影响杂化钙钛矿太阳能电池稳定性的因素探讨

自从2009年首次报道采用有机-无机杂化钙钛矿作为吸光材料用于太阳能电池以来, 钙钛矿太阳能电池效率的快速提升引起了人们广泛的关注, 这类电池同时具有制备工艺简单、成本低廉等优点, 引发了钙钛矿电池的研究热潮. 目前研究工作大多数集中在如何提高电池的光电转化效率, 但钙钛矿电池要真正实现产业化应用, 急需要解决材料及器件的稳定性问题. 本文探讨影响钙钛矿材料及器件的稳定性因素, 从温度及湿度等方面分析了材料的稳定性, 从传输材料及其界面问题讨论了器件的稳定性.     

藏药珠西的化学成分与结构分析

采用X射线荧光(XRF)、电感耦合等离子体发射光谱(ICP-OES)和X射线衍射(XRD)对不同来源藏药珠西中的元素成分和结构组成进行测定,以期揭示其药理作用的物质基础。XRF和ICP-OES分析结果表明,藏药珠西中主要元素为Fe,S和O,及少量的Si,Na,Mg,Al,K,Ni,Ca,Ti等元素。XRD分析表明,藏药珠西中主要存在立方晶系FeS2,此外还含有少量的斜方晶系Fe+3O(OH)等。通过XRF,ICP-OES和XRD分析,获得了藏药珠西的化学成分和结构组成基本数据,为其药理作用物质基础的揭示和质量标准的制定提供了科学依据。     

盾构作业区域湿热环境的研究

通过对掘进中的盾构及隧道内的温度和湿度的实地测量,本文针对盾构施工过程中在其作业区域存在的高温高湿等恶劣的工作环境问题,就其形成的原因和热湿传递的特性进行了分析,还对其中的流场进行了初步的数值模拟,提出了改善盾构作业区域内工作环境的措施。     

Modified Two-Scale Model for Electromagnetic Scattering from the Non-Gaussian Oceanic Surface

Based on the skewness of sea waves, a modified two-scale model is developed for the non-Gaussian sea surface scattering. In this new model, a complementary term is added to the first-order scattering coefficient of the classical small perturbation method （SPM）, the additional part is proportional to the surface bispectrum and it is the critical part in explaining the scattering difference between upwind and downwind observations. Meanwhile, the effects of the shadowing function of the anisotropic surface, the curvature of the surface are also taken into account. The numerical results show the theoretical estimates obtained are consistent with the experimental result, and the influence of the wind speed, the trend and the incident frequency on the backscattering coefficients from the non-Gaussian oceanic surface is discussed in detail.     

Inhibition of copper corrosion by bis-(1,1′-benzotriazoly)-α,ω-diamide compounds in aerated sulfuric acid solution

Three kinds of novel corrosion inhibitors, bis-(1,1′-benzotriazoly)-α,ω-succinyldiamide (BSU), bis-(1,1′-benzotriazoly)-α,ω-adipoyldiamide (BAD), and bis-(1,1′-benzotriazoly)-α,ω-azelayldiamide (BAZ) were synthesized and certified by IR and ¹H NMR. Their corrosion inhibition effects for copper in 0.5 M H₂SO₄ were evaluated by weight-loss method. It shows that among the three compounds, only BSU behaves better compared with BTA. The inhibition efficiency (IE) increased with increasing BSU concentration to 85.2% at the 5 × 10⁻⁴ M level. Polarization studies showed that BSU suppressed both anodic and cathodic corrosion reactions. The minimum energy conformation of these compounds was obtained by MM2 force field program. The two benzotriazoly moieties in BSU molecule are more parallel than in other compounds. This is benefit to increase the inhibition effects of BSU.     

基于多金属氧簇的手性超分子液晶

以手性诱导为切入点,采用含胆固醇基团的季铵盐表面活性剂静电包覆缺位的Keggin结构多金属氧簇K7PW11O39·12H2O,得到了手性介晶阳离子修饰的多金属氧簇杂化超分子复合物。圆二色谱对该复合物光学活性的表征说明外围的手性表面活性剂可以通过静电相互作用诱导复合物显示出手性。利用差示扫描量热曲线法、偏光显微镜观察和变温X射线衍射详细研究了该复合物的热性质和相行为,结果表明该复合物在较宽的温度范围内具有热致液晶性质,是一种典型的手性近晶A相离子液晶材料。     

利用手持技术探究铝的化合物之间的相互转化过程

高中铝的化合物（“铝三角”）之间的相互转化过程是高考高频考点,其中共涉及7个反应方程式,但学生对此大多停留在机械记忆层面上,认知思路和角度较混乱。从一道高考题出发,引入数字化手持技术设计4个滴定实验,利用电导率、pH传感器测得电导率、pH随时间变化的曲线,结合宏观、微观、符号和曲线表征多角度进行分析。利用四重表征分析方法,突破“铝三角”转化中双水解反应的认知难点,完善相关教学并提供参考建议,丰富手持技术在教学上的案例。     

胶晶模板法制备3DOM尖晶石型LiMn2O4及表征

通过乳液聚合获得粒径为280 nm左右的聚甲基丙烯酸甲酯(PMMA)微球, 从其母液中离心沉降制得胶晶模板. 将LiNO3, Mn(Ac)2·4H2O和柠檬酸按摩尔比1∶2∶2配成前驱物的醇水混合溶液, 填充于PMMA胶晶模板间隙中, 经干燥和焙烧氧化成孔制得了三维有序大孔(3DOM)锂锰氧化物. 实验结果表明, 当n(Li)/n(Mn)=0.6, 前驱液浓度在0.6~1.0 mol/L之间和升温速率为2 ℃/min时, 分别在300与600 ℃下两段恒温焙烧2~3 h有利于目标产物的形成. SEM测试结果表明, PMMA胶晶模板和3DOM锂锰氧化物均为面心立方紧密堆积, 排列规则有序, 大孔直径在200~240 nm之间, 孔壁厚度在30~45 nm之间. 产物经XRD晶相测定和EDTA, KMnO4滴定分析确证为正尖晶石型LiMn2O4.     

3，4－二硫方酸的从头算研究

在６－３１Ｇ水平上对３，４－二硫方酸（３，４－二巯基－３－环丁烯－１，２－二酮）的３种平面构象异构体进行ＳＣＦ计算．结果表明，ＺＺ型异构体最稳定，ＺＥ型次之，从等键反应能量分析３，４－二硫方酸的稳定性，与苯作比较探讨其芳香性．并在６－３１Ｇ水平上计算了３种构象的振动频率．