system tissue sections. Here, we raise two technical problems that must be resolved to achieve neurotransmitter imaging: (1) the lower concentrations of bioactive molecules, compared with those of membrane lipids, require higher sensitivity and/or signal-to-noise (S/N) ratios in signal detection, and (2) the molecular turnover of the neurotransmitters is rapid; thus, tissue preparation procedures should be performed carefully to minimize postmortem changes. We first evaluated intrinsic sensitivity and matrix interference using Matrix Assisted Laser Desorption/Ionization (MALDI) mass spectrometry (MS) to detect six neurotransmitters and chose acetylcholine (ACh) as a model for study. Next, we examined both single MS imaging and MS/MS imaging for ACh and found that via an ion transition from m/z 146 to m/z 87 in MS/MS imaging, ACh could be visualized with a high S/N ratio. Furthermore, we found that in situ freezing method of brain samples improved IMS data quality in terms of the number of effective pixels and the image contrast (i.e., the sensitivity and dynamic range). Therefore, by addressing the aforementioned problems, we demonstrated the tissue distribution of ACh, the most suitable molecular specimen for positive ion detection by IMS, to reveal its localization in central nervous system tissues.     

High light inhibits chlorophyll biosynthesis at the level of 5-aminolevulinate synthesis during de-etiolation in cucumber (Cucumis sativus) cotyledons

Using the vascular plant Cucumis sativus (cucumber) as a model, we studied the effects of high (intense and excess) light upon chlorophyll biosynthesis during de-etiolation. When illuminated with high light (1500-1600 microE/m2/s), etiolated cucumber cotyledons failed to synthesize chlorophyll entirely. However, upon transfer to low light conditions (40-45 microE/m2/s), chlorophyll biosynthesis and subsequent accumulation resumed following an initial 2-12 h delay. Duration of high light treatment negatively correlated with chlorophyll biosynthetic activity. Specifically, we found that high light severely inhibited 5-aminolevulinic acid (ALA) synthesis. This effect partly could be because of the decrease in protein level of glutamyl-tRNA reductase (GluTR) observed. Protein level of glutamate-1-semialdehyde (GSA-AT) remained unchanged. It was also found that high light did not suppress HEMA 1 expression. Therefore, we speculated that this significant inhibition of ALA synthesis might have occurred mainly because of concomitant inactivation of GluTR and/or inhibition of complex formation between GluTR and GSA-AT. Our further observation that both methyl viologen and rose bengal similarly inhibit ALA synthesis under low light conditions suggested that reactive oxygen species (ROS) could be responsible for the inhibition of ALA synthesis in cotyledons exposed to high light conditions.     

Biosynthetic pathway for high structural diversity of a common dilactone core in antimycin production

We herein report comparative analysis of two versions of the biosynthetic gene clusters of antimycins, a natural product family possessing up to 44 distinct entities. The biosynthetic pathway of antimycins is amenable to the high structural variation of the substrates, supported by successes in heterologous expression of the ant cluster and in fluorine incorporation. The latter facilitated the investigation of the structure-activity relationship into the usually invariable 3-formamidosalicylic acid moiety of the molecules.     

Mannose‐Binding Geometry of Pradimicin A

Pradimicins (PRMs) and benanomicins are the only family of non‐peptidic natural products with lectin‐like properties, that is, they recognize D ‐mannopyranoside (Man) in the presence of Ca²⁺ ions. Coupled with their unique Man binding ability, they exhibit antifungal and anti‐HIV activities through binding to Man‐containing glycans of pathogens. Notwithstanding the great potential of PRMs as the lectin mimics and therapeutic leads, their molecular basis of Man recognition has yet to be established. Their aggregate‐forming propensity has impeded conventional interaction analysis in solution, and the analytical difficulty is exacerbated by the existence of two Man binding sites in PRMs. In this work, we investigated the geometry of the primary Man binding of PRM‐A, an original member of PRMs, by the recently developed analytical strategy using the solid aggregate composed of the 1:1 complex of PRM‐A and Man. Evaluation of intermolecular distances by solid‐state NMR spectroscopy revealed that the C2–C4 region of Man is in close contact with the primary binding site of PRM‐A, while the C1 and C6 positions of Man are relatively distant. The binding geometry was further validated by co‐precipitation experiments using deoxy‐Man derivatives, leading to the proposal that PRM‐A binds not only to terminal Man residues at the non‐reducing end of glycans, but also to internal 6‐substituted Man residues. The present study provides new insights into the molecular basis of Man recognition and glycan specificity of PRM‐A.     

A novel foam based separation strategy for extracting minute target impurities

The purpose of this study was to extract impurities from compounds using a simple separatory bottle to purify target compounds with a foam column and allow for the further characterization of impurities. Charged dyes were used as target compounds due to the ease of detection of dyes and isolated impurities. Foaming agents were used in a glass bottle with a modified cap to separate a target impurity using an appropriately charged ligand. By passing N₂ gas through the solution, the surfactants sodium dodecyl sulfate and cetylpyridinium chloride generated foams that separated the dyes, Methylene blue and Orange G, respectively, from a solution containing both dyes. Sodium dodecyl sulfate condensed Methylene blue from the solution with high purity while cetylpyridinium chloride condensed Orange G with less purity. A range of concentrations (0.01–0.5 mmol/L) of dyes were used for separation. The condensability (volume and/or concentration) of the target compound increased as its concentration decreased. This novel separation method is a simple, rapid, inexpensive, and effective way to prepare samples and allows for the characterization of these impurities using sensitive analytical detection techniques.