Selective Determination of Trace Mercury (II) after Preconcentration with 4-(2-Pyridylazo)-Resorcinol-Modified Nanometer-Sized SiO2 Particles from Sample Solutions

A rapid, selective method that utilize 4-(2-Pyridylazo)-resorcinol (PAR)-modified nanometer SiO₂ (nanometer SiO₂–PAR) as a new solid-phase extractant for preconcentration of trace mercury (II) has been developed. The adsorption property of nanometer SiO₂–PAR for metal ions was studied by selectively extracting different metal ions from aqueous solutions. The results revealed an excellent affinity of the nanometer SiO₂–PAR for mercury (II) in presence of interfering metal ions at pH 4. The main parameters of solid-phase extraction such as shaking time, elution and sample dilution effect were studied. The extractant shows rapid kinetic sorption, and the adsorption equilibrium of mercury (II) on nanometer SiO₂–PAR was achieved in less than 2 min. The adsorbed mercury (II) was easily eluted by 4 mL of 6 mol L⁻¹ HCl. The maximum preconcentration factor was 50. The maximum static adsorption capacity was 276 μmol g⁻¹ at pH 4. The detection limit (3σ) was 0.43 μg L⁻¹ for cold vapor atomic absorption spectrometry (CVAAS), and the relative standard deviation of the eight replicate determinations was 2.4% for the determination of 2.0 μg of Hg(II) in 100 mL water sample. The method was applied to the determination of trace mercury (II) in sample solutions with satisfactory results.     

Physically adsorbed chiral stationary phase of avidin on monolithic silica column for capillary electrochromatography and capillary liquid chromatography

The physical adsorption method proposed previously has been successfully applied to a monolithic silica column. By virtue of the physical adsorption, a chiral stationary phase of avidin was prepared onto the silica monolith. The phase ratio of resulting stationary phase was evaluated with frontal analysis. The method proved to be comparable in phase ratio to the chemical bonding methods used in high-performance liquid chromatography (HPLC). Enantiomer separations were carried out in capillary electrochromatography (CEC) and capillary liquid chromatography (CLC) modes. Due to its larger phase ratio, the resulting column showed more powerful separation capability as compared to open-tubular CEC (OTCEC). Twelve chiral compounds were baseline-resolved. The resulting column showed high separation efficiency, with average theoretical plate numbers of 66 000/m for CLC and 122 000/m for CEC. Good reproducibility was observed, with RSD value less than 1.3% for retention time, retention factor and separation factor, and less than 6.6% for plate counts and resolution (n = 40). Fast separations were achieved with a short column. The test enantiomers were baseline-resolved within 4 min under CLC and CEC modes. In addition, field-enhanced sample injection (FESI) was coupled to CLC as well as CEC to improve the detection sensitivity.     

氮杂冠醚研究Ⅶ、双仲胺型氮杂冠醚对过渡金属离子的选择性萃取作用

合成了五种新型双仲胺型氦杂冠醚，研究了它们对过渡金属离子进行液—液萃取，并用原子吸收法测定其浓度。实验结果表明：这类冠醚对Ａｇ￣＋、Ｐｄ￣（２＋）、和Ｐｔ￣（４＋）等贵金属离子有较强的选择配位性能，对选择性分离这些金属离子有重要的意义。     

壳聚糖修饰玻碳电极卷积伏安法测定环境水中的EDTA

制备了壳聚糖修饰玻碳电极 ,研究了Fe(EDTA) -在修饰电极上的吸附还原行为 ,用卷积伏安法通过Fe(EDTA) -的检测测定了环境水中的EDTA。在优化的实验条件下 ,峰电流值与 8.0× 1 0 -7～ 5 .0× 1 0 -6mol L的EDTA呈线性关系 ,回归方程为epp′ =0 .75 2 5c - 0 .661 3,r =0 .991 ,最低检出限为 5 .0× 1 0 -7mol L ,5次测定的相对标准偏差小于 5 .8%。对实际样品测定的回收率为98 1 %～ 1 0 5 % ,对比HPLC的结果 ,相对偏差小于 5 %。     

有机-无机杂化凝胶法合成YAG∶Ce~(3+)荧光粉的包膜及其稳定性

本文以金属硝酸盐为原料,柠檬酸为配位剂的有机-无机杂化凝胶法来合成掺杂三价铈离子的钇铝石榴石荧光粉,采用X-射线衍射法研究了杂化凝胶在煅烧过程中的相转变机制。结果表明:杂化凝胶在煅烧过程中可以通过两条途径形成Y3Al5O12(YAG)相:一是由无定形Y2O3和Al2O3直接向YAG相的一步相转变;二是由无定型Y2O3和Al2O3经由YAlO3(YAP)和γ-Al2O3向YAG相的两阶段相转变,在900℃得到结晶性好的纯YAG∶Ce3 荧光粉,其最大激发波长为459nm,最大发射峰波长为550nm;在荧光粉表面包覆氧化铝和氧化镧,将使荧光粉的荧光强度稍有降低,但对荧光粉的稳定性有很好的改进作用。     

不熔化沥青球在低速流化床中炭化和活化的初步研究

不熔化沥青球在低速流化床中炭化和活化的初步研究乔文明，王克温，凌立成，刘朗周承泽，王瑾，郑斌（中国科学院山西煤炭化学研究所，太原０３０００１）（上海太平洋化工（集团）公司焦化总厂，２００２４１）关键词低速流化床，活化，炭化，球形活性炭由于球形活性炭，...     

Fe-Co-Ni合金纳米线有序阵列的模板合成与磁性

以二次阳极氧化的氧化铝膜为模板，用电化学沉积的方法成功地合成了Fe-Co-Ni三组份有序纳米线阵列.扫描电子显微镜（SEM）和透射电子显微镜(TEM)观察表明纳米线表面光滑、有序、高长径比；磁性测量表明,其矫顽力较同组份的膜材料有较大的提高.将样品在惰性气体氛围中不同温度下退火，随着退火温度增加，其纵向矫顽力有一个极值，而对应的横向矫顽力没有类似的变化，关于这一现象的机理,本文进行了初步的讨论. 图5参15     

Electrodeposition of nanocrystalline zinc from acidic sulfate solutions containing thiourea and benzalacetone as additives

Nanocrystalline zinc coatings were produced by pulse electrodeposition in acid sulfate bath containing thiourea and benzalacetone additives and characterized by X-ray diffraction and scanning electron microscopy techniques. The influence of benzalacetone concentration and pulse peak current density on the grain size and crystallographic orientation of zinc deposits was investigated. Zinc electrodeposited from additive-free solutions or with one of the two additives is not composed of nanosized crystals. The mixture additives of thiourea and benzalacetone give rise to the formation of particle-like nanocrystalline zinc with a (10ī1) random orientation. A change in peak current density from 2 to 1 A/cm² only increases the grain size from 60 to 62 nm.     

Formation and structure of a novel enediyne-RNA base covalent adduct

The structure of an unusual covalent adduct formed by thiol-activated neocarzinostatin chromophore (NCS-chrom) and a RNA-DNA hybrid having an overhang of four unpaired residues at the 3'-end of the RNA strand has been elucidated by MS and NMR spectroscopic analyses. Unlike previously characterized adducts formed by NCS-chrom on the sugar residue of the DNA target, this adduct has been found to be on one of the uracil bases in the RNA overhang. Covalent linkage is between C-6 of the post-activated NCS-chrom and C-5 of the uracil. A novel mechanism involving adduction of the NCS-chrom C-6 radical, generated by 2-mercaptoethanol activation, to C-5 of the uracil at the U9 position of the RNA 11-mer, oxidation by dioxygen, reduction by the thiol, and subsequent dehydration is proposed for adduct formation.     

硫化物/Ru(II)络合物复合敏化TiO2纳米多孔膜

用光电化学方法研究了ＣｄＳ,ＰｄＳ和Ｒ１１Ｌ２（ＮＣＳ）２,（Ｌ＝２,２′－ｂｉｐｙｄｉｎｅ－４,４′－ｄｉｃａｒｂｏｘｙｌｉｃａｃｉｄ）复合敏化ＴｉＯ２纳米晶电极的光电化学行为,结果表明,采用复合敏化比用Ｒ１１（ＩＩ）络合物单独敏化ＴｉＯ２纳米晶电极效果好,大大提高了光电转换效率,主要原因是采用复合敏化,可防止ＴｉＯ２导带上由光注入产生的电子的反向转移,避免了电子的损失。