Correlation between oxygen consumption and photobleaching during in vitro photodynamic treatment with ATX-S10.Na(II) using pulsed light excitation: dependence of pulse repetition rate and irradiation time

We revealed that in ATX-S10.Na(II)(13,17-bis (1-carboxypropionyl) carbamoylethyl-8-etheny-2-hydroxy-3-hydroxyiminoethylidene-2,7,12,18-tetraethyl porphyrin sodium)-mediated photodynamic therapy using 667 nm nanosecond-pulsed light excitation at a peak intensity of 2.0 MW/cm(2), phototoxicity increased with decreasing pulse repetition rate in the range of 5-30 Hz for A549 cell cultures. To examine the relation between the reaction mechanism and measured phototoxicity, we carefully measured the kinetics of photochemical oxygen consumption and photobleaching during irradiation of ATX-S10.Na(II)-sensitized A549 monolayer cultures. Measurements of oxygen consumption with a microelectrode, which was performed just above the cells, showed that there was no significant difference between the magnitudes of decrease in oxygen at the three repetition rates at the same cumulative fluence. Loss of ATX-S10.Na(II) fluorescence intensity also exhibited little repetition rate dependence when compared at the same cumulative fluence. We investigated the correlation between oxygen consumption and photobleaching during irradiation and obtained "fluorescence-oxygen diagrams." The diagrams showed dynamic changes between oxygen-dependent and oxygen-independent photobleaching at the higher repetition rates of 10 and 30 Hz, whereas such change was not clearly seen over the whole irradiation time at 5 Hz. These results suggest that the reduced phototoxicity at high repetition rates might be due to an oxygen-independent reaction. We presumed that the change in the reaction mechanism was associated with the local concentrations of the photosensitizer and oxygen in cells during irradiation.     

Synthesis of the ABCD ring of gambierol

A fully functionalized ABCD ring moiety of gambierol, a marine polycyclic ether toxin, was synthesized by the use of the oxiranyl anion strategy and reductive cycloetherification of a beta,delta-dihydroxy ketone.     

Robust and simple interface for microchip electrophoresis-mass spectrometry

A robust and simple interface for microchip electrophoresis-mass spectrometry (MCE-MS) was developed using a spray nozzle connected to the exit of the separation channel of the microchip. The spray nozzle was attached to the microchip using a polyether ether ketone screw without adhesive, thus allowing easy replaced. Sample injection and electrophoretic separation was performed by control of the voltage only. The analysis of a few basic drugs was performed using the optimized MCE-MS system. The separation was improved by using a high-viscosity separation buffer and a spray nozzle with a small bore size. This system was also applied to the separation of peptides and protein-trypsin digests. Sample adsorption was minimized by adding acetonitrile to the separation buffer when using a quartz microchip.     

Synthesis of trans-fused polycyclic ethers with angular methyl groups using sulfonyl-stabilized oxiranyl anions

An efficient method has been developed for the synthesis of trans-fused tetrahydropyrans with angular methyl groups adjacent to the ring oxygen. The procedure involves the coupling reaction of a sulfonyl-stabilized oxiranyl anion with an appropriate triflate followed by 6-endo cyclization, and is effective for the construction of 6/6- and 6/7/6-cyclic ether ring systems with sterically congested 1,3-diaxial methyl groups.     

Iterative synthesis of the ABCDEF-ring system of yessotoxin and adriatoxin

A stereocontrolled linear synthesis of the ABCDEF-ring system of yessotoxin and adriatoxin, diarrhetic shellfish toxins, is described. Iterative application of a tetrahydropyran synthesis by reaction of the alkylation of a sulfonyl-stabilized oxiranyl anion followed by 6-endo cyclization of a 4,5-epoxy alcohol led to the synthesis of the trans-fused hexacyclic ether system, and the seven-membered E ring was constructed by ring expansion reaction.     

Photodegradation of polyethylene in the presence of ferric chloride

Effects of ferric chloride (FeCl₃) on photodegradation of high-density polyethylene (PE) were investigated by using ESR and infrared spectrometry. In the system with irradiation at light of λ > 220 nm, PE irradiated at 77°K yielded an 8-line spectrum, the intensity of which was markedly weakened by using FeCl₃ with the sample, indicating a distinct depression of radical formation. On the other hand, PE with the use of FeCl₃ yielded radicals under irradiation only with light of λ > 300 nm, showing a singlet spectrum with a line width of 15 gauss. For photooxidized PE, almost the same effect of FeCl₃ was observed. On irradiation at room temperature, PE samples with and without FeCl₃ showed a singlet spectrum with line widths of 15 and 25 gauss, respectively. On the other hand, the unsaturated double bond contained in a small amount in PE sample was observed by infrared study to be decreased with photoirradiation; however, the decrease was sharply depressed with the addition of FeCl₃ to the sample. The degradation of carbonyl group in a photooxidized sample was markedly affected by photoirradiation, and the decay was obviously reduced for the sample on addition of FeCl₃. It is concluded that FeCl₃ works upon photodegradation of PE to enhance the Norrish type II reaction and to accelerate the formation of unsaturated double bond in the chain.     

Blue copper model complexes with distorted tetragonal geometry acting as effective electron-transfer mediators in dye-sensitized solar cells

The electron self-exchange rate constants of blue copper model complexes, [(-)-sparteine-N,N'](maleonitriledithiolato-S,S')copper ([Cu(SP)(mmt)])(0/)(-), bis(2,9-dimethy-1,10-phenanthroline)copper ([Cu(dmp)(2)](2+/+)), and bis(1,10-phenanthroline)copper ([Cu(phen)(2)](2+/+)) have been determined from the rate constants of electron transfer from a homologous series of ferrocene derivatives to the copper(II) complexes in light of the Marcus theory of electron transfer. The resulting electron self-exchange rate constant increases in the order: [Cu(phen)(2)](2+/+) < [Cu(SP)(mmt)](0/)(-) < [Cu(dmp)(2)](2+/+), in agreement with the order of the smaller structural change between the copper(II) and copper(I) complexes due to the distorted tetragonal geometry. The dye-sensitized solar cells (DSSC) were constructed using the copper complexes as redox couples to compare the photoelectrochemical responses with those using the conventional I(3)(-)/I(-) couple. The light energy conversion efficiency (eta) values under illumination of simulated solar light irradiation (100 mW/cm(2)) of DSSCs using [Cu(phen)(2)](2+/+), [Cu(dmp)(2)](2+/+), and [Cu(SP)(mmt)](0/)(-) were recorded as 0.1%, 1.4%, and 1.3%, respectively. The maximum eta value (2.2%) was obtained for a DSSC using the [Cu(dmp)(2)](2+/+) redox couple under the light irradiation of 20 mW/cm(2) intensity, where a higher open-circuit voltage of the cell was attained as compared to that of the conventional I(3)(-)/I(-) couple.     

Reactivities of Stable Rotamers: XLIV. Ring-Opening Reactions of 1-(9-Fluorenyl)-2-(2-methyl-2-oxiranyl)naphthalene Rotamers With Acids and the Structure of Oxiranes

X-ray crystallography of the ap-form of the 1-(9-fluorenyl)-2-(2-methyl-2-oxiranyl)naphthalene has revealed that the carbon atom of the oxirane which is connected to the naphthyl group in this compound is almost planar. The specific structural features of the epoxy ring in this compound are caused by sterical effects and by the presence of a -system in the immediate vicinity of the oxirane ring. Certain differences have been found also in reactivity of rotational isomers of 2-X-substituted 1-[1-(9-fluorenyl)-2-naphthyl]ethyl cations (X = O, S, Se). At X = O arose more deprotonation product from the -position of the oxygen than in reactions of sulfur and selenium-containing analogs. Reactions of epoxides with zinc chloride almost exclusively gave the corresponding aldehydes.     

Preparation of a zwitterionic trichloroplatinum(II) complex with an alkylbipyridinum ligand and its reaction in dmso-<Emphasis Type="BoldItalic">d</Emphasis><Subscript>6</Subscript> solution

A zwitterionic trichloroplatinum(II) complex PtCl₃(4,4′-bpy-N-ⁿBu) (1) was prepared by an aqueous reaction of [4,4′-bpy-N-ⁿBu]Cl with K₂PtCl₄, and was characterized by ¹H-n.m.r. and IR spectroscopy as well as elemental analysis. Dissolving (1) into dmso-d ₆ at 25 °C yields a mixture of the complexes, cis-PtCl₂(4,4′-bpy-N-ⁿBu)(dmso-d ₆) (2-cis), trans-PtCl₂(4,4′-bpy-N-ⁿBu)(dmso-d ₆) (2-trans), [4,4′-bpy-N-ⁿBu]Cl and PtCl₂(dmso-d ₆)₂. Ratio of the products in the dmso-d ₆ solution changed depending on the temperature and the total concentration of the complexes. These compounds are in equilibrium via isomerization reaction between (2-cis) and (2-trans) and via displacement reaction of the alkylbipyridinium ligand of (2-cis) and (2-trans) with dmso-d ₆ to form [4,4′-bpy-N-ⁿBu]Cl and PtCl₂(dmso-d ₆)₂.