高温超导无绝缘线圈励磁电压特性研究

本文通过实验研究了焊锡浸渍、励磁电流PI控制、励磁速率以及励磁幅值对高温超导无绝缘线圈励磁电压特性的影响。实验结果表明:高温超导无绝缘线圈励磁电压具有时延特性,焊锡浸渍、励磁电流PI控制分别会增大和减小时延特性,而励磁速率和励磁幅值不会影响时延特性;励磁电压幅值随励磁速率增大而增大;焊锡浸渍可降低励磁电压幅值,而励磁电流控制对励磁电压幅值影响不明显。     

Spin-exchange relaxation of naturally abundant Rb in a K-Rb-~(21)Ne self-compensated atomic comagnetometer

The total effective spin-exchange relaxation of naturally abundant Rb in a K–Rb–21Ne comagnetometer is analyzed,and the results show that the coexistence of 87Rb and 85Rb isotopes in the same volume can lead to a large extra spinexchange broadening compared to pure 87Rb.This broadening mainly comes from the contribution of the equivalent reduction in the Rb spin-exchange rate.On this basis,an approximate relaxation model is proposed and experimentally demonstrated to be more accurate than that from a previous work.This study also provides a method for determining the properties of alkali-metal vapor cells.     

1.3 GHz超导腔磁通排出效应研究

设计并搭建了一套高精度的磁场测量和补偿系统,并结合中国科学院高能物理研究所（IHEP）的2K超导腔垂直测试平台对1.3 GHz 单加速间隙超导腔的磁通排出效应开展了实验研究：利用研制的磁场测量和补偿系统能够精密地测量超导腔赤道位置磁场,并能够将磁场补偿至小于5.0×10⁻⁸ T;并对超导腔不同表面温度梯度下的磁通排出效应进行了测量分析;对钉扎了磁场的超导腔进行了射频性能测试,研究了超导腔电阻对磁通钉扎的敏感度,以及在不同电场梯度下超导腔的表面电阻变化情况。结果表明,研制的高精度磁场测量和补偿系统能够满足超导腔磁通排出研究的需求;高的超导腔表面温度梯度有利于磁通的排出;磁通钉扎电阻的敏感度随着加速电场梯度的增加而增大,导致超导腔的性能下降。此实验研究也为后续超导腔的研制奠定了一定基础。     

离子能量分析器测量特性的仿真研究

针对空间等离子体及其模拟环境、空间原子氧及其模拟环境对离子能谱测量的需要,利用仿真软件COMSOL,对离子能量分析器的低能离子测量特性进行了仿真研究。介绍了离子能量分析器的工作原理,对离子能谱测量过程进行了公式推导。通过对三种待选仪器设计方案进行离子透过率仿真分析,确定了一种较优的仪器设计方案。多种离子温度下的误差分析结果也表明,该设计方案能够较为准确地测量离子能量分布。分析了电场畸变、等离子鞘层、栅网对齐方式和离子温度对测量结果的影响,根据仿真结果对一些仿真实验现象做出了合理的解释。     

用于光学神经网络硬件系统误差纠正的虚拟神经网络

提出了一种用于修正光学神经网络硬件系统误差的虚拟神经网络模型，光学实验结果表明该网络能够有效地消除硬件系统误差对实验结果的影响。     

A Note on L（2, 1）-labelling of Trees

An L(2,1)-labelling of a graph G is a function from the vertex set V (G) to the set of all nonnegative integers such that |f(u) f(v)| ≥ 2 if d G (u,v)=1 and |f(u) f(v)| ≥ 1 if d G (u,v)=2.The L(2,1)-labelling problem is to find the smallest number,denoted by λ(G),such that there exists an L(2,1)-labelling function with no label greater than it.In this paper,we study this problem for trees.Our results improve the result of Wang [The L(2,1)-labelling of trees,Discrete Appl.Math.154 (2006) 598-603].     

快速凝固Cu-Pb过偏晶合金的性能表征

研究了Cu-Pb过偏晶合金的急冷快速凝固组织特征,定量表征了快速凝固Cu-Pb过偏晶合金的电阻率和力学性能,理论分析了冷却速率和组织形态对合金性能的影响规律. 研究结果表明,在急冷快速凝固条件下,Cu-Pb过偏晶合金中的(Cu)相和(Pb)相均以枝晶方式生长,晶体形态以均匀细小的等轴晶为特征. 随着冷却速率增大,一方面,凝固组织显著细化,晶界增多,对自由电子的散射作用增强,合金电阻率显著增大;另一方面,细晶强化作用增强,合金的抗拉强度呈线性升高,同时,伴随着晶体缺陷数量的增多,合金的伸长率降低. 关键词： Cu-Pb过偏晶合金 快速凝固 电阻率 力学性能     

Experimental study of a plasma-filled backward wave oscillator

Experimental studies of a plasma-filled X-band backward-wave oscillator (BWO) are presented. Depending on the background gas pressure, microwave frequency upshifts of up to 1 GHz appeared along with an enhancement by a factor of 7 in the total microwave power emission. The bandwidth of the microwave emission increased from ⩽0.5 GHz to 2 GHz when the BWO was working at the RF power enhancement pressure region. The RF power enhancement appeared over a much wider pressure range in a high beam current case (10-100 mT for 3 kA) than in a lower beam case (80-115 mT for 1.6 kA). The plasma-filled BWO has higher power output than the vacuum BWO over a broader region of magnetic guide field strength. Trivelpiece-Gould modes (T-G modes) are observed with frequencies up to the background plasma frequency in a plasma-filled BWO. Mode competition between the T-G modes and the X-band Tm₀₁ mode prevailed when the background plasma density was below 6×10¹¹ cm^-3 . At a critical background plasma density of ≃8×10¹¹ cm^-3 power enhancement appeared in both X-band and the T-G modes. Power enhancement of the S-band in this mode collaboration region reached up to 8 dB. Electric fields measured by the Stark-effect method were as high as 34 kV/cm while the BWO power level was 80 MW. These electric fields lasted throughout the high-power microwave pulse     

Mössbauer study of Fe-B alloys containing Nd additives

The influence of a few percent neodynium additives to Fe-B alloy on the hyperfine parameters was investigated. It was found that Nd decreases the hyperfine field of amorphous Fe-B alloys. The samples annealed at temperatures between 600°C and 700°C contain α-Fe and Fe₃B phases. The average hyperfine field of Fe₃B phase increases with increasing Nd content and decreases with increasing annealing temperature. The average isomer shift of Fe₃B phase decreases with increasing Nd content. The experimental data show that the change of hyperfine parameters of the Fe₃B phase in the studied alloys is due to Nd atom.     

Recent Advances in Common Transition Metal-Based Single-Atom Nanozymes and Their Applications in Pollutant Detection and Degradation

Nanozymes can be used as favorable substitutes for natural enzymes because of their strong catalytic activity and good stability. At the same time, research on single-atom catalysts (SACs) with isolated metal atoms as active centers is also in full swing, showing excellent performance in a variety of catalytic reactions. With the in-depth study of SACs, people have a comprehensive understanding of them and put forward the concept of single-atom nanozymes (SAzymes) by combining nanozymes with SACs. As a new type of nanomaterial, SAzymes have attracted great interest due to their remarkable catalytic activity and rapid energy conversion. However, most applications of SAzymes are mainly in the fields of biomedicine and biosensing, and less research has been done in the field of the environment. Based on the amazing ability of nanozymes to detect and degrade pollutants, SAzymes are also used in the environmental field, and even they will show better capabilities. This review mainly analyses common transition metal-based SAzymes and describes their applications in the field of environmental pollutants.