Experimental Charge Density Evidence for Pnicogen Bonding in a Crystal of Ammonium Chloride

Chemical binding in crystalline ammonium chloride, a simple inorganic salt with an unexpectedly complex bonding pattern, was studied by using a topological analysis of electron density function derived from high‐resolution X‐ray diffraction. Supported by periodic quantum chemical calculations, it provided experimental evidence for weak σ‐hole bonds (1.5 kcal mol^?1) that involve ammonium cations in a crystal. Our results show this type of supramolecular interaction to be more numerous than has been found to date by using gas‐phase calculations or statistical analysis of CSD.     

An Efficient Halogen‐Free Electrolyte for Use in Rechargeable Magnesium Batteries

Unlocking the full potential of rechargeable magnesium batteries has been partially hindered by the reliance on chloride‐based complex systems. Despite the high anodic stability of these electrolytes, they are corrosive toward metallic battery components, which reduce their practical electrochemical window. Following on our new design concept involving boron cluster anions, monocarborane CB₁₁H₁₂^? produced the first halogen‐free, simple‐type Mg salt that is compatible with Mg metal and displays an oxidative stability surpassing that of ether solvents. Owing to its inertness and non‐corrosive nature, the Mg(CB₁₁H₁₂)₂/tetraglyme (MMC/G4) electrolyte system permits standardized methods of high‐voltage cathode testing that uses a typical coin cell. This achievement is a turning point in the research and development of Mg electrolytes that has deep implications on realizing practical rechargeable Mg batteries.     

Low-temperature thermodynamic properties of <Emphasis Type="Italic">L</Emphasis>-cysteine

Heat capacity C _p(T) of the orthorhombic polymorph of L-cysteine was measured in the temperature range 6–300 K by adiabatic calorimetry; thermodynamic functions were calculated based on these measurements. At 298.15 K the values of heat capacity, C _p; entropy, S _m⁰(T)-S _m⁰(0); difference in the enthalpy, H _m⁰(T)-H _m⁰(0), are equal, respectively, to 144.6±0.3 J K⁻¹ mol⁻¹, 169.0±0.4 J K⁻¹ mol⁻¹ and 24960±50 J mol⁻¹. An anomaly of heat capacity near 70 K was registered as a small, 3–5% height, diffuse ‘jump’ accompanied by the substantial increase in the thermal relaxation time. The shape of the anomaly is sensitive to thermal pre-history of the sample.     

Amidation of deltacyclene and hexacyclic norbornadiene dimers with acetonitrile and water catalyzed by FeCl3·6H2O

Abstract

FeCl₃·6H₂O-catalyzed Ritter amidation of deltacyclene and hexacyclic norbornadiene dimers containing both a double bond and a three-carbon ring in the molecule with acetonitrile and water was performed. Depending on the hydrocarbon structure, the reaction proceeds via C-C bond cleavage in the three-carbon ring or at the double bond to form the corresponding N-acetamides.     

Hydration and dielectric properties of aqueous solutions of protonated diallylmethylammonium polymer: transition from monomer to polymer

Abstract

The high-frequency dielectric relaxation of aqueous solutions of protonated diallylammonium polyelectrolyte, namely poly(diallylmethylammonium trifluoroacetate) has been studied at the maximum water dispersion frequencies, 7.5–25?GHz, and temperatures of 288, 298, and 308?K. Dielectric relaxation parameters have been calculated and compared with similar characteristics of aqueous solutions of monomer, diallylmethylammonium trifluoroacetate, and pyrrolidinium trifluoroacetate salt simulated structure of pyrrolidinium polymer link. It has been concluded that although the monomer features hydrophobic hydration, its polymer exhibits hydrophilic hydration properties. This change is related to conformation of hydrophilic-hydrophobic polycations in aqueous solutions and the change in the structure of polymer links.     

MVF Sensor Enables Analysis of Nucleic Acids with Stable Secondary Structures

One major challenge in nucleic acids analysis by hybridization probes is a compromise between the probe's tight binding and sequence‐selective recognition of nucleic acid targets folded into stable secondary structures. We have been developing a four‐way junction (4WJ)‐based sensor that consists of a universal stem‐loop (USL) probe immobilized on an electrode surface and two adaptor strands (M and F). The sensor was shown to be highly selective towards single base mismatches at room temperature, able to detect multiple targets using the same USL probe, and have improved ability to detect folded nucleic acids. However, some nucleic acid targets, including natural RNA, are folded into very stable secondary and tertiary structures, which may represent a challenge even for the 4WJ sensors. This work describes a new sensor, named MVF since it uses three probe stands M, V and F, which further improves the performance of 4WJ sensors with folded targets. The MVF sensor interrogating a 16S rRNA NASBA amplicon with calculated folding energy of ?32.82 kcal/mol has demonstrated 2.5‐fold improvement in a signal‐to‐background ratio in comparison with a 4WJ sensor lacking strand V. The proposed design can be used as a general strategy in the analysis of folded nucleic acids including natural RNA.     

Competition between non-classical and classical hydrogen bonded sites in [BH3CN]: Spectral, energetic, structural and electronic features

Interaction of the salt (Ph₃PNPPh₃)BH₃CN with the various OH and NH proton donors in low polar media was studied by variable temperature (200–290 K) IR spectroscopy and theoretically by DFT calculations. The formation of two types of complexes containing non-classical dihydrogen bond to the hydride hydrogen (DHB) and classical hydrogen bond (HB) to nitrogen lone pair was shown in solution. The 1:1 complexes of both types (XHH and XHN) coexist in the presence of equimolar amount of proton donor. The addition of excess XH-acid leads to the increase of the classical HB content and appearance of the 1:2 complexes, where two basic sites work simultaneously. The structure, spectral characteristics, energy and electron redistribution were studied by DFT (B3LYP) method. The comparison DHB parameters of [BH₃CN]⁻ with those of the unsubstituted analogue [BH₄]⁻ allowed analyzing the electronic effects of the CN group on the basic properties of boron hydride moiety. The electronic influence of the BH₃ group on CN⁻HX hydrogen bond was also established by comparison with the corresponding classical HB to the CN⁻ anion.     

Microtiterplate phosphate assay based on luminescence quenching of a terbium complex amenable to decay time detection

We describe a terbium-ligand complex (TbL) for a microtiterplate assay for phosphate (P) in the 0.3-100 μmol L⁻¹ range based on luminescence quenching. As the pH optimum is at neutral pH (7.4) the probe is quenched by both, primary (H₂PO₄⁻) and secondary phosphate (HPO₄²⁻). The LOD is 110 nmol L⁻¹. A Stern-Volmer study revealed that quenching is mostly static. Due to the ms-decay time of TbL, the first luminescence lifetime assay for phosphate could also be developed. The lifetime-based calibration plot is linear between 0.5 and 5 μmol L⁻¹ of P. The effect of various surfactants on assay performance and a study on interferents are presented. The probe was successfully applied to determination of P in commercial plant fertilizers and validated against the molybdenum blue test. The probe is the most sensitive lanthanide-based probe for phosphate.     

Mutable Lewis and Brønsted acidity of aluminated SBA-15 as revealed by NMR of adsorbed pyridine-15N

(1)H and variable-temperature (15)N NMR techniques have been used to study the effect of the gradual alumination of SBA-15 on the structure and adsorption properties of this mesoporous material. The interpretation of experimental spectra suggests that aluminum chlorhydrol most effectively reacts with silica surfaces in the confinement of the cavities of rough mesopore walls, instead of forming a homogeneous aluminum film. This first leads to a gradual filling of the cavities and finally results in aluminum islands on the inner surfaces of mesopores. In the sample with a Si/Al atomic ratio of 4.1, up to half of the inner surface area of the mesopores is covered with aluminum. The alumination produces Br?nsted acid sites attributed to silanol groups interacting with aluminum but does not affect the proton-donating ability of isolated silanol groups. At high Si/Al ratios, the surface contains only one type of Lewis site attributed to tetracoordinated aluminum. At lower Si/Al ratios, Lewis acid sites with a lower electron-accepting ability appear, as attributed to pentacoordinated aluminum. The numerical values of the surface densities of all chemically active sites have been estimated after annealing at 420 and 700 K. We were surprised to observe that gaseous nitrogen can occupy Lewis acid sites and hinder the interaction of the aluminum with any other electron donor. As a result, aluminated surfaces saturated with nitrogen do not exhibit any Br?nsted or Lewis acidity. At room temperature, it takes days before pyridine replaces nitrogen at the Lewis acid sites.