基于后向散射模型的蒸汽湿度测量及仿真

为了更加准确地测量出汽轮机末级蒸汽湿度,为锅炉给水量提供依据,促进汽轮机内部除湿技术的发展,采用了后向角散射法的思路设计了湿蒸汽参数测量模型,并对模型所需物理量进行了详细的计算,为后向散射法测量蒸汽湿度的研究提供参考。通过对模型进行仿真模拟以及实验研究,得到了后向散射光光强数据。通过对比仿真模拟数据与实验数据,验证了该模型的可行性与有效性,对光散射法测量蒸汽湿度的实验分析以及工程实践具有重要意义。     

用电子管做等离子体诊断实验

用电子管代替气体放电管做等离子体诊断实验,分别使用X-Y自动记录仪和万用表进行测量,计算得出等离子体参量,并与使用放电管得出的等离子参量做比较,证明了用电子管代替气体放电管的可行性.     

Influence of the angle between two crown ether moieties on supramolecular copolymerization of bis(crown ether)s and bisparaquat homoditopic monomers

Bis(crown ether) homoditopic monomers containing two bis(p-phenylene)-34-crown-10 moieties with different angles(180° for monomer 3,120°for monomer 4,and 60°for monomer 5) and a complementary bisparaquat homoditopic monomer(7) were designed and synthesized.The three bis(crown ether) monomers could organize into linear supramolecular polymers in concentrated solutions in CHCl3/CH3CN with the bisparaquat monomer 7,as demonstrated by 1 H NMR and viscosity studies. The pseudorotaxanes or supramolecular polymers...     

Preparation and Inhibitory Effects of 20（S）-Ginsenoside Rh2 on Hep-A-22 Cells

<正>A modified method of preparing 20(S)-ginsenoside Rh_2(G-Rh_2) and the inhibitory effect of 20(S)-ginse-noside Rh_2 on Hep-A-22 cells were investigated.The total saponins and strong alkali were dissolved in glycerol at the atmospheric pressure,and the degradation was performed at a high temperature.After G-Rh_2 had been isolated and purified,MTT(methyl thiazolyl tetrazolium) assay was applied to evaluating the effect of 20(S)-ginsenoside Rh_2 on the cells viability and morphological changes were observed.It was shown that 20(S)-ginsenoside Rh_2 can reduce Hep-A-22 cells viability in dose-dependent manner and the cells took on cell shrinkage,membrane blebbing,chromosomal condensations,especially under the higher concentrations of it.In conclusion,20(S)-ginsenoside Rh_2 can be prepared effectively that not only decreases viability but also induces the apoptosis of Hep-A-22 cells.     

不对称加氢制备手性3′-氯-苯丙醇的反应液的气相色谱分析

用不对称催化还原法以3’-氯-苯丙醇（CPNL）为原料制备了手性3’-氯-1-苯丙酮（CPNL）,并用气相色谱法测定反应液中产品及剩留的原料的含量。选用2-甲基-苯丙醇为内标物,并用化学键合β-环糊精为固定相的手性毛细管色谱柱CP-Chirasil-Dex-CB对产品及原料进行分离。在所选条件下,不仅使CPNN与CPNL,还可使CPNL的右、左旋对映体相互有效分离。由于采有内标法,因进样不准而产生的误差得以克服,测得CPNN及（S）CPNL的检出限（3S/N）依次为13.14,18.75 mg·L^-1。上述两种化合物的加标回收率依次为99.5%～101.8%及96.5%～100.4%范围内;两者测定值的相对标准偏差（n=6）分别为0.39%,0.74%（左、右旋对映体相同）。     

Application of EDXRF Method in Measurement of Fe Content in Aqueous Fe Sample

介绍了能量色散X荧光分析方法在含水Fe样品测量中的应用.用ANTG -2000型海底X荧光探测系统对含Fe为10％～60％的Fe样进行测量,建立水分对Fe元素特征K α射线影响的校正模型.结果表明,通过该模型校正,对含饱和水情况下Fe样品的分析相对误差小于4％,具有良好的分析效果.     

Dipole bands in nucleus ~(139)Pm

High-spin states in nucleus 139Pm have been studied using the reaction 116Cd(27Al,4n)139Pm.Two dipole cascades have been found.Spin and parity assignments were based on the Directional Correlation of Oriented Nuclei(DCO) ratios and systematic behavior in neighboring odd-proton nuclei.The level structures of 139Pm are compared with those of the N =78 isotone 141Eu in which two dipole bands have been confirmed as magnetic rotational bands.The close similarity between them suggests that the dipole bands in 139...     

Tesla微混合器结构参数对混合强度的影响

针对Tesla微混合器混合原理,利用计算流体力学(CFD)模拟与分析软件对其进行了三维数值模拟.模型采用有限体积法离散、SIMPLEC算法进行层流计算.分析了结构参数的改变对该混合器混合效果的影响,并采用混合强度值作为衡量指标.分析结果显示,不同通道高宽比和分离通道入流角度等结构参数对该微混合器的混合效果有重要影响.模...     

Normalized intensity correlation function of single-mode laser system driven by colored cross-correlation noises

Considering a single-mode laser system with cross-correlated additive colored noise and multiplicative colored noise, we study the effects of correlation among noises on the normalized intensity correlation function C(s).C(s) is derived by means of the projection operator method.