Effect of Mn-site vacancies on the magnetic entropy change and the Curie temperature of La0.67Ca0.33Mn1−xO3 perovskite

Single-phase polycrystalline samples of La_0.67Ca_0.33Mn_1−xO₃ (x=0.00, 0.02, 0.04, 0.06) have been prepared using the sol-gel method. The structure, magnetocaloric properties and the Curie temperature of the samples with different Mn vacancy concentrations have been investigated. The experimental results show that vacancy doping at the Mn-sites has a significant influence on the magnetic properties of La_0.67Ca_0.33Mn_1−xO₃. The Curie temperature decreases monotonically with increasing the Mn-site vacancy concentration x. A remarkable enhancement of the magnetic entropy change has been obtained in the La_0.67Ca_0.33Mn_0.98O₃ sample. The entropy change reaches |ΔS_M|=3.10 J kg⁻¹ K⁻¹ at its Curie temperature (264 K) under an applied magnetic field H=10 kOe, which is almost the same value as that of pure Gd.     

Negative and positive lateral shift of a light beam reflected from a grounded slab

We consider the lateral shift (LS) of a light beam reflecting from a dielectric slab backed by a metal. It is found that the LS of the reflected beam can be negative while the intensity of reflected beam is almost equal to the incident one under a certain condition. The explanation for the negativity of the LS is given in terms of the interference of the reflected waves from the two interfaces. It is also shown that the LS can be enhanced or suppressed under some other conditions. The numerical calculation on the LS for a realistic Gaussian-shaped beam confirms our theoretical prediction.     

Radially polarized and passively Q-switched Nd:YAG laser with composite structure of gain medium

We report on a radially polarized and passively Q-switched Nd:YAG/Cr4+:YAG laser.The bulk Nd:YAG crystal is bonded with two undoped YAG crystal end caps to weaken the thermal lens e?ect and thus,enhance the extraction of stored energy in the bulk gain material.In the absence of active water cooling,the average laser power reaches 383 mW with 33% slope efficiency,and the laser pulse achieves 1.457-W peak power,18.9-ns duration,and 13.9-kHz repetition rate with 97.6% polarization purity.     

One-pot synthesis of uniform hollow cuprous oxide spheres fabricated by single-crystalline particles via a simple solvothermal route

Uniform Cu₂O hollow spheres fabricated by single-crystalline particles (smaller than 20 nm) are facile synthesized in ethylene glycol (EG) solution by a simple solvothermal route without using pre-fabricated templates and reductive agents. EG in this protocol is not only used as a solvent, complexing agent, and reducing agent, but also served as a structure-directing agent for the formation of hollow structure. By control of reaction conditions, such as reaction time, temperature, and the anions, the morphology and structure of the hollow spheres can be tuned. A coordination adsorption and oriented attachment and Ostwald ripening mechanism is proposed for explaining the formation process of hollow Cu₂O spheres in EG solution; and importantly, the hollow Cu₂O spheres exhibit an excellent property for the electro-catalytic oxidization of ascorbic acid in acetic acid buffer solution. Moreover, the hollow spherical Cu₂O particles could be potentially applied in catalysis, sensor, and as model for fundamental research.     

Efficient and wavelength-tunable anti-Stokes frequency conversion with good beam quality in the fundamental mode of photonic crystal fiber

Using the photonic crystal fiber (PCF) with the zero dispersion wavelength of 848 nm for the fundamental mode, the efficient anti-Stokes signal generations from 645 to 543 nm are realized by pumping in the normal dispersion region. When the pump average power increases from 200 to 500 mW, the output power of the anti-Stokes signal increases 8.46 times, the power ratio of the anti-Stokes signal at 543 nm to the residual pump is calculated as 22.6:1, and the conversion efficiency η in the experiment can be up to 46%. Moreover, good optical beam quality of the anti-Stokes signal can be achieved.     

AlF<Subscript>3</Subscript> coating of LiNi<Subscript>0.5</Subscript>Mn<Subscript>1.5</Subscript>O<Subscript>4</Subscript> for high-performance Li-ion batteries

AlF₃-coating is attempted to improve the performance of LiNi_0.5Mn_1.5O₄ cathode materials for Li-ion batteries. The prepared powders are characterized by scanning electron microscope, powder X-ray diffraction, charge/discharge, and impedance. The coated LiNi_0.5Mn_1.5O₄ samples show higher discharge capacity, better rate capability, and higher capacity retention than the uncoated samples. Among the coated samples, 1.0 mol% AlF₃-coated sample shows highest capacity after charge–discharged at 30 mA/g for 3 cycles, but 4.0 mol% coated sample exhibits the highest capacity and cycling stability when cycled at high rate of 150 and 300 mA/g. The 40th cycle discharge capacity at 300 mA/g current still remains 114.8 mAh/g for 4.0 mol% AlF₃-coated LiNi_0.5Mn_1.5O₄, while only 84.3 mAh/g for the uncoated sample.     

In-band pumped Er:YAG ceramic laser with 11 W of output power at 1645 nm

We report on a high power polycrystalline Er:YAG ceramic laser in-band pumped by a cladding-pumped Er, Yb fiber laser wavelength locked at 1532 nm with a volume Bragg grating. Using 1.0 at % Er³⁺-doped ceramic as the gain medium and an output coupler of 10% transmission, the laser had a threshold pump power of ∼1.5 W and generated 11 W of continuous-wave output at 1645 nm for 23.3 W of incident pump power at 1532 nm, corresponding to a slope efficiency with respect to incident pump power of 51%.     

Diode-pumped Pr<Superscript>3+</Superscript>:YAlO<Subscript>3</Subscript>/LBO violet laser at 374 nm

We report a diode-pumped Pr³⁺:YAlO₃ laser emitting at 747 nm. A power of 232 mW at 747 nm has been achieved in continuous-wave operation with a diode emitting 2 W at 448 nm. Furthermore, intracavity second-harmonic generation in continuous-wave mode has also been demonstrated with a power of 52 mW at 374 nm by using a LBO nonlinear crystal. The fluctuation of the violet output power was better than 2.3%. The beam quality M ² value is 2.2.     

Multilayer dielectric cylindrical mirrors based on omnidirectional reflection from a one-dimensional photonic crystal

A multilayer dielectric cylindrical mirror (MDCM) based on the one-dimensional omnidirectional reflection of a photonic crystal is presented. In this case, the refractive indices of the two materials are 1.6 (polystyrene) and 4.6 (tellurium), and the corresponding optimized thicknesses are 0.75a and 0.25a. A very high reflectance over a wide frequency range is observed. In this case, a is the lattice constant of the photonic crystal. In this band, the MDCM has good reflection and focal properties. Therefore, it is feasible to use the MDCM for integrated waveguide devices. As an example, an etched diffraction grating demultiplexer based on the MDCM is also proposed. Both the operational principle and design of the device are introduced. This provides a method for designing compact integrated waveguide devices.