A new molecular rectifier device and some research in its processing

Organic materials of D-π-A type MR-X (MR-1: p-dimethylaminophenylethenetrica-rbonitrile and MR-2: p-diphenylaminophenylethene tricarbonitrile) were designed and synthesized. The device with a sandwich structure shows good rectificative phenomena. The highest rectification ratio 10000 was achieved in device Cu/MR-1/Ag, and about 100 in other device M/MR-X/M (M: Cu, Ag). It has been found that rectificative phenomena exist only in the atmosphere-liquid interface region by means of liquid adsorption, and electric field could help form the oriented molecular film. __________ Translated from Journal of Fudan University (Natural Science), 2005, 44(4) (in Chinese)     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

实二次域上理想类的zeta-函数在-1处的值

用连分数给出了实二次域理想类的zeta-函数-1处值的一个具体的计算公式.     

ICP－AES法测定金属矿产品中的磷

本文研究了铁矿石、铬矿石、锰矿石中的微量磷的电感耦合等离子体发射光谱法的测定。方法简便，具有很好的精密度和准确度。标准样品的分析结果基本与标称值相吻合，回收率在９５％－１０５％之间。     

玻璃陶瓷材料中Tm3+离子红外到蓝色上转换发光

系统研究了PbF2+GeO2+WO3ⅩⅣTmF3玻璃陶瓷材料中,在近红外光(1.06μm)激发下,Tm3+离子的发光特性.实验中观测到Tm3+离子的两组峰值位置分别在20920cm-1和22173cm-1的蓝色上转换发光,并证实这两组上转换发光分别与吸收三个和四个光子有关,同时建立了上转换发光的模型.为了选择最佳掺杂浓度,详细地测量了Tm3+离子峰值为20920cm-1的蓝色上转换发光强度与TmF3浓度的关系.     

杂多酸催化合成乙酸乙酯

回流吸附法制备的负载型12-钨磷酸(HPW/C)是合成乙酸乙酯的高效催化剂。最佳反应条件下乙醇转化率达96％,酯化选择性100％。催化剂的高活性是由于HPW在活性炭上高度分散,使活性位增多,有效酸量增大。HPW/C还具有热稳定性高和不易流失等优点。     

Structural and thermodynamic properties of AlB2 compound

We employ a first-principles plane wave method with the relativistic analytic pseudopotential of Hartwigsen, Goedecker and Hutter (HGH) scheme in the frame of DFT to calculate the equilibrium lattice parameters and the thermodynamic properties of AlB₂ compound with hcp structure. The obtained lattice parameters are in good agreement with the available experimental data and those calculated by others. Through the quasi-harmonic Debye model, obtained successfully are the dependences of the normalized lattice parameters a/a₀ and c/c₀ on pressure P, the normalized primitive cell volume V/V₀ on pressure P, the variation of the thermal expansion α with pressure P and temperature T, as well as the Debye temperature \Theta_D and the heat capacity C_V on pressure P and temperature T.     

油水两液相一维非等温渗流的传递分析

在求解油水两液相非等温渗流的温度场、压力场基础上,以驱动功、驱动功率、驱动阻力、驱动速率为特征参数,对该过程进行(火用)传递分析。数值模拟的结果表明:含水通过降低油的相对渗透率、从而增大驱动阻力、减小驱动功率, 最终导致原油产量降低。     

Study of asymmetric charge writing on Pb(Zr,Ti)O3 thin films by Kelvin probe force microscopy

Polycrystalline Pb(Zr_0.55Ti_0.45)O₃ thin film was deposited on Pt/Ti/SiO₂/Si(1 0 0) by radio-frequency-magnetron sputtering method, and the writing of charge bits on the surface of PZT thin film was studied by Kelvin probe force microscopy. It is found that the surface potential of the negative charge bits are higher than those of the corresponding positive ones. When ferroelectric polarization switching occurs, the potential difference becomes even more remarkable. A qualitative model was proposed to explain the origin of the asymmetric charge writing. It is demonstrated that the internal field in the interface layer, which is near the ferroelectric/electrode interface in ferroelectric film, is likely to be the cause for the occurrence of this phenomenon.     

An unstructured mesh finite volume method for modelling saltwater intrusion into coastal aquifers

In this paper, a two-dimensional finite volume unstructured mesh method (FVUM) based on a triangular background interpolation mesh is developed for analysing the evolution of the saltwater intrusion into single and multiple coastal aquifer systems. The model formulation consists of a ground-water flow equation and a salt transport equation. These coupled and non-linear partial differential equations are transformed by FVUM into a system of differential/algebraic equations, which is solved using backward differentiation formulas of order one through five. Simulation results are compared with previously published solutions where good agreement is observed.