Synthesis,characterization and a thermogravimetric study of copper,cobalt and tin mono- and bis-adducts with ethyleneurea,ethylenethiourea and propyleneurea

This paper describes the synthesis, characterization and a thermogravimetric (t.g.) study of 11 adducts of general formula MCl₂·nL (M = Cu, Co and Sn; n = 1 and 2 for Sn, and 2 for Cu and Co; L = ethyleneurea eu, ethylenethiourea etu, and propyleneurea pu). The i.r. results shows that the eu and pu adducts are coordinated through oxygen, whereas for etu nitrogen is the coordination site. The (C=O) or (C=S) trend is: Cu > Co > Sn. The t.g. curves show that the adducts release ligand molecules in a single mass loss step. As regards considering adducts with the same stoichiometry, the observed thermal stability trend is: etu > pu > eu.     

Elucidating interactions of ionic liquids with polymer films using confocal Raman spectroscopy

We report on the molecular interactions between room-temperature ionic liquids (RTILs) and Nafion and PDMS membranes, proving that in contact with these polymers RTILs behave like electrolytes rather than solvents.     

Search on ruggedness of fast gas chromatography-mass spectrometry in pesticide residues analysis

In this study, suitability of fast gas chromatography-mass spectrometry (GC-MS) on a narrow-bore column with a programmed temperature vaporizer for the analysis of pesticide residues in non-fatty food was evaluated. The main objectives were ruggedness and stability of chromatographic system with regards to co-extractives injected. The chromatographic matrix induced response enhancement was found to be strongly dependent on the concentration of residues and is reaching up to 700% compared to the pesticides solutions in a neat solvent. However, the responses of pesticides in matrix-matched standards at different concentration levels do not significantly change during 130 injections. Response enhancement/or decrease is influenced by the sample preparation technique. External calibration with matrix-matched calibration standards should, therefore, provide results with good precision also at the concentration level of 0.005 mg kg(-1). Special attention is given to the performance of the chromatographic column and retention gap with regards to peak widths, peak tailing and different sample preparation methods. During approximately 460 matrix sample injections, the performance of the analytical column was acceptable. GC-MS set-up with 0.15 mm i.d. column can be successfully utilized for the pesticide residues analysis.     

Dynamic behavior of DNA base pairs containing 8-oxoguanine

The process by which DNA repair enzymes recognize and selectively excise damaged bases in duplex DNA is fundamental to our mechanistic understanding of these critical biological reactions. 8-Oxoguanine (8-oxoG) is the most common form of oxidative DNA damage; unrepaired, this lesion generates a G:C-->T:A mutation. Central to the recognition and repair of DNA damage is base extrusion, a process in which the damaged base lesion or, in some cases, its partner disengages from the helix and is bound to the enzyme's active site where base excision takes place. The conformation adopted by 8-oxoG in duplex DNA is affected by the base positioned opposite this lesion; conformational changes may also take place when the damaged base binds to its cognate repair enzyme. We performed unrestrained molecular dynamics simulations for several 13-mer DNA duplexes. Oligomers containing G:C and 8oxoG:C pairs adopted Watson-Crick geometries in stable B-form duplexes; 8oxoG showed increased local and global flexibility and a reduced barrier to base extrusion. Duplexes containing the G:A mismatch showed much larger structural fluctuations and failed to adopt a well-defined structure. For the 8oxoG:A mismatch that is recognized by the DNA glycosylase MutY, the damaged nucleoside underwent spontaneous and reproducible anti-->syn transitions. The syn conformation is thermodynamically preferred. Steric hindrance and unfavorable electrostatics associated with the 8oxoG O8 atom in the anti conformation were the major driving forces for this transition. Transition events follow two qualitatively different pathways. The overall anti-->syn transition rate and relative probability of the two transition paths were dependent on local sequence context. These simulations indicate that both the dynamic and equilibrium behavior of the duplex change as a result of oxidation; these differences may provide valuable new insight into the selective action of enzymes on damaged DNA.     

Determination of arsenic compounds in beverages by high-performance liquid chromatography-inductively coupled plasma mass spectrometry

Arsenic compounds including arsenous acid (As(III)), arsenic acid (As(V)), dimethylarsinic acid (DMA) and monomethylarsonic acid (MMA) were separated by high-performance liquid chromatography (HPLC) and detected by inductively coupled plasma mass spectrometry (ICP-MS). A Hamilton PRX-100 anionic-exchange column and a pH 8.5 K₂HPO₄/KH₂PO₄ 5.0 × 10⁻³ mol L⁻¹ mobile phase were used to achieve arsenic speciation. The separation of arsenic species provided peaks of As(III) at 2.75 min, DMA at 3.33 min, MMA at 5.17 min and As(V) at 12.5 min. The detection limits, defined as three times the standard deviation of the lowest standard measurements, were found to be 0.2, 0.2, 0.3 and 0.5 ng mL⁻¹ for As(III), DMA, MMA and As(V), respectively. The relative standard deviation values for a solution containing 5.0 μg L⁻¹ of As(III), DMA, MMA and As(V) were 1.2, 2.1, 2.5 and 3.0%, respectively. This analytical procedure was applied to the speciation of arsenic compounds in drinking (soft drink, beer, juice) samples. The validation of the procedure was achieved through the analysis of arsenic compounds in water and sediment certified reference materials.     

Quantitative separation of zinc traces from cadmium matrices by solid-phase extraction with polyurethane foam

A system for separation of zinc traces from large amounts of cadmium is proposed in this paper. It is based on the solid-phase extraction of the zinc in the form of thiocyanate complexes by the polyurethane foam. The following parameters were studied: effect of pH and of the thiocyanate concentration on the zinc extraction, shaking time required for quantitative extraction, amount of PU foam necessary for complete extraction, conditions for the separation of zinc from cadmium, influence of other cations and anions on the zinc sorption by PU foam, and required conditions for back extraction of zinc from the PU foam. The results show that zinc traces can be separated from large amounts of cadmium at pH 3.0±0.50, with the range of thiocyanate concentration from 0.15 to 0.20 mol l⁻¹, and the shaking time of 5 min. The back extraction of zinc can be done by shaking it with water for 10 min. Calcium, barium, strontium, magnesium, aluminum, nickel and iron(II) are efficiently separated. Iron(III), copper(II) and cobalt(II) are extracted simultaneously with zinc, but the iron reduction with ascorbic acid and the use of citrate to mask copper(II) and cobalt(II) increase the selectivity of the zinc extraction. The anions nitrate, chloride, sulfate, acetate, thiosulphate, tartarate, oxalate, fluoride, citrate, and carbonate do not affect the zinc extraction. Phosphate and EDTA must be absent. The method proposed was applied to determine zinc in cadmium salts using 4-(2-pyridylazo)-resorcinol (PAR) as a spectrophotometric reagent. The result achieved did not show significant difference in the accuracy and precision (95% confidence level) with those obtained by ICP–AES analysis.     

Determination of fat-soluble vitamins in yogurt by HPLC with electrochemical detection

A method employing HPLC with electrochemical detection for the rapid and simultaneous determination of vitamins A, D(3) and E is described. The method uses a C-18 reverse phase column and 2.5 mM HAcO-NaAcO in methanol-water (99:1, v/v) solution as the mobile phase. The compounds are quantified using amperometric detection with a glassy carbon electrode at a potential of + 1300 mV (vs. Ag/AgCl) and the results are compared with those obtained using UV detection at a wavelength of 280 nm. The method was successfully applied to the analysis of vitamins A, D(3) and E in yogurt samples. After saponification, fat-soluble vitamins were extracted and the methanolic solution of the extracts was injected directly into the chromatographic system, avoiding the clean-up step which is necessary when no electrochemical detection is used. Good recovery percentages were obtained.     

On-line coupling of liquid chromatography,capillary gas chromatography and mass spectrometry for the determination and identification of polycyclic aromatic hydrocarbons in vegetable oils

Summary An on-line combination of liquid chromatography, gas chromatography and mass spectrometry has been realized by coupling a quadrupole mass spectrometer to an LC-GC apparatus. Liquid chromatography was used for sample pretreatment of oil samples of different origin. The appropriate LC fraction, containing polycyclic aromatic hydrocarbons, was transferred to the gas chromatograph using a loop-type interface. After solvent evaporation through the solvent vapour exit and subsequent GC separation, the compounds were introduced into the mass spectrometer for detection and identification. The GC column was connected to a short piece of deactivated fused silica that protruded into the ion source. The total analytical set-up allowed the direct analysis of oil samples after dilution in n-pentane without any sample clean-up. Detection limits are about 40 pg in the full scan mode and about 1 pg with selective ion monitoring, i.e. 20 ppb and 0.5 ppb respectively.     

Effect of polyvinylalcohols on the thermostability of lipase fromCandida rugosa

Lipase fromCandida rugosa was stabilized against thermal inactivation in the presence of polyvinylalcohols (PVA) of different molecular weights. The apparent rate constant of the lipase inactivation, k_d, at 49°C is 0.049/min and 0.022/min in the absence and in the presence of PVA (mol wt 22,000), respectively. The improvement of the lipase thermostability by adding PVA was confirmed by differential scanning calorimetry. The presence of PVA had also an effect on the hydrolytic activity of the enzyme. Furthermore, lipase was modified by covalent linkage to PVA by means of an original procedure. With respect to the native enzyme, the modified lipase has a slightly lower specific activity, but it is more stable against heat denaturation (k _d 0.032/min at 49°C).     

Thermodynamic properties of citric acid and the system citric acid-water

The binary system citric acid-water has been investigated with static vapour pressure measurements, adiabatic calorimetry, solution calorimetry, solubility measurements and powder X-ray measurements. The data are correlated by thermodynamics and a large part of the phase diagram is given. Molar heat capacities of citric acid are given from 90 to 330 K and for citric acid monohydrate from 120 to 300 K. The enthalpy of compound formation Δ_comH (298.15 K)=(?11.8±1) kJ mole^?1.