等色染料离子对萃取光度法研究：Ⅰ.溴酚蓝·亚甲蓝体系

研究了溴酚蓝（ＢＰＢ）·亚甲蓝（ＭＢ）等色染料离子对萃取光度测定银、汞和铜的方法。首先将被测金属离子形成［Ｍｅ（ｐｈｅｎ）３］ＢＰＢ的二氯乙烷萃取液，用ＫＣＮ解析并反萃入水相，而后加入和溴酚蓝等色的亚甲蓝溶液继续萃取。由于等色染料离子对和Ｍｅ（ＣＮ）ｎＢＰＢ三元络合物同时进入二氯乙烷中而提高了灵敏度、测定Ａｇ、Ｈｇ和Ｃｕ的摩尔吸光系数均在１０５Ｌ·ｍｏｌ（－１）·ｃｍ（－１）以上。     

纳米级MoO3微粉的制备与性质

以(NH4)6Mo7O24·4H2O和HAc为原料,制备了纳米级MoO3微粉,用电镜观察其形貌和粒径的大小,并进行X射线衍射分析.在制备过程中,通过严格控制溶液的浓度、酸度等条件,首先得到纤维状的酸式仲钼酸铵(NH4)4H2Mo7O24·4H2O和 (NH4)3H3Mo7O24·4H2O.并通过加热使其分解,从而获得纳米级MoO3微粉.     

Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Intramolecular proton transfer induced by divalent alkali earth metal cation in the gas state

Interactions between divalent alkali earth metal (DAEM) ions M (M?Be, Mg, Ca, Sr, Ba) and the second stable glycine conformer in the gas phase, which can transfer into the ground‐state glycine‐M²⁺ (except the glycine–Be²⁺) among each corresponding isomers when these divalent metal ions are bound, are studied at the hybrid three‐parameter B3LYP level with three different basis sets. Proton transfers from the hydroxyl to the amino nitrogen of the glycine without energy barriers have been first observed in the gas phase in these glycine–M²⁺ systems. The interaction between the glycine and these DAEM ions except beryllium and magnesium ion only create an amino hydrogen pointing to the original hydroxyl due to their weaker interaction relative to those divalent transition metal (DTM) ion‐bound glycine derivatives, being obviously different from that between the glycine and DTM ions, in which two amino hydrogens point to the original hydroxyl oxygen when these metal‐chelated glycine derivatives are produced. The interaction energy between the glycine and divalent magnesium would be the boundary of one or two amino hydrogens pointing to the hydrogyl oxygen, i.e., the ?170.3 kcal/mol of binding energy is a critical point. Similar intramolecular proton transfer has also been predicted for those DTM ion‐chelated glycine systems; however, that in the gas state has not been observed in the monovalent metal ion‐coordinated glycine systems. The binding energy between some monovalent TM ion and the glycine is similar to that of the glycine–Ba²⁺, which has the lowest binding strength among these DAEM–ion chelated glycine complexes. The difference among them only lies in the larger electrostatic and polarized effects in the latter, which favor the stability of the zwitterionic glycine form in the gas phase. According to these observations, we predict that the zwitterionic glycine would exist in the field of two positive charges in the gas phase. © 2003 Wiley Periodicals, Inc. Int J Quantum Chem 94: 205–214, 2003     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

An Easy One-Pot Procedure for the Synthesis of <Emphasis Type="Italic">N</Emphasis>-Sulfonyl Phosphorous Ylides and Sulfonyl Iminophosphoranes

Summary. Reaction of triphenylphosphine and an electron deficient acetylenic ester in the presence of strong N–H acid such as alkyl and aryl sulfamides or acetamide produces phosphorous ylides at room temperature in CH₂Cl₂. The aryl sulfamide phosphoranes undergo a smooth transformation reaction in boiling toluene and produce iminophosphoranes.