Intrinsic carrier doping in antiferromagnetically interacted supramolecular copper complexes with (pyrazino)tetrathiafulvalene (pyra-TTF) as the ligand, [CuIICl2(pyra-TTF)] and (pyra-TTF)2[CuI3Cl4(pyra-TTF)

New supramolecular copper complexes with pyrazinotetrathiafulvalene (pyra-TTF) as the ligand, [Cu(II)Cl2(pyra-TTF)] (1) and (pyra-TTF) 2[Cu(I)3Cl4(pyra-TTF)] (2), have been synthesized by the diffusion method. Complex 1 is a black block crystal with a three-dimensional (3-D) supramolecular network; the linear chain [-Cu(II)Cl2-(pyra-TTF)-] n extends along the b axis, where the coordinated pyra-TTF donors are stacked in a head-to-tail and ring-over-bond configuration to construct two-dimensional (2-D) sheets, and between the sheets, there are C...Cl(-) or H...Cl(-) contacts. Even though the electron spin resonance (ESR) measurement reveals the nearly Cu(II) state, complex 1 is a semiconductor with sigmaRT=1.0 x 10(-4) S cm(-1) and Ea=0.33 eV. The high-frequency conductivity measurement also confirmed the intrinsic slight carrier doping from Cu(II) to the pyra-TTF donor. This slight doping enhances not only the real and imaginary dielectric constants but also the antiferromagnetic interaction between Cu(II) spins following the 2-D Heisenberg model with 2J=-20 K. In contrast, complex 2 is a very thin black needle. This needle crystal has two crystallographically independent pyra-TTF molecules, which are coordinated and noncoordinated donors. The coordinated donors composed a supramolecular chain [Cu(I)3Cl4(pyra-TTF)(0)]n , whereas the noncoordinated donors formed conducting alpha'-type pyra-TTF(+0.5) sheets. This complex is semiconducting with sigmaRT=0.1 S cm(-1) and Ea=0.15 eV. Both complexes 1 and 2 demonstrate that the pyra-TTF molecule works not only as an oxidized donor by Cu(II) to construct conducting sheets but also as a ligand coordinated to a Cu cation to form supramolecuar chains.     

Oxidation of Au by surface OH: nucleation and electronic structure of gold on hydroxylated MgO(001)

The nucleation and electronic structure of vapor-deposited Au on hydroxylated MgO(001) surfaces has been investigated under ultrahigh vacuum conditions. Hydroxylated MgO(001) surfaces with two different hydroxyl coverages, 0.4 and 1 monolayer, respectively, were prepared by exposure to water (D(2)O) at room temperature. Scanning tunneling microscopy experiments show significantly higher gold particle densities and smaller particle sizes on the hydroxylated MgO surface as compared to gold deposited on clean MgO(001). Infrared spectroscopy and X-ray photoelectron spectroscopy experiments were performed to reveal details about the initial nucleation of gold. Gold atoms are found to chemically interact with a specific type of hydroxyl groups on the MgO surface, leading to the formation of oxidized gold particles. The enhanced adhesion of Au particles, which is due to the formation of strong Au-O interfacial bonds, is responsible for the observed higher stability of small Au clusters toward thermal sintering on hydroxylated MgO surfaces. The results are compared to similar studies on Au/TiO(2)(110) model systems and powder samples prepared by the deposition-precipitation route.     

Selective adsorption and stable solidification of radioactive cesium ions by porous silica gels loaded with insoluble ferrocyanides

Development of highly functional cesium selective adsorbents for the decontamination of high-activity-level water(HALW) from the Fukushima NPP-1 accident is very urgent. In order to selectively adsorb the radioactive cesium, three kinds of novel porous silica gels loaded with insoluble ferrocyanides(SLFC) were prepared using a successive impregnation/precipitation method. Based on the results of previous research, the SLFC composites have relatively large uptake ratio above 95%, distribution coefficients(Kd) above 103 cm3/g, and excellent adsorption kinetics even in seawater. The solidification results also indicate that zeolites have an excellent Cs immobilization characteristic, gas-trapping and self-sintering abilities, and low leachability. We chose three kinds of SLFC composites to achieve the optimization of solidification by mixing with nine kinds of additives at high temperatures(up to 1200 °C). The Cs contents in the three composites were estimated to be below 30% of the initial contents and decreased with the three stages at calcination temperatures ranging from 25 to 1200 °C. By contrast, the Cs immobilization ratio was markedly lowered by mixing with additives: of those, allophane had the best immobilization result. By increasing the additive ratio to 50 wt%, the Cs immobilization ratio became almost 100% and no volatilization of Cs was detected even after calcination at 1200 °C. This result indicates that calcination of the mixture of SLFC composites after adsorbing Cs+ ions and specific additives under appropriate ratio is effective for stable solidification.     

Synthesis and pharmacological evaluation of 1-isopropyl-1,2,3,4-tetrahydroisoquinoline derivatives as novel antihypertensive agents

A series of 1-isopropyl-1,2,3,4-tetrahydroisoquinoline derivatives were synthesized and their bradycardic activities were evaluated in isolated guinea pig right atria. Structure-activity relationship studies revealed that the introduction of an appropriate substituent and its position on the 1,2,3,4-tetrahydroisoquinoline ring are essential for potent in vitro activity. Furthermore, the tether between the piperidyl moiety and the terminal aromatic ring is important for potent antihypertensive activity. Oral administration of 6-fluoro-1-isopropyl-2-{[1-(2-phenylethyl)piperidin-4-yl]carbonyl}-1,2,3,4-tetrahydroisoquinoline (3b) to spontaneously hypertensive rats (SHR) elicited antihypertensive effects without inducing reflex tachycardia, which is often caused by traditional L-type Ca2? channel blockers.     

Sensitive measurement of methylene blue active substances by attenuated total reflection spectrometry with a trimethylsilane-modified glass slab optical waveguide

Attenuated total reflection spectrometry with a slab optical waveguide (SOWG) was explored for the simple, rapid and sensitive measurement of total anionic surfactants by the methylene blue active substance (MBAS) method. A fused-silica sheet used as a guiding layer was modified with trimethylsilane (TMS) to extract and concentrate the MBASs on the SOWG surface. Based on preliminary studies of the adsorption behavior and visible ATR spectrum of MB on the modified silica surface, a detection wavelength of 600 nm was chosen for the sensitive measurement of anionic surfactants. When the concentration of MB was set at 10 microM in the final measurement solution, the calibration curve for a typical anionic surfactant (sodium dodecylbenzenesulfonate) was linear up to 0.6 microM and the detection limit was 0.07 microM. The proposed method was applied to the determination of total anionic surfactants in river water.     

Defect Engineering and Anisotropic Modulation of Ionic Transport in Perovskite Solid Electrolyte LixLa(1−x)/3NbO3

Solid electrolytes, such as perovskite Li_3xLa_2/1−xTiO₃, Li_xLa_(1−x)/3NbO₃ and garnet Li₇La₃Zr₂O₁₂ ceramic oxides, have attracted extensive attention in lithium-ion battery research due to their good chemical stability and the improvability of their ionic conductivity with great potential in solid electrolyte battery applications. These solid oxides eliminate safety issues and cycling instability, which are common challenges in the current commercial lithium-ion batteries based on organic liquid electrolytes. However, in practical applications, structural disorders such as point defects and grain boundaries play a dominating role in the ionic transport of these solid electrolytes, where defect engineering to tailor or improve the ionic conductive property is still seldom reported. Here, we demonstrate a defect engineering approach to alter the ionic conductive channels in Li_xLa_(1−x)/3NbO₃ (x = 0.1~0.13) electrolytes based on the rearrangements of La sites through a quenching process. The changes in the occupancy and interstitial defects of La ions lead to anisotropic modulation of ionic conductivity with the increase in quenching temperatures. Our trial in this work on the defect engineering of quenched electrolytes will offer opportunities to optimize ionic conductivity and benefit the solid electrolyte battery applications.     

Thiol-terminated hydroxy-functional polymer as a transtab toward polymer latex particles

Hydroxy-functional macrodisulfides have been synthesized by atom transfer radical polymerization of 2-hydroxyethyl methacrylate or 2-hydroxypropyl methacrylate in 2-propanol. Mean degrees of polymerization of the polymer chains beside the disulfide were fixed at 30, 60, and 90; since ATRP has reasonably good living character, the molecular weight distribution is relatively narrow. Furthermore, the macrodisulfides were reduced to synthesize corresponding thiol-terminated polymers with relatively narrow molecular weight distributions. ¹H nuclear magnetic resonance and gel permeation chromatography were used to characterize the macrodisulfides and thiol-terminated polymers in terms of their chemical structure, molecular weight, and polydispersity, respectively. Dispersion polymerizations of styrene using the thiol-terminated hydroxy-functional polymers as a transtab (chain transfer agent + colloidal stabilizer) in ethanol resulted in colloidally stable submicrometer-sized polystyrene latex particles. Scanning electron microscopy, Fourier transform infrared spectroscopy, and elemental microanalysis were used to characterize the particles in terms of their morphologies, particle sizes and their distributions, and chemical compositions.     

Local distribution of radioactivity in tree leaves contaminated by fallout of the radionuclides emitted from the Fukushima Daiichi Nuclear Power Plant

We analyzed fresh and dead leaves collected in forests in Fukushima after the Fukushima Daiichi Nuclear Power Plant (FDNPP) accident, using autoradiography. Both fresh and dead leaves of Cryptomeria japonica were contaminated by radionuclides (¹³⁴Cs and ¹³⁷Cs). Contamination of the fresh leaves was possibly attributed to interception of radionuclides by tree canopies, whereas the dead leaves indicated the direct deposition of radionuclides by fallout and/or washout of radionuclides intercepted by tree canopies. Translocation of radiocesium from a contaminated branch to new leaves growing after the FDNPP accident was not clearly observed, although transfer of radiocesium from leaf parts to male flowers occurred. Fallen leaves of Quercus serrata, which started growing after the FDNPP accident, did not show radioactivity, indicating that significant amounts of translocation from other parts to new leaves did not occur. Fallen leaves of Q. serrata collected from a litter showed hot spots originating from direct fallout. Needles of Pinus densiflora were also contaminated by fallout. Leaching with pure water removed soluble fractions of radiocesium and hot particles from the surface of the contaminated leaves, but significant amounts of radioactivity remained. This means that foliar absorption occurred in both fresh and dead leaves. Further leaching experiments using surfactant and acetone could not remove the remaining radiocesium from the leaves. The leaching experiments indicate that radiocesium in the contaminated leaves is strongly fixed in leaf tissues and is not readily released unless leaf tissues are decomposed.