聚乙炔的CH面外振动红外光谱研究

采用从头计算方法，计算了反式和顺式聚乙炔的氢原子在垂直于聚乙炔分子面方向振动的红外光谱，计算表明，Gibson等用红外吸收实验所测得的谱线的确是聚乙炔的CH面外振动产生的谱线，经100℃长时间加热后，顺式聚乙炔变为反式聚炔，但波数为740cm^-1的谱级仍保留5％的强度。     

K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

甲基红染料掺杂的聚乙烯醇薄膜光存储特性的实验研究

用2倍频小型YAG激光(532nm)作为写入光和擦除光,用He-Ne激光器623.8nm线作为读出光,用CCD作为探测器,研究了不同写入光功率下,甲基红/聚乙烯醇(MR/PVA)薄膜光栅生长的动力学过程和不同擦除光功率下,光栅擦除的动力学过程.结合光栅生长曲线的波动现象,对光存储机制进行了新的探讨.实验发现,两写入光和读出光的功率配比为1:1:1时,可获得最大衍射效率,提出读出光对写入过程具有双重作用的物理模型,对此实验结果给出了合理的解释.     

荧光波长对共焦显微镜成像特性的影响

导出了共焦显微镜中不同荧光波长情况下的荧光功率传输函数、三维脉冲响应函数（3D－PSF）和三维光学传递函数（3D－OTF）。结果表明，不同的荧光波长对共焦显微镜的空间截止频率、分辨率、光学传递函数存在明显的影响。当激发波长与荧光波长的比值下降到一定程度时，可以看到明显的失锥现象。     

基于偶联反应新极谱法测定痕量亚硝酸根的研究——Ⅱ.以苯酚为偶联试剂

本文研究了苯酚在氨性缓冲溶液中与NO_2~--磺胺重氮盐偶联反应的实验条件,建立了一个灵敏快速测定痕量NO_2~-的新方法。NO_2~-离子浓度在1.0×10~(-10)～4.8×10~(-7)g/ml范围内,与峰高呈良好的线性关系.4000倍量NO_3~-存在不干扰.     

Use of a long-spacer-side-chain liquid crystalline polysiloxane containing a crown ether as a stationary phase for capillary gas chromatography

A new kind of side chain liquid crystalline polysiloxane containing a crown ether with a longer spacer (PSC-11) has been prepared and coated on a fused silica capillary column. The main chroma-tographic characteristics including efficiency, polarity, and selectivity have been examined. The phase exhibits the retention properties of both liquid crystal and crown ether stationary phases and possesses higher efficiency and better selectivity than PSC-3, which has a shorter spacer between the main polysiloxane chain and liquid crystalline side chain.     

Extended X-ray absorption fine structure studies of thulium doped GaN epilayers

The local structure of Tm³⁺ ions incorporated into GaN epilayers was studied by means of Extended X-ray Absorption Fine Structure. The samples were doped either in situ during growth by Molecular Beam Epitaxy or by ion implantation of layers grown by Metal Organic Chemical Vapour Deposition. The implantation was done at ion energy of 300 keV and different nominal fluences of 3×10¹⁵, 4×10¹⁵ cm⁻² and 5×10¹⁵ cm⁻². The concentration of Tm in the samples studied was measured by Wavelength Dispersive X-ray analysis. For the in situ doped sample with concentration of 0.5%, and for all of the implanted samples, Tm was found on the Ga site in GaN. The ion implanted sample and an in situ doped sample with a similar concentration of Tm showed the same local structure, which suggests that the lattice site occupied by Tm does not depend on the doping method. When the average Tm concentration for in situ doped samples is increased to 1.2% and 2.0%, Tm is found to occupy the Ga substitutional site and the presence of a substantial number of Tm ions in the second coordination sphere indicates dopant clustering in the films. The formation of pure TmN clusters was found in an in situ doped sample with a dopant concentration of 3.4%.     

Unexpected end‐groups of poly(acrylic acid) prepared by RAFT polymerization

Low‐molecular‐weight poly(acrylic acid) (PAA) was synthesized by reversible addition fragmentation chain transfer polymerization with a trithiocarbonate as chain‐transfer agent (CTA). With a combination of NMR spectroscopy and matrix‐assisted laser desorption/ionization time‐of‐flight mass spectrometry, the PAA end‐groups of the polymer were analyzed before and after neutralization by sodium hydroxide. The polymer prior to neutralization is made up of the expected trithiocarbonate chain‐ends and of the H‐terminated chains issued from a reaction of transfer to solvent. After neutralization, the trithiocarbonates are transformed into thiols, disulfides, thiolactones, and additional H‐terminated chains. By quantifying the different end‐groups, it was possible to demonstrate that fragmentation is the rate limiting step in the transfer reaction. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5439–5462, 2004     

Influence of Particle Morphology and Flow Conditions on the Dispersion Behavior of Fumed Silica in Silicone Polymers

The dispersion behavior of agglomerates of several grades of fumed silica in poly(dimethyl siloxane) liquids has been studied as a function of particle morphology and applied flow conditions. The effects of primary particle size and aggregate density and structure on cohesivity were probed through tensile and shear strength tests on particle compacts. These cohesivity tests indicated that the shear strength of particle compacts was two orders of magnitude higher than the tensile strength at the same overall packing density. Experiments carried out in both steady and time‐varying simple‐shear flows indicate that dispersion occurs through tensile failure. In the steady‐shear experiments,enhanced dispersion was obtained at higher levels of applied stress and, at comparable levels of applied stress, dispersion was found to proceed faster at higher shear rates. Experiments conducted in time‐varying flows further corroborated the results obtained in tensile cohesivity tests. Experiments in which the mean and maximum stresses in the time‐varying flows were matched to the stresses produced in steady shear flows highlight the influence of flow dynamics on dispersion behavior.