Study on the Correlation between the Protein Profile of Lupin Milk and Its Cheese Production Compared with Cow’s Milk

Australian sweet lupin, the largest legume crop grown in Western Australia, is receiving global attention from the producers of new foods. To understand the effect of protein on cheese yield, lupin milk proteins were separated from the first, second, and third filtrations by cheesecloths. However, proteins from the first and second were analyzed using two-dimensional polyacrylamide gel electrophoresis; then, the isolated proteins associated with cheese production were identified. The research also focused on identifying the optimal method of cheese production based on the coagulation process, temperature, yield, and sensory evaluation. Lupin curds from the two cultivars, Mandelup and PBA Jurien, were produced using vinegar, lemon juice, starter culture, vegetable rennet enzyme as coagulant, as well as curd generated using starter culture and vegetable rennet enzyme. Cow’s milk was used as a control. The results indicated that first-time filtration produced better extraction and higher yield of lupin proteins and cheese than the second filtration. A sensory analysis indicated that lupin cheese produced from PBA Jurien lupin milk using vinegar, 7.80% expressed as acetic acid, and ground in 45 °C water, was the most acceptable. The cheeses were examined for their protein, carbohydrates, fat, ash, and moisture contents. The concentration of protein was approximately 27.3% and 20.6%, respectively, in the cheese from PBA Jurien and Mandelup. These results suggest that lupin milk can adequately supply the proteins needed in human diets and, thus, could be used in the production of many existing products that require animal milk as an input.     

Magnetic interactions in the geometrically frustrated triangular lattice antiferromagnet CuFeO2

The spin-wave excitations of the geometrically frustrated triangular lattice antiferromagnet CuFeO2 have been measured using high resolution inelastic neutron scattering. Antiferromagnetic interactions up to third nearest neighbors in the ab plane (J1, J2, J3, with J{2}/J{1} approximately 0.44 and J{3}/J{1} approximately 0.57), as well as out-of-plane coupling (J{z}, with J{z}/J{1} approximately 0.29) are required to describe the spin-wave dispersion relations, indicating a three-dimensional character of the magnetic interactions. Two energy dips in the spin-wave dispersion occur at the incommensurate wave vectors associated with multiferroic phase and can be interpreted as dynamic precursors to the magnetoelectric behavior in this system.     

Simultaneous In Situ Quantification of Two Cellular Lipid Pools Using Orthogonal Fluorescent Sensors

Lipids regulate a wide range of biological activities. Since their local concentrations are tightly controlled in a spatiotemporally specific manner, the simultaneous quantification of multiple lipids is essential for elucidation of the complex mechanisms of biological regulation. Here, we report a new method for the simultaneous in situ quantification of two lipid pools in mammalian cells using orthogonal fluorescent sensors. The sensors were prepared by incorporating two environmentally sensitive fluorophores with minimal spectral overlap separately into engineered lipid‐binding proteins. Dual ratiometric analysis of imaging data allowed accurate, spatiotemporally resolved quantification of two different lipids on the same leaflet of the plasma membrane or a single lipid on two opposite leaflets of the plasma membrane of live mammalian cells. This new imaging technology should serve as a powerful tool for systems‐level investigation of lipid‐mediated cell signaling and regulation.     

Pathways of Methane Transformation over Copper-Exchanged Mordenite as Revealed by In Situ NMR and IR Spectroscopy

The reaction of methane with copper-exchanged mordenite with two different Si/Al ratios was studied by means of in situ NMR and infrared spectroscopies. The detection of NMR signals was shown to be possible with high sensitivity and resolution, despite the presence of a considerable number of paramagnetic Cu^II species. Several types of surface-bonded compounds were found after reaction, namely molecular methanol, methoxy species, dimethyl ether, mono- and bidentate formates, Cu^I monocarbonyl as well as carbon monoxide and dioxide, which were present in the gas phase. The relative fractions of these species are strongly influenced by the reaction temperature and the structure of the copper sites and is governed by the Si/Al ratio. While methoxy species bonded to Brønsted acid sites, dimethyl ether and bidentate formate species are the main products over copper-exchange mordenite with a Si/Al ratio of 6; molecular methanol and monodentate formate species were observed mainly over the material with a Si/Al ratio of 46. These observations are important for understanding the methane partial oxidation mechanism and for the rational design of the active materials for this reaction.     

Water Catalysis of the Reaction of Methanol with OH Radical in the Atmosphere is Negligible

Faced with the contradictory results of two recent experimental studies [Jara‐Toro et al., Angew. Chem. Int. Ed. 2017 , 56, 2166 and Chao et al., Angew. Chem. Int. Ed. 2019 , 58, 5013] of the possible catalytic effect of water vapor on CH₃OH + OH reaction, we report calculations that corroborate the conclusion made by Chao et al. and extend the rate constant evaluation down to 200 K. The rate constants of the CH₃OH + OH reaction catalyzed by a water molecule are computed as functions of temperature and relative humidity using high‐level electronic structure and kinetics calculations. The Wuhan–Minnesota Scaling (WMS) method is used to provide accurate energetics to benchmark a density functional for direct dynamics. Both high‐frequency and low‐frequency anharmonicities are included. Variational and tunneling effects are treated by canonical variational transition state theory with multidimensional small‐curvature tunneling. And, most significantly, we include multistructural effects in the rate constant calculations. Our calculations show that the catalytic effect of water vapor is not observable at 200–400 K.     

Crystallization Mechanism of 9,9-Diphenyl-dibenzosilole from Solids

Organic semiconductor (OSC) crystals have great potential to be applied in many fields, as they can be flexibly designed according to the demands and show an outstanding device performance. However, OSCs with the capacity of solid-state crystallization (SSC) are developing too slowly to meet demands in productions and applications, due to their difficulties in molecular design and synthesis, unclear mechanism and high dependence on experimental conditions. In this work, in order to solve the problems, we synthesized an organic semiconductor capable of SSC at room temperature by adjusting the relationship between conjugated groups and functional groups. The thermodynamic and kinetic properties have been studied to discover the model of film SSC. Moreover, it can be purposefully controlled to prepare the high-quality crystals, and their corresponding organic electronic devices were further fabricated and discussed.     

Two-dimensional tellurium saturable absorber for ultrafast solid-state laser

Two-dimensional(2 D) Te nanosheets were successfully fabricated through the liquid-phase exfoliation(LPE) method. The nonlinear optical properties of 2 D Te nanosheets were studied by the open-aperture Z-scan technique. Furthermore, the continuous wave mode-locked Nd:YVO_4 laser was successfully realized by using 2 D Te as a saturable absorber(SA) for the first time, to the best of our knowledge. Ultrashort pulses as short as 5.8 ps were obtained at 1064.3 nm with an output power of 851 m W. This primary investigation indicates that the 2 D Te SA is a promising photonic device in the fields of ultrafast solid-state lasers.     

Chain transfer and living functionalization of polymethacrylates by group transfer polymerization using ethyl 2-Phenyl-2-butenoate

A living functionalization method has been investigated for group transfer polymerization (GTP) of poly(alkyl methacrylates) using ethyl 2-phenyl-2-butenoate (EPB). The end-capping reactions of EPB to living trimethylsilyl ketene acetal-ended poly(methyl methacrylate) (PMMA) chain ends have been systematically studied and characterized by SEC, VPO, UV-visible spectrosocopy, ¹H and ¹³c NMR spectroscopy. The results of sequential monomer addition, varying stoichiometry and copolymerization indicate that EPB effects efficient chain end functionalization only at stoichiometric concentrations; chain transfer reactions (chain transfer constant = 0.4) occur with excess EPB and during copolymerization with MMA. Chain transfer reactions (chain transfer constant = 0.1) also occur when copolymerizing ethyl 2-methyl-2-butenoate with MMA.