上海光源储存环磁聚焦结构设计

上海光源是一台正在建设中的低发射度第三代同步辐射光源. 经过优化后, 储存环有两种直线节长度, 周长432m,在能量3.5GeV下束流发射度为3.9nm.rad, 直线节处的β函数和色散函数有足够的调节范围. 跟踪研究表明, 即使带上磁铁高阶场误差, 储存环仍有足够大的动力学孔径和能量接受度.     

双原子分子振动能级半量子化及量子理论的数值计算

利用半经典量子化理论和量子理论，分别采用Ｌｅｎｎａｒｄ－Ｊｏｎｅｓ势和Ｍｏｒｓｅ势，对双原子分子的振动能级给予了较为详细的数值计算。并将所得结果与部分实验数据进行比较，峄双原子分子的振动能级作了较为详细的 讨论。     

Defect-induced failure of optical coating filters

Optical filters composed of Ag, Al₂O₃, and ZnSe films were prepared on BK7 substrates by evaporation. By employing spectrophotometer, microscope, scanning electron microscope (SEM), and energy dispersive spectrum (EDS) analysis, the moisture-dependent stability of the samples was tested. The experimental results revealed that filter failure often occurs initially at defect sites. Small sputtering particles and pinhole are found to be two types of defects that induced the optical coating filter failure. The mechanisms of the defect-induced failure of the filters also are discussed in the article.     

爆电换能脉冲大电流输出研究

 基于爆电换能原理,使用掺铌的PZT 95/5陶瓷组装换能器件,在垂直工作模式下,对爆电电源LRC电路响应进行了理论分析,并开展了脉冲大电流输出实验研究。实验采用多组PZT 95/5铁电陶瓷并联,利用平面波发生器作为冲击加载手段,获得了峰值5 kA以上的脉冲大电流,初始电流上升速率可达10~20 GA/s。实验结果与理论设计符合较好。     

新型脱硅剂水合碳铁酸钙合成过程的光谱学研究

亚熔盐溶出一水硬铝石型铝土矿过程中需在高浓介质条件下脱除二氧化硅杂质,研究采用合成水合碳铁酸钙做为脱硅剂;因水合碳铁酸钙合成过程中会有碳酸钙、氢氧化钙、铁酸钙等副产物,故合成条件对水合碳铁酸钙含量及脱硅效果有重要影响。为了探讨反应机理并优化合成参数, 研究采用傅里叶变换红外光谱(FTIR)、电感耦合等离子发射光谱(ICP-AES)分析对合成过程产物进行了物相分析和脱硅实验。FTIR和脱硅过程元素分析表明水合碳铁酸钙在水溶液中为介稳物质,反应温度和反应时间对水合碳铁酸钙的合成具有重要影响,随时间和温度增加水合碳铁酸钙含量先增加后减少;单因素条件下最优的合成条件为, 反应温度30 ℃,反应时间16 h,反应液固比20,搅拌强度500 r·min-1;对最优条件下合成水合碳铁酸钙的物相结构进行了研究,表明水合碳铁酸钙为斜方六面体晶体结构,其中存在结晶水、羟基、Fe—O特征峰。     

铜铟镓硒太阳能电池多层膜的结构分析

对于溅射后硒化和共蒸发等方法制备的铜铟镓硒（CIGS）太阳能电池薄膜,利用多种分析方法研究了CIGS多层膜的复杂结构等．研究表明：卢瑟福背散射（RBS）在分析CIGS多层膜方面具有其独特优势和可靠的结果;溅射后硒化方法制备的CIGS薄膜中,Ga和In在CIGS薄膜中呈梯度分布,这种Ga表层少而内层多的不均匀分布与Mo层没有必然关系;RBS和俄歇电子能谱分析（AES）均显示CIGS太阳能电池器件多层膜界面处存在扩散,尤其是CdS与CIGS,Mo与CIGS的界面处;X射线荧光（XRF）结果表明,电池效率最高的CIGS层中In,Ga比例为In：Ga=0．7：0.3;X射线衍射（XRD）结果显示：退火后的CIGS／Mo薄膜结晶品质得到了优化．     

Monte Carlo simulations for 20 MV X-ray spectrum reconstruction of a linear induction accelerator

To study the spectrum reconstruction of the 20 MV X-ray generated by the Dragon-I linear induction accelerator, the Monte Carlo method is applied to simulate the attenuations of the X-ray in the attenuators of different thicknesses and thus provide the transmission data. As is known, the spectrum estimation from transmission data is an ill-conditioned problem. The method based on iterative perturbations is employed to derive the X-ray spectra, where initial guesses are used to start the process. This algorithm takes into account not only the minimization of the differences between the measured and the calculated transmissions but also the smoothness feature of the spectrum function. In this work, various filter materials are put to use as the attenuator, and the condition for an accurate and robust solution of the X-ray spectrum calculation is demonstrated. The influences of the scattering photons within different intervals of emergence angle on the X-ray spectrum reconstruction are also analyzed.     

InN量子点的液滴外延及物性表征

由于1. 55μm波段广泛应用于通信领域,为了探索不同生长温度对InN量子点的形貌影响,并且实现自组装InN量子点在1. 55μm通信波段的发光,对InN量子点的液滴外延及物性进行了相关研究。首先利用射频等离子体辅助分子束外延(PA-MBE)技术在GaN模板上,采用液滴外延方法在3种温度下生长了InN量子点结构。生长过程中靠反射高能电子衍射(RHEED)对样品进行原位监控。原子力显微镜(AFM)表征结果表明随着生长温度升高,量子点尺寸变大,密度减小。在生长温度350℃和400℃下,观测到了量子点;当温度高于450℃时,未观测到InN量子点。当生长温度为400℃时,量子点形貌最好,密度为6×10~8/cm~2,对400℃下生长的InN量子点进行了变温PL测试,成功得到InN量子点在1. 55μm波段附近的光致发光,并且随着测试温度的升高,量子点的发光峰位发生了先红移后蓝移最后又红移的S型曲线变化,这种量子点有望在未来应用于量子通信领域。     

Calculation of the reactor neutron time of flight spectrum by convolution technique

It is a very complex and time-consuming process to simulate the nuclear reactor neutron spectrum from the reactor core to the export channel by applying a Monte Carlo program. This paper presents a new method to calculate the neutron spectrum by using the convolution technique which considers the channel transportation as a linear system and the transportation scattering as the response function. It also applies Monte Carlo Neutron and Photon Transport Code （MCNP） to simulate the response function numerically. With the application of convolution technique to calculate the spectrum distribution from the core to the channel, the process is then much more convenient only with the simple numerical integral numeration. This saves computer time and reduces some trouble in re-writing of the MCNP program.     

弯曲波导之间的耦合分析

采用极坐标下的光束传播法分析了两条平行变曲波导的中心间距、曲率半径等因素对模式耦合的影响,得到了耦合长度、耦合强度随中心间距、曲率半径的变化规律,并将直波导作为变曲波导的一种特殊情况进行了分析.