Anomalous heat evolution of deuteron implanted al upon electron bombardment III - try to observe the nuclear d-d reaction

In previous papers, one of the authors (K. K.) has observed the anomalous melting of the surface layer of deuteron implanted Al, containing so-called "tunnel structures", on the electron bombardment in transmission electron microscope. In the present paper, we intended to observe the evidence of the d-d nuclear reaction, expecting neutron emission, associated with the melting phenomenon. However, the result was rather unexpected. The melting phenomenon was certainly observed under the same experimental conditions as before. But, in spite of the melting, neutron emission associated with the nuclear reaction was not observed. And, more unexpectedly, X-ray emission of energy less than roughly 400 v keV was observed when specimens with a bubble structure, which never showed melting, were bombarded with electron beams. Several conceivable mechanisms are discussed which, however, are all not convincing to explain the melting. The melting is attributed to some excess energy generation. The error estimation of the radiation measurements was undertaken.     

Site selection NMR study on electronic state in and near vortex core of YBa2Cu4O8

We report a site-selective ¹⁷O spin-lattice relaxation rate T₁⁻¹ in the vortex state of YBa₂Cu₄O₈. We found that T₁⁻¹ at the planar sites exhibits an unusual nonmonotonic NMR frequency dependence. Based on T₁⁻¹ in the vortex core region, we establish strong evidence that the local density of states within the vortex core is strongly reduced.     

LET distributions from CR-39 plates on Space Shuttle missions STS-84 and STS-91 and a comparison of the results of the CR-39 plates with those of RRMD-II and RRMD-III telescopes

The LET distributions during the Space Shuttle missions STS-84 (altitude 270-412 km, average 375 km; inclination angle, 51.6 degrees) and STS-91 (altitude 328-397 km, average 373 km; inclination angle, 51.6 degrees) were measured using CR-39 plastic nuclear track detectors. A correction for the dip-angle dependence of the track-formation sensitivity of the CR-39 plates was applied to the data analysis. The absorbed doses and the dose equivalents around RRMD Detector Units, estimated from the LET distributions in the LET region of 4-200 keV/micrometers, fluctuated with standard deviations of +/- 21% to +/- 35% in both flight experiments. The LET distributions obtained from the CR-39 plates agreed well with that obtained from RRMD-II in STS-91. However, the particle fluxes obtained from RRMD-III in STS-84 and STS-91 were two or three times higher than those obtained from RRMD-II and the CR-39 plates. It was concluded that the LET distributions obtained from RRMD-II and the CR-39 plates in the present flight experiments did not include the contribution of target-fragmented secondary heavy particles produced by low-LET particles, such as relativistic or semi-relativistic protons and helium ions, whereas RRMD-III was able to detect these secondary particles because of its low triggering level.     

10-Gbit/s optical receiver using ICs with low-capacitance HBT technology

A 10-Gbit/s optical receiver is developed using low-capacitance HBT IC technology. The HBT allows a cutoff frequency of 45 GHz and a maximum oscillation frequency of 70 GHz. The receiver contains an automatic gain-control amplifier IC with a gain of 16 dB, a bandwidth of 10.7 GHz, and a decision-circuit IC with an ambiguity of 66 mVp-p at a data rate of 10 Gbit/s. The sensitivity of this receiver is -26.5 dBm at a bit error rate of 10^-9. Transmission over a 140-km fiber was achieved successfully.     

Raman probe using a single hollow waveguide

A simple Raman probe was realized using a single flexible hollow waveguide (HW). A HW coated with a silver film, which had reasonable transmission and little optical background noise, was used as a bidirectional transmission fiber for both the excitation and collection of Raman scattered light. The HW itself generated no Raman scattering or fluorescence noise during transmission. A complex filtering system at the end of the waveguide was thus unnecessary. In addition, the measured Raman spectra showed better signal-to-noise ratios than a conventional Raman fiber probe. The HW's suitability as a Raman fiber probe was also demonstrated.     

Perturbations of Solitons and Solitary Waves

A direct perturbation method is developed to investigate the evolution of solitary waves in the presence of small perturbations. A uniformly valid first order solution is constructed. The method is applied to several nonlinear evolution equations which support solitons or solitary waves. Finally, the method is compared with other approaches in the literature.     

9.4 nm Tunable Vertically Coupled Microring Resonator Filter by Thermo-Optic Effect

A wide range (9.4nm) tuning of vertically coupled microring resonator filter was demonstrated utilizing a large TO coefficient of polymer. The power consumption was about 60mW and no degradation of filter response was observed.     

Oblique-Incidence Characteristics of a Parallel-Aligned Nematic-Liquid-Crystal Spatial Light Modulator

We have developed optically-addressed and electrically-addressed liquid crystal spatial phase-only light modulators having no pixelized structures. We obtained a large depth of phase-only modulation and high diffraction efficiency based on the electro-optical characteristics of a parallel-aligned nematic liquid crystal. These spatial light modulators (SLM) are of the reflection type, so there would be a loss of power in the readout light from the half mirror, which was set up so as to separate the incident and reflected lights. To optimize the characteristics of a reflection type spatial phase-only light modulator, we have proposed an oblique incident optical readout setup. We have examined the effect of conditions such as the polarization direction and the incidence angle of the readout light, and the orientation of liquid crystal molecules in the SLM. High diffraction efficiency close to the theoretical maximum value was obtained by adjusting the above conditions. The simulation analysis can well explain the experimental results of phase modulation.     

A structural study of CN treated amorphous silicon

Recently, a remarkable technique to overcome the problem of light-induced degradation in amorphous silicon (a-Si) solar cells using a cyanide (CN) treatment has been developed. Structural and bonding characteristics of CN in a-Si has been studied using ab initio molecular dynamics simulations. It was found that CN incorporation results in more than just the termination of dangling bonds. The connectivity of the covalent random network increases because the CN changes from triply bonded, which is a common form in molecular CN, to the singly bonded form. This may be the mechanism by which CN incorporation produces significant reductions in light-induced degradation.