Pyrylium-containing polymers as sensory materials for the colorimetric sensing of cyanide in water

A sensory polymeric material for the colorimetric sensing of cyanide in water has been developed based on the reactivity of this anion with the pyrylium cation.     

Developing an on-line derivatization of FAs by microwave irradiation coupled to HPLC separation with UV detection

The development of analytical methods for routine simultaneous identification and quantification of carboxylic fatty acids (CFAs) are required in different fields, such as, pharmaceutical cosmetics, food products and formulations of water–microemulsion–oil systems. Determination of CFAs has been developed mainly by gas chromatography (GC). As an alternative to GC, liquid chromatography (LC) has better sensitivity and selectivity. However, most CFAs show no useful absorption in ultraviolet–violet (UV–Vis) region, one of the more used detection technique in high-performance liquid chromatography (HPLC). In order to allow the use of UV–Vis detection, the use of pre-column derivatization has been reported to increase sensitivity and selectivity. Therefore, establishment of a simpler and faster on-line method with complete separation is needed for the screening of large numbers of samples. 2,4-Dinitrophenylhydrazine (2,4-DNPH.), benzoil chloride (BC), and phenylhydrazine (PH) were used for derivatization of different FAs by microwaves radiation (MW). After the on-line derivatization, products were separated and quantified by HPLC. Reactor coil was placed inside of microwaves oven at 450 W. Parameters as flow, amount of reagents, irradiation time, and chromatographic conditions were optimized. The continuous analysis using the MW–HPLC–UV system provided high sensitivity and reduced both the amount of reagent used and the analysis times. This proposed method can be used for the routine analysis of FAs contained in water–microemulsion–oil systems, to quantify the total acid fraction in each phase.     

直接甲醇燃料电池阴极电催化剂的研究进展

直接甲醇燃料电池(DMFC)功率密度高，燃料甲醇价格低廉、储存和携带方便，特别适合作为电动车和小型电子设备的电源，是目前燃料电池研究领域的一个热点。本文介绍了40年来DMFC阴极电催化剂的发展历史及现状，并针对目前严重影响DMFC性能的“甲醇透过”问题，阐述了研制耐甲醇阴极电催化剂的重要性，讨论了今后DMFC阴极电催化剂的发展趋势。     

Influence of the Meniscus at the Bottom of the Solid Plate on Imbibition Experiments

The analysis of the experiments on liquid imbibition into porous solids carried out by using the increase of weight technique proves the influence that meniscus formation has on the experimental increase of weight when the bottom of the porous layer is put in contact with the free surface of the liquid used to perform the penetration experiments. This process (meniscus onset) has a temporary dependence due to the change of the distance between the inferior base of the plate and the free surface of the liquid as a result of the imbibition. We have also found the proper experimental conditions under which such temporary dependence can be minimized after a short time after the start of contact between the porous layer and the free surface of the liquid utilized in the penetration procedure. Thus, the weight increase because of the meniscus formation can be assumed as a constant during the greatest part of the experiments, allowing the use of the proper mathematical form of Washburn's equation in order to describe the imbibition of the liquid into the pores of the solid. Copyright 2001 Academic Press.     

Chiral N-alkyl-2,4,6-triphenylpyridiniums as enantioselective triplet photosensitizers. laser flash photolysis and preparative studies

Three N-alkylpyridinium photosensitizers having chiral alkyl groups have been prepared by reacting 2,4,6-triphenylpyrylium tetrafluoroborate ion with (1R,2S)-(-)-norephedrine, (S)-(+)-2-(aminomethyl)pyrrolidine, and (R)-(-)-1-cyclohexylethylamine. Laser flash photolysis allows detection of the corresponding triplet excited states that are quenched by hydrogen atom donors and electron donors. Asymmetric quenching of the chiral triplet excited state was observed using enantiomerically pure 1,2-diamino cyclohexane as quencher. Low enantiomeric excess values (up to 7%) were measured for the photochemical cyclization of 5-methyl-4-hexenoic acid to its corresponding gamma-lactone using these chiral N-alkylpyridinium as photosensitizers.     

Determination of bromide by low power surfatron microwave induced plasma after bromine continuous generation

A simple continuous flow generation of volatile bromine is described for the determination of low concentrations of the elements by atmospheric-pressure argon microwave induced plasma (MIP) surfatron. Bromine is continuously generated by mixing the bromide with sulphuric acid and hypochlorite solutions. The bromine vapor is separated from the aqueous phase by a gas-liquid separator and is desiccated by passing it through concentrated sulphuric acid. The detection limit attained was 2 microg/l. and the precision was +/-0.7% (at the 80 microg/l. level). The proposed determination is very selective if oxidizing/reducing agents are absent. The procedure has been tested for bromide determination in two drug preparations. Good agreement between the experimental results and the certified values has been obtained.     

A one-pot synthesis to [(Me3Si)3SiSb]4; a potential precursor for Sb42-

The reaction of (Me(3)Si)(3)SiK[middle dot]18-crown-6 with SbCl(3)(3 : 1 equiv.) provides a simple route to the title complex [(Me(3)Si)(3)SiSb](4). The potassium base initially acts as a nucleophile and then as a coupling agent, forming Sb-Sb bonds.     

Development of pressurized liquid extraction and cleanup procedures for determination of organochlorine pesticides in soils

The scope of this work is the development of a rapid, reliable and sensitive method for the analysis of organochlorine pesticides from soils by pressurized liquid extraction (PLE). The effect of four parameters (temperature, pressure, static time and cell volume) on the extraction efficiency was studied. The great extracting power of the PLE causes the extraction of numerous interfering substances, so a more efficient purification of this extract was necessary. In this work several sorbents have also been assayed to carry out the purification of soil samples: Florisil, silica, alumina, carbon, as well as combinations of them. Finally, the proposed analytical method was validated using a certified reference soil material (CRM804-050) and the results were compared with those obtained by other extraction techniques (Soxhlet and microwave-assisted extraction).     

Conformational dynamics of a bispyridinium cyclophane

A complete study of the conformational behavior of 4,8-diaza-3(1,4),9(4,1)-dipyridina-1,6(1,4)-dibenzenacyclodecaphan-3(1),9(1)-bis(ilium) bishexafluorophosphate is described. This study allows us to conclude that the process observed by which the different chemical shifts of the pyridinium protons show coalescence at a high-temperature 1H NMR is the rotation around the C-N bond, whereas the conformational equilibrium between the four conformers is produced at low temperature.     

Evaluating the significance threshold in robustness testing. A critical discussion on the influence of time in molecular fluorescence spectrometry

Robustness experiments are performed in analytical chemistry to assess the behaviour of an analytical procedure under conditions slightly different from those of the experimental optimum. This work presents a study of robustness applied to a previously proposed fluorescent methodology using two replicated 2(7-4) saturated fractional factorial designs. A comparison is established between three different ways to test the significance of the effects of the variables involved on the response signal. Critical discussions about the most appropriate threshold to be introduced when testing for significance of the factors and the influence of the time necessary to carry out the experiments are included.