Multi-mode wave propagation in ribbed plates: Part I,wavenumber-space characteristics

This paper addresses the issue of energy propagation features in ribbed panels over a wide frequency range. First, a tool for estimating the wave propagation characteristics of one- and two-dimensional structures by k-space analysis is presented. This tool uses a concept of Inhomogeneous Wave Correlation with sparse measured or extracted data, and leads to the estimation of θ-dependent wavenumbers. Here, the method is employed with the sparse simulated and measured normal velocities of a set of ribbed panels and new insights into their k-space behavior are highlighted. Behavior is essentially characterized at low frequencies by structural orthotropy. Comparisons with homogenized data show very good agreement. At higher frequencies, a new behavior pattern is observed and explained both numerically and experimentally. This is a multi-modal waveguide type of propagation in a direction parallel to the ribs.     

Application of the wavelet transform for a channel flow in a mixed convection phenomenon

The aim of this paper is to investigate laminar-turbulent transition in a mixed convection phenomenon occurring in a horizontal rectangular duct. Indeed, laminar-turbulent transition is well known in the case of forced convection but the presence of secondary flow induced by natural convection on this transition is not well highlighted. In this study, we will not be concerned by determining a critical threshold value of a Reynolds number of transition but only to estimate the degree of turbulence in the transition regime, i.e. weak turbulence in the case of a mixed convection phenomenon. This is possible thanks to the application of the wavelet transform. The calculation of the Hölder exponent, associated with the maximum value of the singularity spectrum for various experimental conditions allows the degree of turbulence to be measured. The variation of the Hölder exponent versus heat flux and Reynolds number enables us to show that there are two ways to go towards turbulence: thermal by increasing heat flux and hydrodynamic by increasing fluid velocity.     

Chlorination of aromatic substrates catalyzed by the phthalocyanine complexes

The chlorination of benzene, toluene, and o-xylene with molecular chlorine in the presence of the phthalocyanine complexes of different structures was studied. The transformations of the catalysts during the reaction were investigated. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1644–1647, August, 2008.     

4-Functionally-substituted 3-heterylpyrazoles: XIX. 3-aryl-4-(5-isoxazolyl)pyrazoles

Oximes of 4-(4-pyrazolyl)-3-buten-2-onees obtained by successive reaction of 3-aryl-4-formylpyrazoles with acetone and hydroxylamine at the treatment with iodine suffered an oxidative cyclization yielding 3-aryl-4-(5-isoxazolyl)pyrazoles.     

Influence of the composition of the polymer matrix on the electrooptical properties of films with a dispersed liquid crystal

Polymer films with a dispersed liquid crystal were prepared by photopolymerization of (meth)acrylic monomers. The electrooptical properties of these films were studied. The influence exerted by the composition of the monomer mixture, cross-linking agents, and chain-transfer agent on the liquid crystal drop size and on the transmission of the polymer-liquid crystal films was examined.     

Study of the dynamic structure factor of strong glasses

The dynamic structure factors (DSFs) of several strong glasses (SF6, SF10, BK7, SUPRASIL) measured by Brillouin light scattering spectroscopy are reported. Spectra have been collected, at and above room temperature, at two scattering angles, θ=90° and θ=180° corresponding to exchanged wavevector q values ranging from 0.0256 to 0.0448 nm⁻¹. In particular we find that the isotropic spectral lineshapes are in all cases well described by the simple hydrodynamic theory of an amorphous solid. The width of the Brillouin peaks are found to be consistent with the predicted q² dependence at both investigated temperatures. This damping is however found to account only partially for the strong asymmetry of the Brillouin line clearly visible on a logarithmic intensity scale. As a matter of fact there is an excess intensity in the very low frequency plateau underlying the central component. The height of this plateau and hence the entire lineshape is well reproduced if a relaxation process is taken into account in the hydrodynamic equations. Owing to the intense elastic scattering we are able to determine unambiguously only the ratio between amplitude and characteristic time of this process which quantifies the sound dispersion to be of the order of a few percent in all samples. The temperature dependence of the parameters indicates that this relaxation cannot be attributed to thermally activated relaxation phenomena. These general findings favorably compare with molecular dynamics simulation results on similar systems.     

Closed-form solutions for a rectangular layer with central crack under anti-plane shear stress

We consider the problem of determining the stress distributionin a finite rectangular elastic layer containing a Griffithcrack which is opened by internal shear stress acting alongthe length of the crack. The mode III crack is assumed to belocated in the middle plane of the rectangular layer. The followingtwo problems are considered: (A) the central crack is perpendicularto the two fixed lateral surfaces and parallel to the othertwo stress-free surfaces; (B) all the lateral surfaces of therectangular layer are clamped and the central crack is parallelto the two lateral surfaces. By using Fourier transformations,we reduce the solution of each problem to the solution of dualintegral equations with sine kernels and a weight function whichare solved exactly. Finally, we derive closed-form expressionsfor the stress intensity factor at the tip of the crack andthe numerical values for the stress intensity factor at theedges of the cracks are presented in the form of tables.     

Combined supercritical-fluid chromatography/mass spectrometry in the analysis of diuron in plasma using on-line phase-system switching

On-line sample pretreatment by means of the phase-system switching approach is an interesting technique for the analysis of aqueous samples, e.g., plasma, by means of supercritical-fluid chromatography. In order to analyse plasma samples the following analytical procedure is used. The plasma sample is injected on to a short precolumn, which is washed with water and subsequently dried with nitrogen. Next, the solutes are desorbed with the supercritical mobile phase, analysed with packed-column supercritical-fluid chromatography and detected with either a UV detector or a mass spectrometer, equipped with a moving-belt interface. The herbicide diuron is selected as a test compound to study the feasibility of this approach. Using a selective detector the procedure is sufficiently sensitive to detect diuron in plasma, but not appropriate to detect the diuron metabolites in a post-mortem plasma sample. These have been identified with liquid chromatography/mass spectrometry. The detection limit of diuron in plasma using the procedure described is about 30 ng/mL.     

Robust Speed Control of a Low Damped Electromechanical System Based on CRONE Control: Application to a Four Mass Experimental Test Bench

Robust speed control of a low damped electromechanical system with backlash is studied, controlled load angular speed being not measured. The proposed control strategy combines a Luenberger observer (load angular speed and load torque disturbance estimations) and a robust CRONE controller. The observer provides estimation of the load angular speed and of the disturbance torque applied on the load. Through the computation of only three independent parameters (as many as a PID controller), the CRONE controller permits to ensure the robust speed control of the load in spite of plant parametric variations and speed observation errors. The proposed control strategy is applied to a four mass experimental test bench.     

An improved numerical simulator for multiphase flow in porous media

In basin modelling the thermodynamics of a multicomponent multiphase fluid flux are computationally too expensive when derived from an equation of state and the Gibbs equality constraints. In this article we present a novel implicit molar mass formulation technique using binary mixture thermodynamics. The two proposed solution methods, with and without cross derivative terms between components, are based on a preconditioned Newton‐GMRES scheme for each time‐step with analytical computation of the derivatives. These new algorithms reduce significantly the numerical effort for the computation of the molar masses, and we illustrate the behavior of these methods with numerical computations. Copyright © 2004 John Wiley & Sons Ltd.