Evaluation of different quantitative approaches for the determination of noneasily ionizable molecules by different atmospheric pressure interfaces used in liquid chromatography tandem mass spectrometry: Abamectin as case of study

The liquid chromatography tandem mass spectroscopy residue determination of compounds without any acidic or basic centers such as abamectin has been investigated. Several approaches regarding the interface used and adduct formation have been compared. The low acidity of the hydroxyl groups only made deprotonation feasible using the atmospheric pressure chemical ionization (APCI) interface. To obtain sufficient sensitivity for residue analysis, the Ion Sabre APCI interface was necessary. However, the sensitivity attained was lower than for monitoring adducts in positive ion mode. Using electrospray ionization, different adducts with Na+, NH4+, and Li+ were tested and compared. The best results were obtained for the ammoniated adduct in electrospray ionization (ESI) because of its high sensitivity and the presence of several product ions with similar abundance. The highest sensitivity was reached using an in-source fragment as precursor ion, leading to a limit of detection (LOD) of 2 microg/L with low relative standard deviation. The relatively high abundance of other transitions allowed abamectin confirmation at concentrations close to the LOD (6 microg/L). Alkali ions were found to be a suitable alternative to determine and confirm abamectin at residue levels. The [M + Na]+ also presented various product ions with similar abundance, which allowed confirmation at LOD levels. However, this LOD was found to be almost four times higher than with [M + NH4]+ because of the poor sensitivity of the transitions obtained. Although the use of Li+ facilitated the fragmentation of the adduct [M + Li]+, with similar sensitivity to [M + NH4]+, this fragmentation preferentially generated only one product ion, which did not allow confirmation at concentration levels lower than 15 microg/L. The use of APCI for monitoring adducts was also feasible, but with less sensitivity. The sensitivity increased with the Ion Sabre APCI, although it was still five times lower than with ESI. Other adduct formers such as Co2+ and Ni2+ also were tested with unsatisfactory results.     

Hydrolysis of new phthalimide-derived esters catalyzed by immobilized lipase

The last step of the production of four phthalimide-derived acids, designed to act as antiasthma drugs, was performed by enzymatic hydrolysis of the respective methyl or ethyl esters. The esters 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic methyl ester (PHT-MET), 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic ethyl ester, 4-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester, and 2-(1,3-dioxo-1, 3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester were hydrolyzed by immobilized lipase. The enzymatic reaction could be used only to produce the desired 4-substituted compounds. The best result that was found to hydrolysis of PHT-MET, and, therefore, that ester was selected for optimization experiments in a three-phase system. Reactions were performed with solid biocatalyst (Lipozyme® RM IM), organic solvent phase (ethyl acetate), and aqueous phase (saturated Na₂CO₃ solution). To optimize the reaction conditions, an experimental design optimization procedure was used. The variables studied were the amount of enzyme, the temperature, and the volume of the aqueous solution. Time course experiments were then performed for different initial enzyme concentrations (0.5, 0.9, and 1.4 U_H/mL of solvent). The optimized reaction conditions found were 20 mg of Lipozyme (0.9 U_H/mL_solvent) and 5.0 mL of Na₂CO_3(sat) at 40°C for 6 h.     

Temperature dependence of second critical micelle concentration of dodecyldimethylbenzylammonium bromide in aqueous solution

The specific conductivity of dodecyldimethylbenzylammonium bromide (C12BBr) in aqueous solutions, in the temperature range of 15 to 40 °C, has been measured as a function of molality. The two breaks which were found on the conductivity against molality plots were attributed to the critical micelle concentration, cmc, and second critical micelle concentration, 2^nd cmc, respectively. The ratio of the slopes, S, of the three linear fragments on the plots, S2/S1 and S3/S1, was attributed to the degree of ionization of the micelles at cmc and 2^nd cmc respectively. It was shown that the values of the 2^nd cmc estimated above 27 °C are only apparent due to thermal disintegration of the micelles. In the temperature range of 15 to 27 °C, the values of the 2^nd cmc increase gradually and the plot of the 2^nd cmc against temperature is concave. The ratio of 2^nd cmc/cmc for C12BBr at 25 °C amounts to 15 and appears to be high compared to the literature values for other surfactants. For comparative purposes the cmc and 2^nd cmc values were also estimated conductometrically for decyldimethylbenzylammonium bromide (C10BBr) at 25 °C. The 2^nd cmc value for this surfactant is higher compared to the value for the C12 homologue by a factor of 2.6.The standard Gibbs free energies of micellization at cmc and at the 2^nd cmc were estimated from the experimental data for both surfactants at 25 °C.     

Application of Graphite-Epoxy Composite Electrodes in Differential Pulse Anodic Stripping Voltammetry of Heavy Metals

An analytical study on the use of graphite-epoxy composite (GEC) electrodes for differential pulse anodic stripping voltammetry (DPASV) of heavy metals is presented. This study is accompanied by microscopic observations of the electrode surface before and after the stripping step in comparison to glassy carbon electrode. GEC electrodes show much better accumulation properties and consequently acceptable behaviour which makes them suitable as working electrodes in the DPASV of heavy metals. Lead determination in real water samples in a batch system as well as some preliminary results in a flow-through system are presented. The detection limits in batch measurements were 100ppb for Cd, 10pb for lead and 50ppb for copper. The detection limit for lead in the flow-through system was similar to that in the batch. The results obtained show that these low cost and easy to prepare materials can be of interest in future research concerning stripping techniques of heavy metals and other analytes.     

Determination of pesticides and some metabolites in different kinds of milk by solid-phase microextraction and low-pressure gas chromatography-tandem mass spectrometry

A new analytical method is proposed to determine more than 40 multiclass pesticides in different kinds of processed (whole, skimmed and powdered) and unprocessed (goat and human) milk samples using solid-phase microextraction (SPME). A comparative study between headspace (HS) and direct immersion (DI) was carried out. The effect of milk dilution and the use of acid to reduce the influence of the matrix in DI-SPME mode were also evaluated. DI of the SPME fiber into previously diluted and acidified milk samples achieved the best sensitivity results. Pesticides were determined using low-pressure gas chromatography-tandem mass spectrometry (LP-GC-MS/MS). Both of the selected techniques have been shown to be effective at reduce fat interference and can determine analytes present at very low concentrations (limits of quantification between 0.02 and 1.00 g L^–1). Performance characteristics such as linearity, recovery, precision, and lower limits, together with an estimation of the measurement uncertainty using validation data, are presented for each pesticide. All of the pesticides presented recovery rates of between 81 and 110% and precision values lower than 12% (expressed as the relative standard deviation). The overall uncertainty of the method was estimated at three different concentrations (10, 25 and 50 g L^–1) and was lower than 25.5% in all cases. The proposed analytical methodology was applied to the analysis of target pesticides in 35 samples: 15 commercial, 3 human and 17 goat milk samples. The metabolite p,p-DDE was the compound most frequently found in both the breast and goat milk samples, at concentration levels <20 g L^–1. However, pesticide residues were not found in any of the other 15 commercial milk samples (skimmed, powdered and whole milk) analyzed.     

Molecular-level control of the photoluminescence from PPV nanostructured films

The fabrication of varied molecular architectures in layer-by-layer (LbL) films is exploited to control the photoluminescence (PL) of poly(p-phenylene vinylene) (PPV) in an unprecedented way. This was achieved by controlling the F?rster energy transfer between PPV layers (donors) and layers of a commercial azodye, Brilliant Yellow (BY) (acceptors). Energy transfer was controlled by inserting spacer layers of inert polymers between PPV and BY layers and by photoaligning the BY molecules via trans-cis-trans isomerization. The PPV/BY LbL films displayed polarized PL whose intensity could be varied almost continuously by changing the time of photoalignment, which was carried out by impinging a linearly polarized laser light simultaneously to the PL experiments. For PPV/BY films with no spacer layers, PL was completely quenched, but its intensity increased with the number of spacing layers. Further increase in PL was obtained by photoaligning the BY molecules perpendicularly to the PPV molecules. This minimizes energy transfer, since F?rster processes are directional, dipole-dependent resonant transfers. Energy transfer is also controlled by imparting a preferential orientation of the PPV chains on PPV/BY LbL films deposited onto flexible Teflon substrates that may be stretched.     

Determination of aflatoxins in peanuts by matrix solid-phase dispersion and liquid chromatography

A new method based on matrix solid-phase dispersion (MSPD) extraction was studied to determine aflatoxin B1, B2, G1 and G2 from peanuts. Optimization of different parameters, such as type of solid supports for matrix dispersion and elution solvents were carried out. The method used 2 g of peanut sample, 2 g of C18 bonded silica as MSPD sorbent and acetonitrile as eluting solvent. Recoveries of each aflatoxin spiked to peanut samples at 2.5 ng/g (5 ng/g for aflatoxin G2) level were between 78 and 86% with relative standard deviations ranging from 4 to 7%. The limits of quantification ranged from 0.125 to 2.5 ng/g for the four studied aflatoxins using liquid chromatography (LC) with fluorescence detection. In addition, LC coupled to mass spectrometry with an electrospray interface was used for confirmation of aflatoxins present in real samples. Eleven peanut samples from different countries were analyzed by the proposed method and by using an enzyme-linked immunosorbent assay (ELISA). ELISA test is a good screening method for investigation of these mycotoxins in peanut samples.     

Production and purification of CGTase of alkalophylicBacillus isolated from Brazilian soil

Alkalophylic bacilli that produce cyclodextringlycosyltransferase (CGTase) were isolated from Brazilian soil, with a scheme of two plating steps. In the first step, the bacterial isolate forms a halo in the cultivation medium that contains γ-cyclodextrin (CD) complexing dyes. The CGTase of an isolate was purified 157-fold by biospecific affinity chromatography, with β-CD showing a mol wt of 77,580 Daltons. It produces a γ- to β-CD ratio of 0.156 and a small amount of α-CD, using maltodextrin 10% as substrate, at 50°C, pH 8.0 and 22 h reaction time, reaching 21.4% conversion of the substrate to cyclodextrins. In the second screening step, the isolates chosen give larger halos with β-CD complexing dyes, and smaller halos with β-CD complexing dyes, leading to a 30% improvement in γ-CD selectivity, although at lower total yield for cyclodextrins (11.5%).     

Particle-size distribution of polycyclic aromatic hydrocarbons in urban air in southern Spain

The size distribution of polycyclic aromatic hydrocarbons (PAH) was determined for airborne particles from a large city with high vehicular traffic. The analytical method was optimised and validated using NIST standard reference material (SRM 1649a Urban Dust). The 16 priority PAH listed in the US-EPA were Soxhlet-extracted from filtered particulate matter and then fractionated using on-column chromatography. The aromatic fraction was quantified by gas chromatography-mass spectrometry. Real samples of particles collected in Seville (Spain) were analysed using the validated method. Values for the total concentration of PAH in the air, as well as the concentrations of each PAH in six particle-size ranges were obtained. Values of the PAH in TSP, PM₁₀, PM_2.5 and PM₁ were assessed.     

A simple and fast micromethod for the analysis of polychlorinated biphenyls in air by sorbent enrichment and ultrasound-assisted solvent extraction

A combination of sorbent enrichment and ultrasound-assisted solvent extraction has been used to determine polychlorinated biphenyls in air. Analytes were sampled by pumping a known volume of air through a porous polymer (Tenax TA). The enriched adsorbent was transferred into a glass vial, and ultrasound-assisted extraction of the analytes was then performed in n-hexane. Quantification was carried out by using gas chromatography coupled to tandem mass spectrometry. Breakthrough volume of the sampling step was studied, indicating that 10 m³ of air could be processed without losses of the most volatile compounds. Good recoveries (75–96%) were obtained, and limits of detection at the sub ng m^–3 were achieved for all the analytes. The proposed method is very simple and fast, avoiding the use of large solvent volumes and time-consuming preconcentration steps.