Enantioseparation and molecular modeling study of eight psychoactive drugs on a coated polysaccharide-based chiral stationary phase

The enantioseparation of eight psychoactive drugs has been firstly performed on a coated cellulose-based chiral stationary phase (Chiralcel OJ-H). To obtain optimum separation conditions, the influences of alcohol modifiers and basic/acidic additives have been studied. As a result, except for the partial separation of oxybutynin enantiomers, the other seven drug enantiomers, including mirtazapine, sulpiride, promethazine, citalopram, oxazepam, donepezil, and cyamemazine, have been completely separated. Additionally, for gaining a better insight into the chiral recognition mechanisms, molecular docking was carried out using the Autodock software. Herein, binding energy and conformations of the chiral stationary phase complexes were provided, and it was found that the distinction in enantiomeric conformation determined the number and strength of intermolecular interactions between analytes and chiral stationary phase which resulted in the difference in binding energies of two enantiomers, and ultimately led to the different migration. These modeling results were in accordance with the observed enantioseparation results in high performance liquid chromatography experiments. At last, chiral separation mechanisms have been discussed in detail, and it has been confirmed that hydrogen bond, π–π, hydrophobic interactions, and some special interactions synergistically contributed to the enantioseparation of psychoactive drugs.     

Three-dimensional Octameric Assembly of Icosahedral M13 Units in [Au8Ag57(Dppp)4(C6H11S)32Cl2]Cl and its [Au8Ag55(Dppp)4(C6H11S)34][BPh4]2 Derivative

The high-dimensional (that is, three-dimensional (3D)) assembly of nanomaterials is an effective means of improving their properties; however, achieving this assembly at the atomic level remains challenging. Herein, we obtained a novel nanocluster, [Au₈Ag₅₇(Dppp)₄(C₆H₁₁S)₃₂C_l2]Cl (Dppp=1,3-bis(diphenylphosphino)propane) showing a 3D octameric assembly mode involving the kernel penetration of eight complete icosahedral Au@Ag₁₀Au₂ units for the first time. The atomically precise structure was determined by single-crystal X-ray diffraction, and further confirmed by thermogravimetric analysis, X-ray photoelectron spectroscopy, and electrospray ionization mass spectrometry measurements. Furthermore, ligand-induced transformation prompted the conversion of [Au₈Ag₅₇(Dppp)₄(C₆H₁₁S)₃₂Cl₂]Cl, with complete octameric fusion into [Au₈Ag₅₅(Dppp)₄(C₆H₁₁S)₃₄][BPh₄]₂, with incomplete octameric fusion. These observations will hopefully facilitate further research on the assembly of M₁₃ nanobuilding blocks.     

Stimuli-Responsive Circularly Polarized Organic Ultralong Room Temperature Phosphorescence

Purely organic materials showing room temperature phosphorescence (RTP) and ultralong RTP (OURTP) have recently attracted much attention. However, it is challenging to integrate circularly polarized luminescence (CPL) into RTP/OURTP. Here, we show a strategy to realize CPL-active OURTP (CP-OURTP) by binding an achiral phosphor group directly to the chiral center of an ester chain. Engineering of this flexible chiral chain enables efficient chirality transfer to carbazole aggregates, resulting in strong CP-OURTP with a lifetime of over 0.6 s and dissymmetry factor of 2.3×10⁻³ after the conformation regulation upon photo-activation. The realized CP-OURTP is thus stable at room temperature but can be deactivated quickly at 50 °C to CP-RTP with high CPL stability during the photo-activation/thermal-deactivation cycles. Based on this extraordinary photo/thermal-responsive and highly reversible CP-OURTP/RTP, a CPL-featured lifetime-encrypted combinational logic device has been successfully established.     

C.I.颜料红177中间体的制备工艺改进

本文较为系统地研究了铜粉催化剂加入方式对C.I.颜料红177中间体4,4'-二氨基-1,1'-二蒽醌-3,3'-二磺酸(DAS)合成过程中的乌尔曼偶联反应速率的影响规律。 研究结果表明,在55 ℃较佳反应温度下,先加入与溴氨酸钠质量比为2:5的铜粉,反应一段时间后再加入与溴氨酸钠的质量比为1:5的铜粉,与一次性加入与溴氨酸钠的质量比为3:5的铜粉相比较,综合反应时间可节省2~3 h。 另外,对于DAS中混有的铜盐,采取在制备过程中加入柠檬酸的方法予以去除,此举可提高DAS的纯度。 当铜粉与柠檬酸的质量比为6:1时,可使DAS中铜盐的含量小于0.001%。 此外还探究了蒸馏后滤液的剩余量对DAS收率的影响,结果表明,滤液的剩余量在20 mL时,DAS的收率在95%以上。 基于本文的研究结果提出,欲进一步提高该反应的收率,需要寻找更高效的催化剂。     

马尿酸分子印迹电化学传感器的制备及应用

采用超声法制备g-C3N4/NiO复合催化材料,将其滴涂在玻碳电极(GCE)表面构建g-C3N4/NiO/GCE催化电极。采用电聚合方法,以马尿酸为模板分子,邻苯二胺为功能单体构建M IP/g-C3N4/NiO/GCE传感器。采用时间-电流法对传感器制备条件优化。结果表明,复合催化材料对H2O2具有良好的催化效果。分子印迹传感器对马尿酸具有良好的选择性。在优化条件下,马尿酸质量浓度在0.05~2 mg/L范围内,电极电流响应与浓度呈良好的线性关系,检出限为7.1μg/L。将电极用于尿液中马尿酸的检测,回收率在87.3%~95.3%之间。     

液相色谱-四极杆-静电轨道阱高分辨质谱法测定保健食品中11种磷酸二酯酶抑制剂

保健食品样品用50%(体积分数)甲醇溶液超声提取15 min,提取液用水定容至50.0mL,离心,取上清液,经0.22μm微孔滤膜过滤,采用液相色谱-四极杆-静电轨道阱高分辨质谱法测定滤液中11种磷酸二酯酶抑制剂的含量。以Waters HSS T3色谱柱为固定相,以不同体积比的0.1%(体积分数)甲酸溶液和乙腈的混合液为流动相进行梯度洗脱,质谱分析中采用电喷雾离子源正离子模式和全扫描模式。11种磷酸二酯酶抑制剂的质量浓度均在2~100μg·L^-1内与其对应的峰面积呈线性关系,测定下限(10S/N)为0.02~0.5μg·L^-1。以空白样品为基体进行加标回收试验,所得回收率为75.7%~98.9%,测定值的相对标准偏差(n=6)为5.9%~14%。     

QuEChERS提取-高效液相色谱-高分辨质谱法测定水产品中3种蓝藻毒素的含量

取水产品样品2.00g与2g无水硫酸钠混匀后加入提取剂10 mL甲醇,涡旋振荡5min后超声提取5 min,再离心5 min,取其上清液。在上清液中加入500 mg中性氧化铝和15mg石墨化碳黑(GCB)涡旋振荡1min,离心5min,取上清液,于40℃下吹氮至近干,用体积比为1∶1的流动相A-流动相B混合溶液溶解残渣并定容至2.0mL,经0.22μm滤膜过滤,取其滤液按高效液相色谱-高分辨质谱法测定其中3种蓝藻毒素的含量。色谱分离中用Hypersile Gold C8色谱柱(150mm×2.1mm,3μm)为固定相,用不同比例的流动相A和流动相B两溶液的混合液作为流动相进行程序梯度洗脱。质谱测定中采用电喷雾离子源,正、负离子切换模式。由于3种蓝藻毒素均产生基质减弱效应,制作工作曲线需用基质标准溶液以消除基质效应。结果表明:所测3种蓝藻毒素均在10~200μg·L^-1内与其峰面积之间呈线性关系,其检出限(3S/N)均为5μg·kg^-1。通过标准加入法进行回收试验,测得回收率为68.3%~104%,测定值的相对标准偏差(n=6)为7.7%~17%。     

碱金属无机酸盐催化的硫醇的β-羟乙基化反应

在常压、无溶剂、120℃条件下,考察了14种碱金属无机酸盐(MA,M=Li^+,Na^+,K^+)催化正辛硫醇与碳酸乙烯酯的S-羟乙基化反应性能。普遍的规律是:在阴离子A相同的情况下,钾盐的催化活性高于相应的钠盐,而锂盐无催化活性。在各种无机酸钾盐中,如果共轭酸酸性越强,则相应的钾盐的催化活性越低。为探究钾盐催化剂活化-SH的机理的普适性,以K_3PO_4为催化剂,考察了在不同反应温度下,6种不同结构的硫醇与碳酸乙烯酯的β-羟乙基化反应催化活性,得出规律是硫醇的酸性越强,其反应活性越高,S-H键越容易解离。该反应无溶剂参与,硫醇与碳酸乙烯酯的物质的量之比接近理论量,产物β-羟乙基硫醚的选择性>99%,产物中无卤素盐副产物生成,易于分离。     

A biomass carbon material with microtubule bundling and natural O-doping derived from goldenberry calyx and its electrochemical performance in supercapacitor

A promising biomass carbon material,manufactured by the carbonation of Physalis peruviana L.calyx at 700℃,is presented in this wo rk.Morphology characterization shows that the carbon material possesses long microtubule bundling and above 30%natural O-atom component on the surface.After KOH chemical etching,the materials maintain the oxygen content but exhibit more micropores and higher specific surface area up to 1732.6 m^2/g.Using as an electrode material for supercapacitor,the active carbon material exhibits high specific capacitance up to 339.7 F/g at 0.5 A/g in 3 mol/L KOH aqueous solution through three-electrode system.The active carbon material also exhibits excellent cycling stability(97%retention)by 10,000 cycles at 10 A/g.The outstanding electrochemical performances are attributing to the unique long microtubule bundling with much more pores and the abundant Oelement on the surface.This biomass carbon material with excellent electrochemical properties could be a useful material for multiple applications.     

手性钙钛矿纳米材料的构筑及光电性能

金属卤化物钙钛矿纳米材料因其丰富的化学结构和优异的光电性能,已成为一种极具应用前景的半导体材料。在钙钛矿无机框架中引入有机手性分子后,能够比较容易地得到手性钙钛矿纳米材料,从而可以极大地推动智能光电材料和自旋电子器件的快速发展。本文将综述手性钙钛矿纳米材料的构筑与手性产生机理的最新研究进展,包括一维手性钙钛矿纳米线、二维及准二维手性有机-无机杂化钙钛矿纳米片、三维手性钙钛矿纳米晶、超分子组装体系中诱导的手性钙钛矿纳米晶等。值得注意的是,不同种类的手性钙钛矿纳米材料在圆二色性、圆偏振发光、铁电性、自旋电子学等方面展现出优异的光电性能及巨大的应用前景。但是,有关手性钙钛矿纳米材料的研究目前还处于初级阶段,其中很多机理还存在争议,许多基础性和应用型的工作也有待开展。