全文获取类型
收费全文 | 33篇 |
免费 | 54篇 |
国内免费 | 42篇 |
专业分类
化学 | 59篇 |
数学 | 5篇 |
物理学 | 65篇 |
出版年
2023年 | 1篇 |
2022年 | 4篇 |
2021年 | 1篇 |
2020年 | 1篇 |
2019年 | 2篇 |
2017年 | 4篇 |
2016年 | 1篇 |
2015年 | 2篇 |
2014年 | 7篇 |
2013年 | 7篇 |
2012年 | 8篇 |
2011年 | 14篇 |
2010年 | 4篇 |
2009年 | 5篇 |
2008年 | 12篇 |
2007年 | 10篇 |
2006年 | 9篇 |
2005年 | 6篇 |
2004年 | 9篇 |
2003年 | 3篇 |
2002年 | 3篇 |
2001年 | 2篇 |
2000年 | 3篇 |
1997年 | 2篇 |
1996年 | 2篇 |
1995年 | 1篇 |
1994年 | 2篇 |
1992年 | 1篇 |
1989年 | 1篇 |
1987年 | 1篇 |
1980年 | 1篇 |
排序方式: 共有129条查询结果,搜索用时 15 毫秒
31.
32.
基于高定向热解石墨晶体(highly oriented pyrolitic graphite,HOPG)研制了一种新型反射式X射线谱仪.该谱仪具有高反射效率、较高能谱分辨率及相对较宽的能谱测量范围.根据计算,在相同的入射条件下,该谱仪的效率比一般X射线弯晶谱仪高3个量级;谱仪能谱分辨率理论值最高达350;理论探测范围是6.891keV至9.193 keV.我们将该谱仪应用在高功率密度激光与固体靶相互作用的实验中,发现在普通弯晶谱仪无法采到信号的实验条件下,HOPG谱仪依然采集到清晰的Cu K谱线.分析发现在8.048 keV(Cu的Kα光子能量)附近的能谱分辨能力最高达到40 eV,分辨率大于200. 相似文献
33.
提出一种利用组合透镜系统与渐变折射率光纤相结合改进激光 器管芯到单模尾纤耦合性能的新方法. 这种方法首先利用组合透镜系统对具有像 散的激光器输出光束进行整形, 然后采用渐变折射率光纤对整形后的光束进行聚焦处理, 并将处理后的的光束耦合进入普通单模光纤. 利用Jones矩阵理论分析表明, 采用这种方法可以得到86%的功率耦合效率, 1 dB插入损耗对应的渐变折射率光纤长度、 横向偏移和倾斜角容差分别为60 μm, 30 μm和2.4°, 且结构简单, 便于操作, 特别适合于大功率激射的激光模块到单模光纤的耦合. 对于提高激光器输出功率, 改善光束质量具有重要意义. 相似文献
34.
Characteristics and properties of metal aluminum thin films prepared by electron cyclotron resonance plasma-assisted atomic layer deposition technology 下载免费PDF全文
Metal aluminum (Al) thin films are prepared by 2450 MHz electron cyclotron resonance plasma-assisted atomic layer deposition on glass and p-Si substrates using trimethylaluminum as the precursor and hydrogen as the reductive gas. We focus our attention on the plasma source for the thin-film preparation and annealing of the as-deposited films relative to the surface square resistivity. The square resistivity of as-deposited Al films is greatly reduced after annealing and almost reaches the value of bulk metal. Through chemical and structural analysis, we conclude that the square resistivity is determined by neither the contaminant concentration nor the surface morphology, but by both the crystallinity and crystal size in this process. 相似文献
35.
In order to check the conceptual design of the subcritical blanket in a fusion-fission hybrid reactor, a depleted uranium/polyethylene simulation device with alternate shells has been established. The measurement of the 238U(n, 2n) reaction rate was carried out using an activation technique, by measuring the 208 keVγ rays emitted from 237U. The self-absorption of depleted uranium foils with different thicknesses was experimentally corrected. The distribution of the 238U(n, 2n) reaction rate at 90° to the incident D+ beam was obtained, with uncertainty between 5.3% and 6.0%. The experiment was analyzed using MCNP5 code with the ENDF/BVI library, and the calculated results are all about 5% higher than the measured results. 相似文献
36.
锂离子电池具有比能量高、质量轻、体积小、电压高、安全性好和无记忆效应等特点,而正极材料是其研究的重点.采用溶胶-凝胶法合成了锂离子电池的正极材料,结果表明,其初始容量高,循环性能理想,并且整个合成过程也较为简单,合成的温度相对较低,样品的颗粒比较均匀. 相似文献
37.
Liquid penetrations into hydrophobic capillaries are controlled by the adsorption and diffusion of the solute in the vicinity of the moving meniscus. The wetting process of microporous hydrophobic polyvinylidenefluoride (PVDF) and polytetrafluoroethylene (PTFE) membrane was investigated in both sodium dodecyl benzene sulphonate (SDBS) and diethanolamine (DEA) aqueous solutions. The experimental results revealed that wetting both the PVDF and PTFE membranes in SDBS solutions at high concentrations proceeded in two stages: rapid wetting and slow wetting, but this transition in the wetting rate was not observed during the membrane wetting at low SDBS concentration and in DEA solutions. The membrane wetting process was accelerated by increasing the solution temperature. 相似文献
38.
39.
在高强钢表面制备了防护性溶胶凝胶涂层,并研究了不同浓度二氧化硅纳米粒子的加入对于涂层形貌、耐蚀性和硬度的影响。采用扫描电子显微镜(SEM)和电子能谱(EDS)观察了涂层的微观结构和成分;采用显微硬度计测试了涂层的硬度;采用电化学方法研究了二氧化硅纳米粒子的浓度对于涂层耐蚀性能的影响;采用傅里叶红外光谱研究涂层的化学结构,进而探讨了二氧化硅纳米粒子对于涂层的强化机理。结果显示涂层加入二氧化硅纳米粒子的最佳浓度为500 mg.L-1,此条件下的涂层表面均匀致密,有较高的硬度并且在3.5%NaCl溶液中体现出较好的耐蚀作用。纳米粒子在溶胶中反应形成活性羟基基团并与硅烷发生反应生成空间网状结构,从而强化涂层。 相似文献
40.
Metalloporphyrins and crown ether groups were simultaneously supported on chloromethylated polystyrene resin to produce a series of polymer-supported catalysts. The synthesis of these catalysts has been studied. The influence of pH, concentrations of NaOCl and phase transfer catalysts on the epoxidation of styrene catalyzed by these catalysts has also been investigated. The experimental results show that manganese(III) porphyrin bound to chloromethylated polystyrene which bears crown ether groups is effective catalysts for the epoxidation of styrene by sodium hypochlorite. The introduction of crown ether groups increases the catalytic efficiency of supported metalloporphyrins. The kinetics of epoxidation catalyzed by supported manganese(III) porphyrins obeys Michaelis-Menten equation—the characteristic of enzyme-driven reaction. 相似文献