钴膦簇合物的催化环丙烷化反应

本文首次利用碳基钴簇合物ＰｈＰＣｏ_３（ＣＯ）_９催化剂，在常压和－２０℃－０℃，用苯乙烯和重氮乙酸乙酯进行环丙烷化反应，合成了菊酸酯，重氮乙酸乙酯可全部转化，酯的选择性可达８５％。产物经减压分馏后，由ＩＲ和￣１ＨＮＭＲ分析，确证了产物为菊酸酯，表明了羰基钴簇合物对苯乙烯的环丙烷化反应有良好的催化性能，为四面体异核簇合物用于不对称催化反应打下了基础。     

In Situ Monitoring of Generation and Precipitation of Ferric Hydroxide Sol with a Piezoelectric Quartz Crystal Impedance Analyzer

The piezoelectric quartz crystal (PQC) impedance technique was applied to monitor in situ generation and precipitation of the ferric hydroxide sol in aqueous solutions at 90 degrees C. Equivalent circuit parameters and resonant frequencies as well as the half-peak width of the electroacoustic conductance spectrum deltaf(G1/2) for the PQC resonance were obtained and analyzed. Three stages, sol generation and simultaneous adsorption, adsorption equilibrium, and precipitation of ferric hydroxide sol could be identified in the process of adding the ferric nitrate solution into the hot water. A scheme of two consecutive reactions occurring at the electrode/solution interface was used to analyze the adsorption kinetics of ferric hydroxide sol onto the Au electrode. In addition, the electrolyte-induced precipitation of the colloid was monitored and discussed. Temperature effect on the PQC resonance behavior in liquid was also investigated. Since the PQC impedance technique provides multidimensional piezoelectric information in situ, it is highly recommended for studying the process of sol-gel generation and precipitation. Copyright 2001 Academic Press.     

硅胶担载四核羰基钴催化剂的EXAFS和IR研究

本文以透射法EXAFS和IR等手段研究了四核羰基钴金属簇Co_4(CO)_(10)(PPh)_2担载在SiO_2上以后及用于烯烃醛化反应前后的变化,确定了相应的结构参数并探讨了催化活性与结构的关系。     

Solvent extraction of uranium(VI) with benzyloctadecyldimethylammonium chloride (BODMAC) from highly concentrated chloride solution

The ²²²Rn emanation fraction (EF) released from the technically enhanced naturally occurring radioactive material (TE-NORM) wastes at certain sites of petroleum and gas production was determined. The samples were analyzed by γ-ray spectrometry to determine the activity concentration of the ²²⁶Ra content, of which the ²²²Rn emanation fraction was calculated. The results showed that the ²²²Rn emanation fraction differs in the oil and gas production sites and it is independent of the activity concentration of ²²⁶Ra. This revised version was published online in August 2006 with corrections to the Cover Date.     

A comparison between the SBR vulcanizates reinforced by magnesium methacrylate added directly or prepared in situ

The styrene-butadiene rubber (SBR) cured by dicumyl peroxide was reinforced by magnesium methacrylate [Mg(MAA)₂], which was added into SBR directly or prepared in situ in SBR through the neutralization of magnesium oxide (MgO) and methacrylic acid (MAA). The experimental results show that the SBR vulcanizates reinforced by Mg(MAA)₂ prepared in situ have better mechanical properties than those reinforced by Mg(MAA)₂ added directly. The SBR vulcanizates with Mg(MAA)₂ prepared in situ are semi-transparent, but those with Mg(MAA)₂ added directly are opaque. The Fourier transform infrared analysis shows that the polymerization conversion of Mg(MAA)₂ in the SBR vulcanizates with Mg(MAA)₂ prepared in situ is much higher than that in the SBR vulcanizates with Mg(MAA)₂ added directly. The scan probe microscopy photographs show that the particles in the SBR vulcanizates with Mg(MAA)₂ prepared in situ are much finer and disperse more evenly than that in the SBR vulcanizates with Mg(MAA)₂ added directly.     

Liquid chromatographic enantiomer resolution of N-fluorenylmethoxycarbonyl alpha-amino acids and their ester derivatives on polysaccharide-derived chiral stationary phases

The liquid chromatographic enantiomer separation of N-fluorenylmethoxycarbonyl (FMOC) protected alpha-amino acids and their ethyl ester derivatives was performed on polysaccharide-derived chiral stationary phases, Chiralcel OD, Chiralpak AD, and Chiralpak AS. In general, Chiralcel OD and Chiralpak AD showed good performance for resolution of N-FMOC alpha-amino acids and their ethyl esters, respectively. All investigated N-FMOC alpha-amino acid enantiomers were baseline separated on Chiralcel OD or Chiralpak AD, whereas N-FMOC alpha-amino acid ethyl ester enantiomers were baseline resolved (alpha = 1.15-3.03) on Chiralpak AD, except for two analytes. The L-enantiomers of all examined FMOC alpha-amino acid ethyl ester derivatives are preferentially retained on Chiralpak AD, while the elution orders of the other enantiomer separations are not consistent.     

Interface characteristics in diffusion bonding of Fe3Al with Cr18-Ni8 stainless steel

Fe3Al and Cr18-Ni8 stainless steel were diffusion-bonded in vacuum and a Fe3Al/Cr18-Ni8 interface with reaction layer was formed. Microstructure in the reaction layer at Fe3Al/Cr18-Ni8 interface was analyzed by means of scanning electron microscope (SEM) and electron probe micro-analyzer (EPMA). The growth of reaction layer with heating temperature (T) and holding time (t) was researched. The results indicate that FeAl, Fe3Al, Ni3Al, and alpha-Fe (Al) solid solution are formed in the reaction layer. These phases are favorable to promote the element diffusion and to accelerate the formation of the reaction layer at Fe3Al/Cr18-Ni8 interface. The growth of reaction layer obeys the parabolic law and its thickness (X) is expressed by X2 = 7.5 x 10(-4)exp(-83.59/RT)(t - t0).     

N-（4＇-取代嘧啶-2＇-基）-取代苯氧基磺酰脲的合成及除草活性

光谱;N-（4＇-取代嘧啶-2＇-基）-取代苯氧基磺酰脲的合成及除草活性     

溶剂浓度对PVDF相转换膜大孔结构的影响

提出决定大孔能否发展的初始分相点处溶剂浓度临界点的概念 ,认为初始分相点处较高的溶剂浓度有利于大孔的发展 ,溶剂浓度低于一定的界限后 ,大孔停止发展 ,转为海绵状结构 .实验考察了不同凝胶液组成下制得的PVDF中空膜的结构 ,建立了相应的传质模型 ,模拟不同制膜条件下初生态膜内的组成分布情况 ,根据初始分相点处溶剂浓度临界点的概念 ,预测膜的形态结构 .模拟结果与相应制膜条件下的电镜照片有很好的对应关系 ,证明了上述大孔形成机理的正确性 .     

Use of on-line mass spectrometric detection in capillary electrochromatography

Capillary electrochromatography (CEC) is a liquid phase analytical separation technique that is generally carried out with packed capillary columns by electroosmotically driven mobile phase at high electric field strength. The analytes are separated by virtue of the differences in their distribution between the mobile and stationary phases and, if charged in their electrophoretic mobilities as well. It is thus considered a hybrid of liquid chromatography and capillary electrophoresis and is expected to combine the high peak efficiency of capillary zone electrophoresis (CZE) with the versatility and loading capacity of HPLC. This review explores the potential use of on-line mass spectrometric detection for CEC. It discusses key design issues that focus on the physical and electrical arrangement of the CEC column with respect to the electrospray orifice inlet. The salient features of the sheathless, sheath flow and liquid junction interfaces that are frequently employed while coupling a CEC column to an electrospray ionization mass spectrometry system are also highlighted. Possible configurations of the CEC column outlet that would obviate the need for pressurizing the capillary column are also presented. While coupling CEC with MS both the nature of the interface and the configuration of the column outlet will determine the optimal arrangement. The review also discusses bandspreading that occurs when a connecting tube is employed to transfer mobile phase from the column outlet to the atmospheric region of the electrospray source with a concomitant loss in sensitivity. Selected examples that highlight the potential of this technique for a wide range of applications are also presented.