初-边值问题驻波解的渐近稳定性

本文考虑一带有人工粘性的二维定常等熵无旋平面流方程组的初-边值问题. 在一定的假设下,我们证明其驻波解是渐近稳定的.     

Bounds for the Least Laplacian Eigenvalue of a Signed Graph

A signed graph is a graph with a sign attached to each edge. This paper extends some fundamental concepts of the Laplacian matrices from graphs to signed graphs. In particular, the relationships between the least Laplacian eigenvalue and the unbalancedness of a signed graph are investigated.     

第I类非自共轭锥上的Gamma函数

本文将Ｇａｍｍａ函数及Ｓｉｅｇｅｌ积分推广到一般的第Ｉ类非自共轭锥上．作为其应用，显式给出了以这些锥为底的管状域（或第一类Ｓｉｅｇｅｌ域）的Ｃａｕｃｈｙ Ｓｚｅｇ¨ｏ核和形式Ｐｏｉｓｏｎ核．     

保健酒中淫羊霍苷成分的分析研究

采用高效液相色谱法对某保健酒中淫羊藿苷成分进行分析研究,结果表明,保健酒中淫羊藿苷的平均含量为0.627％,平均回收率为98.1％,相对标准差（RSD）为2.1％.本分析方法也适用于其他保健酒、药材和药品中淫羊藿苷成分的分析测定.     

(ΩΩ)0+ Dibaryon Productions in Central Au+Au Collisions at RHIC Energy(SNN)= 130 GeV

Based on the measured transverse mass spectra ofπr-, K-, and p at the RHIC energy s()NN = 130 GeV,di-omega productions from baryon-baryon reactions in hadronic matter are studied. Results about the (ΩΩ)0+ numbershow that the deeply bound state (ΩΩ)o+ can be observed at RHIC energies.     

类铜离子的电子碰撞参数及其规律

用准相对论扭曲波方法系统地计算了Ｂａ、Ｎｄ、Ｇｄ、Ｙｂ、Ａｕ、Ｐｂ类铜离子组态能级之间的电子碰撞激发强度Ω（ｎｌ－ｎｌ），３≤ｎ≤７，４≤ｎ≤７，同时给出了高能极限的碰撞强度和外推到阈值的碰撞强度，用最小二乘样条方法拟合了全能域碰撞强度及热平均速率系数。对于一个激发过程，用１０个参数可以得到碰撞电子在任意能量下的碰撞强度以及任意温度下的速率系数。     

Structural and magnetic properties of RF sputtered FePt/Fe multilayers

Series of [FePt(4min)/Fe(t_Fe)]₁₀ multilayers have been prepared by RF magnetron sputtering and post-annealing in order to optimize their magnetic properties by structural designs. The structure, surface morphology, composition and magnetic properties of the deposited films have been characterized by X-ray diffractometer (XRD), Rutherford backscattering (RBS), scanning electron microscope (SEM), energy dispersive X-ray spectroscope (EDX) and vibrating sample magnetometer (VSM). It is found that after annealing at temperatures above 500 °C, FePt phase undergoes a phase transition from disordered FCC to ordered FCT structure, and becomes a hard magnetic phase. X-ray diffraction studies on the series of [FePt/Fe]_n multilayer with varying Fe layer thickness annealed at 500 and 600 °C show that lattice constants change with Fe layer thickness and annealing temperature. Both lattice constants a and c are smaller than those of standard ones, and lattice constant a decreases as Fe layer deposition time increases. Only a slight increase in grain size was observed as Fe layer decreased in samples annealed at 500 °C. However, the increase in grain size is large in samples annealed at 600 °C. The coercivities of [FePt/Fe]_n multilayers decrease with Fe layer deposition time, and the energy product (BH)_max reaches a maximum in the samples with Fe layer deposition time of 3 min. Comparison of magnetic properties with structure showed an almost linear relationship between the lattice constant a and the coercivities of the FePt phase.     

基于FPGA的光纤水听器PGC解调算法实现

针对干涉型光纤水听器信号的PGC（Phase Generated Carrier，相位产生载波）数字化调制解调原理，提出一种基于FPGA（Field Programmable Gate Array，现场可编程门阵列）的实现方案。相比基于DSP的实现方案，该方案可将处理系统的采样率提高1—2个量级，从而大大提高可处理水声信号的上限频率，提高系统的抗混叠能力。     

γ-LiAlO2晶体生长、改性和热学性质研究

采用快速提拉法生长出了透明、完整的γ-LiAlO2晶体,但是晶体的高熔点和易挥发性限制了γ-LiAlO2晶体质量.采用气相传输平衡法(vapor transport equilibration technique,VTE)工艺对晶体改性,半高宽(FWHM)值从116.9arcsec降至44.2arcsec,继续升高VTE处理温度至1300℃,FWHM值反而升高至55.2arcsec.快速提拉法生长出来晶体,[100]方向和[001]方向的热膨胀系数分别为17.2398×10-6/K,10.7664×10-6/K.经过三步VTE处理后[100]和[001]方向热膨胀系数降至16.6539×10-6/K和10.1784×10-6/K.     

Developing a hybrid emulsion polymerization system to synthesize Fe3O4/polystyrene latexes with narrow size distribution and high magnetite content

A hybrid emulsion polymerization was formulated for synthesizing Fe₃O₄/polystyrene composite latex. This system, containing binary droplets that are magnetic (Mag)‐droplets with a diameter of 100–200 nm and styrene (St)‐droplets with a diameter of 3–4 μm, was obtained by mixing Mag‐miniemulsion and St‐macroemulsion. With extremely low surfactants concentration (?critical micelle concentration, CMC), the nucleated loci are selectively controlled in the Mag‐droplets, as the result of smaller droplet size and larger surface ratio. Both water‐soluble potassium persulfate (KPS) and oil‐soluble 2,2′‐azobis(2‐isobutyronitrile) was adopted to initiate the polymerization. In the presence of KPS, magnetic polystyrene latices with particles size of 60–200 nm, narrow size distribution, and high magnetite content (86 wt % measured by TGA) were attained successfully. The synthesized magnetic Fe₃O_4/polystyrene latices assembled into well‐ordered hexagonal structure in the surface of a carbon supported copper grid. The influence of various parameters on various aspects of the as‐synthesized Fe₃O₄/polystyrene was investigated in detail: type of initiator on composite morphology, feed ratio of Mag‐miniemulsion and St‐macroemulsion on magnetite content, and hydrophobic agent or amount of surfactant on size and size distribution. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5285–5295, 2007