Ion generation from Al-laser-produced plasma

Particle diagnostics of Al-laser-produced plasma based on ion collectors identified three groups of emitted ions. Their velocity distributions were analyzed to obtain the mean ion energy, energy and charge carried by ions, including the angular distributions of these quantities. The electron temperature evaluated from these measurements was compared with X-ray results. A satisfactory agreement between the two sets of data was found. In both the cases the electron temperature grows only very slowly with the incident laser power. Origin of different ion groups is discussed. Iodine photodissociation laser system PERUN was used as a driver.     

高性能MgB2长线材制备及性能表征

采用原位粉末装管工艺,分别以Mg粉(99.5%),无定形B粉(99.9%)为原料,以纳米SiC(10-30 nm)作为掺杂材料制备铁基MgB2线.首先将已混合的原料在丙酮介质中球磨,真空干燥后,将粉末填入铁管内,然后通过孔型轧制、旋锻和拉拔等冷加工工艺得到11 m长外径Ф1.75 mm铁基MgB2超导线.用扫描电镜,电子能谱,X射线衍射仪和超导量子干涉仪测试发现,样品微观结构整齐,晶粒大小均匀,内部仅含微量MgO,TC(onset)= 35.1 K,ΔTC＝5.3 K.纳米SiC掺杂后,其中C造成MgB2晶格畸变,形成有效磁通钉扎中心,C元素在MgB2中分布均匀.标准四引线测试结果表明,11 m线均分10段后,各点的Jc(4.2 K,10 T)均超过1.0×104 A/cm2,最高值达到1.2×104 A/cm2.在10-18T范围各点临界电流值分布均匀,变化率小于10%.     

一种显示器投影成象系统的彩色图象几何畸变校正方法

显示器投影成象系统是解决数字图象输出的一种设备,它可将显示器荧屏上的图象(可来自数码相机、光盘、计算机等)扩印在普通彩色相纸上.由于光学镜头会产生几何畸变,加之显示器表面有一定弧度,因此成象在相纸上的图象存在着非线性的畸变.本文主要介绍了如何用数字图象处理的方法对显示器投影成象系统的图象进行几何畸变校正,并对其软件实现进行了简单的讨论.     

全通光均衡器色散补偿传输系统性能的研究

本文以数值求解非线性薛定谔方程为主要分析手段,对全通光均衡器色散补偿传输系统的性能进行了研究.对单波长传输系统的数值模拟结果表明:系统工作波长和光均衡器谐振波长的稳定性对补偿效果影响显著.提出了适合波分复用系统中进行色散补偿的光均衡器参量,并进行了数值模拟,结果表明:对于信道速率为10Gb/s、常规单模光纤组成的波分复用系统采用单个光均衡器可同时对6个信道进行色散补偿,传输距离可达100km左右.     

有限维希尔伯特空间非简谐振子广义相干态

在有限维希尔伯特空间中构造了非简谐振子的广义相干态,并研究了其量子统计特性。详细地讨论了该量子态的压缩效应和反聚束效应,得到了出现压缩的条件并给陋了反聚束效应与有限维希尔伯特空间维数关系的数值计算结果。理论计算表明该量子态存在压缩效应和反聚束效应,这与通常的无限维空间中的广义相干态是完全不同的。     

New exact solutions of a （3＋1）-dimensional Jimbo-Miwa system

By using the (G'/G)-expansion method and the variable separation method, a new family of exact solutions of the (3+1)-dimensional Jimbo-Miwa system is obtained. Based on the derived solitary wave solutions, we obtain some special localized excitations and study the interactions between two solitary waves of the system.     

FAIR项目Super-FRS超导二极磁铁测试线圈的三维失超数值模拟

国际反质子与离子研究装置(FAIR)项目中的Super-FRS超导二极磁铁是一个大型温铁结构的超导磁体,由中国负责设计、研制和测试。为了研究超导线圈的性能和其设计的可靠性,前期研制了一个测试线圈。建立了一个基于ANSYS和OPERA 3D的三维失超模型,不仅将模拟结果和实验数据进行对比,更可以获得失超过程的更多细节。模型将环氧浸渍的超导线圈简化为各项异性连续介质。将ANSYS求解器用于瞬态传热过程的分析,OPERA 3D用于磁场计算,并采用ANSYS脚本语言（APDL）进行焦耳热的计算和保护电路方程的求解。模拟得到了温度、电压、电流随时间的变化曲线和失超传播过程。最后将模拟结果和测试线圈的测试结果进行了比较。     

Pairing-energy coefficients of neutron-rich fragments in spallation reactions

The ratio of pairing-energy coefficient to temperature(a_p/T)of neutron-rich fragments produced in spallation reactions has been investigated by adopting an isobaric yield ratio method deduced in the framework of a modified Fisher model.A series of spallation reactions,0.5A and 1A Ge V~(208)Pb+p,1A Ge V~(238)U+p,0.5A Ge V~(136)Xe+d,0.2A,0.5A and 1A Ge V~(136)Xe+p,and~(56)Fe+p with incident energy ranging from 0.3A to 1.5A Ge V,has been analysed.An obvious odd-even staggering is shown in the fragments with small neutron excess(I≡N-Z),and in the relatively small-A fragments which have large I.The values of a_p/T for the fragments,with I from 0 to36,have been found to be in a range from-4 to 4,and most values of a_p/T fall in the range from-1 to 1.It is suggested that a small pairing-energy coefficient should be considered in predicting the cross sections of fragments in spallation reactions.It is also concluded that the method proposed in this article is not good for fragments with A/A_s85%(where A_(s )is the mass number of the spallation system).     

Nuclear axial currents from scale-chiral effective field theory

By incorporating hidden scale symmetry and hidden local symmetry in the nuclear effective field theory,combined with the double soft-pion theorem, we predict that the Gamow-Teller operator coming from the space component of the axial current should remain unaffected by the QCD vacuum change caused by the baryonic density,whereas the first forbidden beta transition operator coming from the time component should be strongly enhanced.While the latter has been confirmed for some time, the former was given support by a powerful recent ab initio quantum Monte Carlo calculation for light nuclei, which also confirmed the old?chiral filter hypothesis." Formulated in terms of the Fermi-liquid fixed point structure of strong-coupled nuclear interactions, we offer an extremely simple resolution to the long-standing puzzle of the?quenched g A," g_A~(eff) ≈1 [1], found in nuclear Gamow-Teller beta transitions, giant Gamow-Teller resonances, and double beta decays.     

Micromechanism of sulfurizing activated carbon and its ability to adsorb mercury

The effect of ambient environment (dry or wet) and overlapping laser pulses on the laser ablation performance of brass has been investigated. For this purpose, a Q-switched, frequency doubled Nd:YAG laser with a wavelength of 532 nm, pulse energy of 150 mJ, pulse width of 6 ns and repetition rate of 10 Hz is employed. In order to explore the effect of ambient environments, brass targets have been exposed in deionized water, methanol and air. The targets are exposed for 1000, 2000, 3000 and 4000 succeeding pulses in each atmosphere. The surface morphology and chemical composition of ablated targets have been characterized by using Scanning Electron Microscope (SEM), Atomic Force Microscope (AFM) and Attenuated Total Reflection (ATR) techniques. In case of liquid environment, various features like nano- and micro-scale laser-induced periodic surface structures with periodicity 500 nm–1 μm, cavities of size few micrometers with multiple ablative layers and phenomenon of thermal stress cracking are observed. These features are originated by various chemical and thermal phenomena induced by laser heating at the liquid–solid interfaces. The convective bubble motion, explosive boiling, pressure gradients, cluster and colloid formation due to confinement effects of liquids are possible cause for such kind of features. The metal oxides and alcohol formed on irradiated surface are also playing the significant role for the formation of these kinds of structure. In case of air one huge crater is formed along with the redeposition of sputtered material and is ascribed to laser-induced evaporation and oxide formation.