粒子分辨CCT方法中的δ电子效应

提出了切伦科夫相关时间测量(CCT)中初始粒子在辐射体里产生的δ电子的干扰问题,以及降低干扰的方法. 通过模拟计算给出了北京τ-C工厂探测器初步设计中CCT的π/K分辨本领.     

超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。     

稳态锁模产生4ps激光脉冲

首次利用ＧａＡｓ光电导开关，控制Ｎｄ：ＹＬＦ激光器腔内Ｑ值，实现稳态锁模，获得脉宽和能量稳定性极高的４ｐｓ激光脉冲。     

Generation of red light at 660 nm by frequency doubling a Nd:YAG laser with periodically-poled stoichiometric LiTaO<Subscript>3</Subscript>

High power red light was generated from a periodically-poled stoichiometric LiTaO₃ (PPSLT) by single-pass frequency doubling of a diode-side-pumped, Q-switched Nd:YAG laser at 1319 nm. An average power of 2.4 W of the 660 nm red light was obtained at the fundamental power of ∼5.4 W with the conversion efficiency up to 44.4% and with low fluctuation down to 2%. The high efficiency and stability at the red output indicate that it is a practical method to construct a reliable compact red laser. PACS 42.70.Mp; 42.79.Nv; 42.55.Xi     

各向同性湍流中颗粒引起湍流变动的直接模拟

本文通过直接数值模拟对均匀各向同性湍流中颗粒对湍流的变动作用进行了研究.颗粒相的体积分数很小而质量载荷足够大,以至于颗粒之间的相互作用可以忽略不计,而重点考虑颗粒与湍流间能量的交换。颗粒对湍流的反向作用使得湍动能的耗散率增强,以至于湍动能的衰减速率增大.湍动能的衰减速率随颗粒惯性的增大而增大。三维湍动能谱显示,颗粒对湍动能的影响在不同的尺度上是不均匀的。在低波数段,流体带动颗粒,而高波数段则相反.     

STM/AFM studies of the evolution of morphology of electroplated Ni/W alloys

The surface morphology evolution of Ni/W alloys was studied, as a function of the alloy composition. Using the modified plating baths developed in our laboratory recently, electroplated Ni/W alloys with different W content, in the range of 7–67 atom percent (a/o), can be obtained. This was found to lead to different structures, ranging from polycrystalline fcc-Ni type structure to amorphous, followed by orthorhombic with increasing W content in the alloy. Powder XRD was studied to determine the crystal structures. Ex situ STM, AFM and SEM were used to study in detail the surface morphologies of the different alloys, and their evolution with increasing W content.

The important findings are that a mixture of two crystalline forms can give rise to an amorphous structure. Hillocks that are usually a characteristic of epitaxial growth can also exist in the amorphous alloys. Oriented scratches caused by stress can also be formed.

Up to 20 a/o of W is deposited in the alloys in crystalline form, with the fcc-Ni type structure. Between 20 and about 40 a/o an amorphous structure is observed, and above that an orthorhombic crystal structure is seen, which is characteristic of the NiW binary alloy. Careful choice of the composition of the plating bath allowed us to deposit an alloy containing 67 a/o W, which corresponds to the composition NiW₂.     

A comparison between degenerate paramagnetic oscillators and two-photon correlated-spontaneous-emission lasers

The degenerate parametric oscillator (DPO) is analyzed with the nonlinear material treated quantum mechanically. The source of squeezing in the DPO is the same as in the two-photon correlated-spontaneous-emission laser (CEL) — the level coherence. In this sense, they are similar. The amount of squeezing in DPO is the same as in the two-photon CEL at two-photon resonance, but the gain in DPO is usually much smaller than that in the two-photon CEL at two-photon resonance.     

矩孔金属光栅矢量模式理论的数值计算

根据矩孔金属光栅的矢量模式理论，计算了不同入射方向，波长及偏振态情况下衍射场的分布，研究了不同光栅结构对衍射效率，偏振态变化的影响；同时，根据实际需要，加工制作了一批不同深度的矩孔光栅样品，进行了实验测量，并将计算值与实验值进行了比较，两者基本相符。     

Characteristics of soft magnetic composite material under rotating magnetic fluxes

This paper reports the measurement of magnetic properties of the soft magnetic composite material SOMALOY^TM 500 in a square sample under different patterns of flux density with 2D magnetic excitations. The test system, principle of measurement, magnetic power loss calculation, and methods of correction for misalignment of H surface sensing coils are presented. The experimental results show that although nominally isotropic, the SOMALOY^TM 500 sample exhibits some anisotropy. The results are useful in the design and performance analysis of rotating electrical machines.     

(NH4)2MoS4在活性炭上浸渍过程的研究:Ⅱ.干燥机理及模型

（ＮＨ＿４）＿２ＭｏＳ＿４在活性炭上浸渍过程的研究Ⅱ．干燥机理及模型秦慧芳，张成芳，陆岗，俞丰，朱子彬（华东理工大学无机化工研究所，上海２００２３７）２３７）关键词硫代钼酸铵，活性炭，干燥，钼分布，干燥模型负载型催化剂的活性组分在载体上的分布，受浸渍...