ICP-MS法测定不同采收时间宽叶荨麻中微量元素含量

采用微波消解,ICP-MS法分析不同采收时间宽叶荨麻中18种微量元素Al,Ba,Ca,Co,Cr,Cu,Fe,K,Li,Mg,Mn,Mo,Na,Ni,P,Pb,S和Zn的含量。该方法的相对标准偏差在1.2%～5.3%之间,加标回收率在95.4%～101.2%之间。结果表明宽叶荨麻中K,P,S,Ca,Na含量较高;Fe,Mg,Mn,Zn含量次之;有潜在生理毒性的元素Al,Cr,Pb的含量较低,并且在宽叶荨麻中微量元素呈现明显的季节性动态变化,此结果为进一步研究宽叶荨麻药理药效与微量元素的关系以及更好的开发这一资源提供理论数据。     

应用角谱方法研究聚焦声束在层状生物组织中的非线性声传播

应用角谱方法理论研究了聚焦声束在层状生物组织中的非线性传播特性，将声波分解为角谱，可计算垂直于声轴的任意平面的非线性声场。在圆形平面活塞聚焦换能器的焦区中插入多种生物组织样品，数值计算了样品内部及外部的二次谐波声场，并通过实验测量验证了理论方法的有效性。基于快速傅氏变换的角谱方法可直观地描述非线性声传播，对非线性声成像有指导作用。     

基于分时原理的多相流体比例分配方法

提出了从“时间”上对多相流进行分配的新思路,分析了分时分配的基本原理,并设计了具体的实现方式。在空气-水实验回路上对分时分配装置进行了实验研究和验证。分时分配的基本原理就是通过“分时”的方法,使整个分配器“空间”内的多相流都能按照给定的时间份额周期性地交替流向对应的支路,从而保证各支路内的多相流具有高度一致的相含量和确定的流量比例。实验研究证明,分时分配法具有切实的可行性,分流比等于分时比且与流量和流体的物性无关,仅取决于分配器的几何参数。     

A 168-W high-power single-frequency amplifier in an all-fiber configuration

We present a high-power,single-frequency,narrow linewidth fiber amplifier based on master oscillator power amplification chains in an all-fiber configuration.The effect of the delivery fiber on the maximum output power is studied.A home-made 1064-nm seed laser with a 20-kHz linewidth is boosted to 129 W,and limited by stimulated Brillouin scattering(SBS) when the delivery fiber is 1.2 m long.By shortening the delivery fiber length to 0.7 m,the SBS threshold is increased efficiently and the maximum output power rises to 168 W with an 82.9% power conversion efficiency.The experimental results indicate that the output power can be further raised by shortening the delivery fiber length and increasing the pump power.     

Complete condensation in a zero range process on scale-free networks

We study a zero range process on scale-free networks in order to investigate how network structure influences particle dynamics. The zero range process is defined with the rate p(n) = n(delta) at which particles hop out of nodes with n particles. We show analytically that a complete condensation occurs when delta < or = delta(c) triple bond 1/(gamma-1) where gamma is the degree distribution exponent of the underlying networks. In the complete condensation, those nodes whose degree is higher than a threshold are occupied by macroscopic numbers of particles, while the other nodes are occupied by negligible numbers of particles. We also show numerically that the relaxation time follows a power-law scaling tau approximately L(z) with the network size L and a dynamic exponent z in the condensed phase.     

Asymmetrically coupled directed percolation systems

We introduce a dynamical model of coupled directed percolation systems with two particle species. The two species A and B are coupled asymmetrically in that A particles branch B particles, whereas B particles prey on A particles. This model may describe epidemic spreading controlled by reactive immunization agents. We study nonequilibrium phase transitions with attention focused on the multicritical point where both species undergo the absorbing phase transition simultaneously. In one dimension, we find that the inhibitory coupling from B to A is irrelevant and the model belongs to the unidirectionally coupled directed percolation class. On the contrary, a mean-field analysis predicts that the inhibitory coupling is relevant and a new universality appears with a variable dynamic exponent. Numerical simulations on small-world networks confirm our predictions.     

Thermally switchable and discretely tunable comb filter with a linearly chirped fiber Bragg grating

We propose and experimentally demonstrate a novel switchable and discretely tunable comb filter based on a thermally induced linearly chirped fiber Bragg grating. Experimentally we achieved a thermally induced optical bandpass filter that has eight switchable passband peaks with peak separations of 1.6 and 3.2 nm, a very narrow bandwidth (as small as 10 pm) of each peak, a tunable range of 16.5 nm, and a greater than 25 dB rejection ratio. Two spectral peaks separated by only 0.8 nm were also obtained with this comb filter. This filter provides the unique advantages of an all-fiber structure, switchable spectral peaks, independent tuning of the center wavelength and wavelength spacing of the spectral peaks, low polarization sensitivity, simple structure, ease of fabrication, and low cost.     

N = 4 Supersymmetric Morse Oscillator and Its Spectrum-Generating Algebra

In this paper N = 4 supersymmetry of generalized Morse oscillators in one dimension is studied. Both bound states and scattering states of its four superpartner Hamiltonians are analyzed by using unitary irreducible representations of the noncompact Lie algebra su(1,1). The spectrum-generating algebra governing the Hamiltonian of the N = 4 supersymmetric Morse oscillator is shown to be connected with the realization of Lie superalgebra osp(1,2)or B(0,1) in terms of the variables of a supersymmetric two-dimensional harmonic oscillator.     

高强高效近红外光源的不同光源强度对玉米杂交种鉴别的影响

以2009年产自海南的农华101玉米种子作为研究对象,基于近红外漫透射光谱法(波长范围908.1~1 677.2 nm),研究了一种高强高效近红外光源在不同光源电压以及光源至光谱仪不同距离两种条件下对玉米杂交种鉴别的影响。对光谱进行一阶导数、矢量归一化的预处理后,使用主成分分析(PCA)和正交线性判别分析(OLDA)提取光谱特征,使用支持向量机(SVM)分别建立种子纯度鉴定模型,统计不同实验条件下的识别率。结果表明,在电压较低或者光源至光谱仪的距离较大的时候,光源强度较低,得到的光谱曲线有较多的毛刺,此时的识别率较低,增大电压或者降低光源至光谱仪的距离时,光谱曲线变得较为平滑,识别率明显升高,说明在一定范围内增大光源强度会提高模型的正确鉴定率。     

Spectral emissivity of type E235B low carbon structural steel with different roughnesses

A self-built experimental apparatus was employed to study the spectral emissivity of type E235B low carbon structural steel in the wavelength range 2–15 μm at different temperatures by energy comparison method. The surface roughness and topography of the steel E235B were determined by a roughness tester and a scanning electron microscopy, respectively. And then, the spectral emissivity of steel E235B with six different roughnesses was measured before and after oxidation. The measurement results showed that the spectral emissivity increased with the increasing temperature and surface roughness before oxidation. The effect of roughness on the spectral emissivity is different at different wavelength and temperature ranges. However, the oscillatory behavior of the spectral emissivity was observed after oxidation. To explore the possible reasons for emissivity variation, the changes of surface roughness and optical roughness were investigated after oxidation. It is found that both the surface roughness and optical roughness increased after oxidation. Although the optical roughness can be used as one of the parameters to evaluate the effect of surface roughness on the spectral emissivity, it is insufficient to describe the effect of surface morphology on the spectral emissivity.