电解液对LiCr0.1Mn1.9O4电化学性能的影响

容量;循环特性;自放电;电解液对LiCr0.1Mn1.9O4电化学性能的影响     

氯化银立方体微晶乳剂和{100}面扁平微晶乳剂的甲酸盐掺杂增感

将甲酸盐掺杂在乳剂微晶不同位置处,制备成氯化银立方体微晶乳剂和{100}面扁平微晶乳剂.实验发现:作为正空穴捕获剂,适当计量的甲酸盐在不增加乳剂灰雾的前提下,可使上述乳剂的感光度提升3—8倍.甲酸盐在两种晶形乳剂的不同位置掺杂的研究结果显示,甲酸盐均匀掺杂可比表面掺杂获得更高的感光度.在两种乳剂中甲酸盐掺杂增感都可与其后的硫增感、硫加金增感以及光谱增感协同作用,进一步提升乳剂的感光性能.     

2-呋喃甲硫醇修饰环糊精形成互锁式螺旋柱状超分子的自组装行为

利用单-(6-氧-对甲基苯磺酰基)-β-环糊精和2-呋喃甲硫醇反应得到单修饰环糊精, 单[6-硫-6-(2-甲基呋喃)]-β-环糊精. 通过X-ray衍射分析及核磁光谱等方法研究了其在溶液和固态中形成线状超分子的分子自组装行为. 结果表明, 化合物在固态中通过呋喃基团从第二面羟基连续插入到另一个环糊精的空腔, 形成了互锁式螺旋柱状超分子, 而且在溶液中也显示了相似的自组装行为, 其键合常数K及聚合度n分别为450 mol^-1·L和1.9.     

沉淀及老化温度对浆态床合成甲醇CuO/ZnO/Al2O3催化剂活性及稳定性的影响

利用浆态床反应器,考察了沉淀及老化温度对CuO/ZnO/Al₂O₃催化剂催化合成甲醇的活性及稳定性的影响,并用XRD、BET、FT-IR以及XPS等技术对前驱体及催化剂进行了表征。结果表明,前驱体物相主要以孔雀石(Cu₂(CO₃)(OH)₂)和类孔雀石((Cu,Zn)₂(CO₃)(OH)₂)为主,其中,70 ℃沉淀和80 ℃老化条件下制备的前驱体具有适当的结晶度,焙烧后的催化剂中CuO分布均匀,Cu元素的电子结合能位移最大,CuO与ZnO之间作用较强,催化剂的性能最佳,时空收率和失活率分别达到了153.3 g/(kg_cat·h)和1.44%/d。     

傅里叶变换红外光谱体表无创探测乳腺肿瘤

利用傅里叶变换红外(FTIR)光谱仪联合衰减全反射(ATR)探头的中红外光导纤维对46名健康志愿者及113名乳腺肿物患者的体表皮肤进行无创红外光谱测定, 并从分子水平比较、分析了正常乳腺和有肿物乳腺体表皮肤的红外光谱特征. 结果表明, 健康志愿者乳房皮肤8个FTIR光谱测定部位的图谱趋于一致; 正常乳腺体表与有肿瘤乳腺体表的吸收峰差异明显, 而1080 cm^-1处核酸相关吸收峰的变化对鉴别肿瘤的良、 恶性有重要意义.     

锂离子电池负极材料Li4Ti5O12的半固相法制备及碳包覆改性

由半固相法制得锂离子电池负极材料Li4Ti5O12,并研究了Li4Ti5O12的碳包覆改性.采用XRD、SEM、TEM以及HRTEM观察和分析产物的相结构与形貌.采用恒流充放电、循环伏安法和交流阻抗技术测试了材料的电化学性质.结果表明,Li4Ti5O12因颗粒团聚电化学性能严重下降,该电极在0.1C和0.5C首周期放电容量分别为121.7和87.6 mAh·g-1;碳包覆Li4Ti5O12/C材料呈球形分布,能抑制颗粒团聚,该电极倍率<0.5C时的放电比容量大于180 mAh·g-1,超过Li4Ti5O12的理论放电比容量(175 mAh·g-1);在1C、5C和10C倍率下,其容量仍保持在136、79.9和58.3 mAh·g-1,碳包覆改性材料具有优异的循环寿命和高倍率性能.     

Electronic Coupling between Two Amine Redox Sites through the 5,5′‐Positions of Metal‐Chelating 2,2′‐Bipyridines

Electron delocalization of new mixed‐valent (MV) systems with the aid of lateral metal chelation is reported. 2,2′‐Bipyridine (bpy) derivatives with one or two appended di‐p‐anisylamino groups on the 5,5′‐positions and a coordinated [Ru(bpy)₂] (bpy=2,2′‐bipyridine), [Re(CO)₃Cl], or [Ir(ppy)₂] (ppy=2‐phenylpyridine) component were prepared. The single‐crystal molecular structure of the bis‐amine ligand without metal chelation is presented. The electronic properties of these complexes were studied and compared by electrochemical and spectroscopic techniques and DFT/TDDFT calculations. Compounds with two di‐p‐anisylamino groups were oxidized by a chemical or electrochemical method and monitored by near‐infrared (NIR) absorption spectral changes. Marcus–Hush analysis of the resulting intervalence charge‐transfer transitions indicated that electron coupling of these mixed‐valent systems is enhanced by metal chelation and that the iridium complex has the largest coupling. TDDFT calculations were employed to interpret the NIR transitions of these MV systems.     

微电极阵列芯片的脂质体电融合研究

利用旋转蒸发法制作基于大豆卵磷脂的一种大型脂质体,在微电极阵列芯片上进行脂质体电融合实验研究.在电融合过程中,利用介电电泳力实现脂质体在微流控芯片中的排队,再利用高场强的电脉冲使脂质体膜发生可逆性电穿孔,在持续的介电电泳力作用下,使穿孔的脂质体实现融合.芯片上脂质体的融合率可以达到20％左右.而且,玻璃基底材料和低深宽比的通道结构更有利于脂质体融合过程的观察与控制.     

A structurally ordered thiophene-thiazole copolymer for organic thin-film transistors

This paper reports a new donor-acceptor copolymer semiconductor, PTBTh, comprising bithiophene and bithiazole where the regular coplanar structure and the intramolecular charge transfer are expected to increase the opportunity for --- stacking and charge transport. The AFM image shows lamellar stacking of the polymer on the surface. The field-effect transistor (FET) properties of PTBTh have been evaluated by a bottom-contact/bottom-gate TFT configuration. The device showed a high hole mobility of 1.14×10-2 cm2 V-1 s-1 and a current on/off ratio of 3×105 with the polymer thin film annealed at a mild temperature of 120 ℃ when measured under ambient conditions.     

Synthesis of biodiesel from rapeseed oil catalyzed by Ca/A1 solid base

采用共沉淀法制备了Ca/Al复合氧化物固体碱催化剂,考察了沉淀剂种类、Ca/Al摩尔比、沉淀温度、溶液pH值、老化时间和焙烧温度等制备条件对其催化剂活性的影响.采用正交实验方法得到制备Ca/Al复合固体碱催化剂前躯体的最佳制备条件为,沉淀剂NaOH,Ca/Al摩尔比为3,沉淀温度为60℃,沉淀过程中pH值保持在10,在90℃老化18h.在该最优条件下制备的催化剂前驱体主要以Ca4Al2 O6(NO3)2· 10H2O晶相存在,在N2气保护下300℃焙烧2h后,催化剂形成高分散钙铝复合氧化物,且碱性强度达到26.5以上.在催化菜籽油和甲醇的酯交换反应中,菜籽油的转化率达到95％,脂肪酸甲酯的质量分数为95.9％.