Molecular distillation

Molecular distillation was studied for the separation of tocopherols from soya sludge, both experimentally and by simulation, under different operating conditions, with good agreement. Evaporator temperatures varied from 100°C to 160°C and feed flow rates ranged from 0.1 to 0.8 kg/h. The process pressure was maintained at 10⁻⁶ bar, the feed temperature at 50°C, the condenser temperature at 60°C, and the stirring at 350 rpm. For each process condition, samples of both streams (distillate and residue) were collected and stored at −18°C before tocopherols analyses. Owing to the differences between molecular weights and vapor pressures of free fatty acids and tocopherols, tocopherols preferentially remained in the residue at evaporator temperatures of 100°C and 120°C, whereas for higher temperatures (140°C and 160°C) and lower feed flow rate, tocopherols tended to migrate to the distillate stream.     

Characterization of xylitol dehydrogenase from debaryomyces hansenii

The xylitol dehydrogenase (EC 1.1.1.9) from xylose-grown cells ofDebaryomyces hansenii was partially purified in two Chromatographic steps, and characterization studies were carried out in order to inves tigate the role of the xylitol dehydrogenase-catalyzed step in the regu lation of D-xylose metabolism. The enzyme was most active at pH 9.0–9.5, and exhibited a broad polyol specificity. The Michaelis con stants for xylitol and NAD⁺ were 16.5 and 0.55 mM, respectively. Ca²⁺, Mg²⁺, and Mn²⁺ did not affect the enzyme activity. Conversely, Zn²⁺, Cd²⁺, and Co²⁺ strongly inhibited the enzyme activity. It was concluded that NAD⁺-xylitol dehydrogenase from D.hansenii has similarities with other xylose-fermenting yeasts in respect to optimal pH, substrate specificity, and K_m value for xylitol, and therefore should be named L-iditol:NAD⁺-5-oxidoreductase (EC 1.1.1.14). The reason D.hansenii is a good xylitol producer is not because of its value of K_m for xylitol, which is low enough to assure its fast oxidation by NAD⁺ xylitol dehydrogenase. However, a higher K_m value of xylitol dehydro genase for NAD⁺ compared to theK _m values of other xylose-ferment ing yeasts may be responsible for the higher xylitol yields.     

Analytical process control of the Celeste R&D installation of IPEN-CNEN/SP

Celeste-1 is a lab-scale hot cell intended for R&D work in reprocessing of low burn-up spent fuel elements. The studies are concerned with head-end, first separation cycle by Purex Process using mini mixer-settlers and development of analytical techniques. The analytical monitoring for process control purposes is based on several off-line techniques, such as X-ray fluorescence spectrometry, potentiometric titration, -and -spectroscopy, spectrophotometry, fluorimetry, density measurement and gas chromatography. The analytical treatment takes place in a shielded working place analytical hot cell, glove boxes and hoods and some final measurements are made in the associated analytical laboratory. A pneumatic system is used for transporting analytical samples. All analytical procedures are ready and in operation.     

PHOTOSENSITIZATION BY FENOFIBRATE. II. In vitro PHOTOTOXICITY OF THE MAJOR METABOLITES

Fenofibric acid, the major metabolite of fenofibrate, was found to be photolabile. Its irradiation in aqueous solution gave rise to two photoproducts, whose formation involves photodecarboxylation of the dissociated acid to an aryloxy-substituted carbanion, which is directly protonated or, alternatively, undergoes a Wittig rearrangement. A comparative in vitro phototoxicity study has been carried out on the anti-hyperlipoproteinemic drug fenofibrate, its metabolites and the photoproducts of fenofibric acid. Fenofibrate, fenofibric acid and its two photoproducts were found to be active when examined by the photohemolysis test and were able to photosensitize peroxidation of linoleic acid, as evidenced by the UV monitoring of dienic hydroperoxides. In summary, the major metabolite of fenofibrate (fenofibric acid), as well as its photoproducts, are phototoxic in vitro . This behavior can be attributed to the fact that the four compounds retain the benzophenone chromophore present in fenofibrate and is indicative of free radicalmediated photosensitization. In agreement with this rationalization, the metabolites with a reduced ketone functionality exhibit no detectable in vitro phototoxicity.     

Stabilisation of [Fe2(CO)9] and [Ru2(CO)9] bu substitution with bridging diphosphorus ligands

Reaction of [Fe₂(CO)₉] with a half molar amount of R₂PYPR₂ (Y = CH₂, R = Ph, Me, OMe or OPrⁱ; Y = N(Et), R = OPh, OMe or OCH₂; Y = N(Me), R = OPrⁱ or OEt) leads to the ready formation of a product which on irradiation with ultraviolet light rapidly decarbonylates to the heptacarbonyl derivative [Fe₂(μ-CO)(CO)₆{μ-R₂PYPR₂}]. Treatment of the latter with a slight excess of the appropriate ligand results, under photochemical conditions, in the formation of the dinuclear pentacarbonyl complex [Fe₂(μ-CO)(C))₄{μ-R₂PYPR₂}₂] but under thermal conditions in the formation of the mononuclear species [Fe(CO)₃{R₂PYPR₂}]. Reaction of [Ru₃(CO)₁₂] with an equimolar amount of (RO)₂PN(R′)P(OR)₂ (R′ = Me, R = Prⁱ or Et; R′ = Et, R = Ph or Me) under either thermal or photochemical conditions produces [Ru₃(CO)₁₀{μ-(RO)₂PN(OR)₂}] which reacts further with excess (RO)₂PN(R′)P(OR)₂ on irradiation with ultraviolet light to afford the dinuclear compound [Ru₂(μ-CO)(CO₄{μ-(RO)₂PN(R′)P(OR)₂}₂]. The molecular structure of [Ru₂(μ-CO)(CO)₄{μ-(MeO)₂PN(Et)P(OMe)₂}₂], which has been determined by X-ray crystallography, is described.     

Construction of 4D-QSAR Models for Use in the Design of Novel p38-MAPK Inhibitors

The p38-mitogen-activated protein kinase (p38-MAPK) plays a key role in lipopolysaccharide-induced tumor necrosis factor-alpha (TNF-alpha) and interleukin-1 (IL-1) release during the inflammatory process, emerging as an attractive target for new anti-inflammatory agents. Four-dimensional quantitative structure-activity relationship (4D-QSAR) analysis [Hopfinger et al., J. Am. Chem. Soc., 119 (1997) 10509] was applied to a series of 33 (a training set of 28 and a test set of 5) pyridinyl-imidazole and pyrimidinyl-imidazole inhibitors of p38-MAPK, with IC50 ranging from 0.11 to 2100 nM [Liverton et al., J. Med. Chem., 42 (1999) 2180]. Five thousand conformations of each analogue were sampled from a molecular dynamics simulation (MDS) during 50 ps at a constant temperature of 303 K. Each conformation was placed in a 2 angstroms grid cell lattice for each of three trial alignments. 4D-QSAR models were constructed by genetic algorithm (GA) optimization and partial least squares (PLS) fitting, and evaluated by leave-one-out cross-validation technique. In the best models, with three to six terms, the adjusted cross-validated squared correlation coefficients, Q2adj, ranged from 0.67 to 0.85. Model D (Q2adj = 0.84) was identified as the most robust model from alignment 1, and it is representative of the other best models. This model encompasses new molecular regions as containing pharmacophore sites, such as the amino-benzyl moiety of pyrimidine analogs and the N1-substituent in the imidazole ring. These regions of the ligands should be further explored to identify better anti-inflammatory inhibitors of p38-MAPK.     

Preparation and sedimentation behavior in magnetic fields of magnetite-covered clay particles

This work is devoted to the preparation of magnetite-covered clay particles in aqueous medium. For this purpose, magnetite nanoparticles were synthesized by a coprecipitation method. These magnetic particles are adhered to sodium montmorillonite (NaMt) particles in aqueous suspensions of both materials, by appropriate control of the electrolyte concentrations. The best condition to produce such heteroaggregation corresponds to acid pH and approximately 1 mol/L ionic strength, when the electrokinetic potentials (zeta-potential) of both NaMt and Fe3O4 particles have high enough and opposite sign, as demonstrated from electrophoresis measurements. When a layer of magnetite re-covers the clay particles, the application of an external magnetic field induces a magnetic moment in clay-magnetite particles parallel to the external magnetic flux density. The sedimentation behavior of such magnetic particles is studied in the absence or presence of an external magnetic field in a vertical direction. The whole sedimentation behavior is also strongly affected by the formation of big flocculi in the suspensions under the action of internal colloidal interactions. van der Waals and dipole-dipole magnetic attractions between magnetite-covered clay particles dominate the flocculation processes. The different relative orientation of the clay-magnetite particles (edge-to-edge, face-to-edge, and face-to-face) are discussed in order to predict the most favored flocculi configuration.     

Correlation between repeated measurements: bane and boon of the GUM approach to the uncertainty of measurement

With measurement uncertainty estimation accounting for all relevant uncertainty contributions, the results of measurements using the same procedure on different objects or samples may no longer be considered as being independent, and correlations have to be taken into account. For this purpose, a simple approximation for the estimation of covariances is derived and applied to the estimation of uncertainty for some basic combinations of two measurement results. This covariance estimate is also applied to the estimation of uncertainty for the mean value of the results of replicate measurements on the same object or sample.

Excess Molar Volumes and Liquid–Liquid Equilibria of the Ionic Liquid 1-Methyl-3Octyl-Imidazolium Tetrafluoroborate Mixed with Butan-1-ol and Pentan-1-ol

Experimental densities were measured for the system 1-methyl-3-octyl-imidazolium tetrafluoroborate [OMIM][BF₄] + butan-1-ol, + pentan-1-ol at 298.15 K and ambient pressure using a vibrating tube densimeter, taking into account the influence of the viscosity correction. Excess molar volumes V^E have been determined. V^E is quite small and negative in the alcohol-rich range of the mixture composition and positive in the alcohol-poor range. LLE data of [OMIM][BF₄] + pentan-1-ol have been measured using a laser light scattering cell for detecting cloud points at different compositions in the temperature range of 282–292 K. A miscibility gap with an upper critical solution temperature (UCST) of 292 K has been found.     

Influence of inhibitory compounds and minor sugars on xylitol production by <Emphasis Type="Italic">Debaryomyces hansenii</Emphasis>

To obtain in-depth information on the overall metabolic behavior of the new good xylitol producer Debaryomyces hansenii UFV-170, batch bioconversions were carried out using semisynthetic media with compositions simulating those of typical acidic hemicellulose hydrolysates of sugarcane bagasse. For this purpose, we used media containing glucose (4.3–6.5 g/L), xylose (60.1–92.1 g/L), or arabinose (5.9–9.2 g/L), or binary or ternary mixtures of them in either the presence or absence of typical inhibitors of acidic hydrolysates, such as furfural (1.0–5.0 g/L), hydroxymethylfurfural (0.01–0.30 g/L), acetic acid (0.5–3.0 g/L), and vanillin (0.5–3.0 g/L). D. hansenii exhibited a good tolerance to high sugar concentrations as well as to the presence of inhibiting compounds in the fermentation media. It was able to produce xylitol only from xylose, arabitol from arabinose, and no glucitol from glucose. Arabinose metabolization was incomplete, while ethanol was mainly produced from glucose and, to a lesser less extent, from xylose and arabinose. The results suggest potential application of this strain in xyloseto-xylitol bioconversion from complex xylose media from lignocellulosic materials.