高效液相色谱/串联质谱法快速鉴定Z/E盐酸头孢吡肟异构体

采用高效液相色谱/串联质谱技术建立了快速鉴定Z型盐酸头孢吡肟原料药中E型异构体杂质的新方法。以乙腈-醋酸盐缓冲溶液(4∶96)为流动相经C18柱分离,通过高分辨电喷雾串联质谱在线检测,获得了相关的色谱和质谱信息。在所建立条件下,Z型盐酸头孢吡肟及其E型异构体杂质获得了有效分离,保留时间分别为5.22 m in和14.60 m in,同时它们的二级质谱及裂解方式呈现明显差异。本法能在无对照品情况下,快速、准确地分离鉴定盐酸头孢吡肟原料药中的Z/E异构体。     

铟封前后透射式GaAs光电阴极光谱响应特性的测试与分析

利用自行研制的光谱响应测试仪工程化样机,对透射式GaAs光电阴极在高温激活结束、低温激活结束以及铟封成管后的光谱响应特性进行了测试。结果显示,铟封后阴极整个响应波段的光谱响应下降,长波响应受到最显著的影响,表现为800~815 nm之间长波响应大幅度衰减,截止波长和峰值波长向短波移动,峰值响应和积分灵敏度减小,最终的光谱响应曲线变得平坦。阴极参量的计算结果反映铟封后阴极的表面逸出几率降低,说明铟封引起阴极表面激活层发生变化,使得能量较低的长波段光生电子不容易逸出,阴极长波响应和灵敏度随之降低。进一步分析了铟封过程中影响阴极表面激活层的因素。     

Optimizing the quasi-equilibrium state of hot carriers in all-inorganic lead halide perovskite nanocrystals through Mn doping: fundamental dynamics and device perspectives

Hot carrier (HC) cooling accounts for the significant energy loss in lead halide perovskite (LHP) solar cells. Here, we study HC relaxation dynamics in Mn-doped LHP CsPbI₃ nanocrystals (NCs), combining transient absorption spectroscopy and density functional theory (DFT) calculations. We demonstrate that Mn²⁺ doping (1) enlarges the longitudinal optical (LO)–acoustic phonon bandgap, (2) enhances the electron–LO phonon coupling strength, and (3) adds HC relaxation pathways via Mn orbitals within the bands. The spectroscopic study shows that the HC cooling process is decelerated after doping under band-edge excitation due to the dominant phonon bandgap enlargement. When the excitation photon energy is larger than the optical bandgap and the Mn²⁺ transition gap, the doping accelerates the cooling rate owing to the dominant effect of enhanced carrier–phonon coupling and relaxation pathways. We demonstrate that such a phenomenon is optimal for the application of hot carrier solar cells. The enhanced electron–LO phonon coupling and accelerated cooling of high-temperature hot carriers efficiently establish a high-temperature thermal quasi-equilibrium where the excessive energy of the hot carriers is transferred to heat the cold carriers. On the other hand, the enlarged phononic band-gap prevents further cooling of such a quasi-equilibrium, which facilitates the energy conversion process. Our results manifest a straightforward methodology to optimize the HC dynamics for hot carrier solar cells by element doping.

Mn doping modulates the hot carrier dynamics in all-inorganic lead halide perovskite nanocrystals according to the excitation energy.     

Radial flow velocity profiles of a yield stress fluid between smooth parallel disks

In rock grouting, idealized 2D-radial laminar flow of yield stress fluids (YSF) is a fundamental flow configuration that is used for cement grout spread estimation. A limited amount of works have presented analytical and numerical solutions on the radial velocity profiles between parallel disks. However, to the best of our knowledge, there has been no experimental work that has presented measured velocity profiles for this geometry. In this paper, we present velocity profiles of Carbopol (a simple YSF), measured by pulsed ultrasound velocimetry within a radial flow model. We describe the design of the physical model and then present the measured velocity profiles while highlighting the plug-flow region and slip effects observed for three different apertures and volumetric flow rates. Although the measured velocity profiles exhibited wall slip, there was a reasonably good agreement with the analytical solution. We then discuss the major implications of our work on radial flow.

     

高压烧结制备Tb掺杂n型(Bi1–xTbx)2(Te0.9Se0.1)3合金及其微结构和热电性能

采用高压烧结技术制备了稀土元素Tb掺杂的n型Bi2Te2.7Se0.3基纳米晶块体热电材料.将高压烧结成型的样品于633 K真空退火36 h.研究了Tb掺杂量对样品的晶体结构和热电性能的影响.结果表明,高压烧结制备的样品为纳米结构, Tb掺杂使样品的晶胞体积变大,功率因子增大,热导率降低,从而使ZT值提高.Tb掺杂量为x=0.004是最优的掺杂量,该掺杂量的高压烧结样品经退火处理后,于373 K时ZT值达到最大为0.99,并且在323-473 K范围内, ZT值均大于0.8,这对用于温差发电领域具有重要意义.     

一种超导重力仪磁悬浮力的等效计算

为实现超导重力仪磁悬浮力的精确计算,以GWR型超导重力仪为模型基础,采用有限元的思想,将超导球表面电流理想化为多个等高共轴电流环,计算出各个电流环与超导线圈的作用力,求和得到线圈与超导球间的磁悬浮力。利用MATLAB完成计算程序实现,通过改变下线圈电流和上、下线圈电流比,获得满足一定条件的磁悬浮力及其梯度。选取合适的模型参数,计算出线圈对质量为m=4.069 g超导球的磁悬浮力大小为:Ftotal=3.988×10^-2N,磁悬浮力梯度为:-9.699×10^-3N/m,此时悬浮力梯度合适,满足系统稳定性和灵敏度的要求。     

真空条件下LiCl溶液蒸发量随浓度变化规律研究

除湿溶液再生是除湿空调系统的核心过程,为了提高除湿溶液再生效率,以蒸发量作为评价标准,在不同的真空度下对不同浓度LiCl溶液进行再生。对不同再生条件下,溶液的再生情况进行数学模拟及实验研究,并将模拟结果与实验结果进行对比分析,结果表明,实验结果同模拟结果具有相同的变化趋势。在6 kPa和8 kPa的压强下,LiCl溶液的蒸发量随浓度的增大先上升后下降,而在1 kPa的压强下,LiCl溶液的蒸发量随浓度的增大呈现出先下降再升高接着又下降的趋势。     

Quantum Thermalization and Vanishing Thermal Entanglement in the Open Jaynes–Cummings Model

The quantum thermalization of the Jaynes–Cummings (JC) model in both equilibrium and non-equilibrium open-system cases is studied, in which the two subsystems, a two-level system and a single-mode bosonic field, are in contact with either two individual heat baths or a common heat bath. It is found that in the individual heat-bath case, the JC model can only be thermalized when either the two heat baths have the same temperature or the coupling of the JC system to one of the two baths is turned off. In the common heat-bath case, the JC system can be thermalized irrespective of the bath temperature and the system–bath coupling strengths. The thermal entanglement in this system is also studied. A counterintuitive phenomenon of vanishing thermal entanglement in the JC system is found and proved.     

Simultaneous measurement of SO_2 and NO_2 concentration using an optical fiber-based LP-DOAS system

SO2 and NO2 are the most important pollution in atmosphere.An optimized long path(LP)differential optical absorption spectroscopy(DOAS)system of high light intensity at an ultraviolet(UV)wavelength is proposed and used to measure the concentration of SO2 and NO2 simultaneously.In contrast to the traditional DOAS,the system adopted a Y-type optical fiber structure instead of a combination of mirrors in the telescope.The UV light intensity test shows that the light intensity of UV can arrive to above 80% of the max measuring range when the light path reaches 135 m,and the integral time of the spectrograph is only 15 ms.The system is proved to be efficacious through laboratory calibration.The maximum error of SO2 calibration is 4.19%,and is 5.22% for NO2.The error of the SO2 and NO2 mixture calibration is within 10%.Field measurement is implemented in a wastewater treatment plant in winter.The measurement light path is 738 m.The concentration of SO2 varies from 6μg/m^3(2.26 ppb)to 20μg/m^3(7.52 ppb),and the concentration of NO2varies from 100μg/m^3(53.2 ppb)to 200μg/m^3(106.4 ppb)approximately.The results are in accordance with the data from a monitoring station nearby in magnitude order and variation tendency mostly.     

Structure and Processing Properties of Nine Yam (Dioscorea opposita Thunb) Starches from South China: A Comparison Study

In order to explore the processing and application potential of Chinese yam starch, nine kinds of Chinese yam starch (GY11, GY5, GY2, GXPY, LCY, SFY, MPY, SYPY, ASY) from South China were collected and characterized. The chemical composition, rheological properties, thermal properties, and in vitro starch digestion were compared, and the correlation between the structure and processing properties of these yam starches was analyzed using Pearson correlation. The results show that GY2 had the highest amylose content of 28.70%. All the yam starches were similarly elliptical, and all the yam starch gels showed pseudoplastic behavior. Yam starches showed similar pasting temperatures and resistant starch content, but SYPY showed the largest particle size (28.4 μm), SFY showed the highest setback (2712.33 cp), and LCY showed the highest peak viscosity (6145.67 cp) and breakdown (2672.33 cp). In addition, these yam starches also showed different crystal types (A-type, B-type, C-type), relative crystallinity (26.54–31.48%), the ratios of 1045/1022 cm⁻¹ (0.836–1.213), pasting properties, and rheological properties, so the yam starches have different application potentials. The rheological and pasting properties were related to the structural properties of starch, such as DI, Mw, and particle size, and were also closely related to the thermodynamic properties. The appropriate processing methods and purposes of the processed products of these yam starches can be selected according to their characteristics.