不同结构毛细管网辐射板供冷性能实验研究

对两种不同结构毛细管网辐射板的性能进行了实验研究,分析了在不同供水温度下,该两种辐射板在表面温度分布、供冷能力、安装辐射板房间温度变化情况之间的差异,为今后毛细管网辐射供冷空调系统辐射末端的设计应用及运行控制提供依据。     

A low specific on-resistance SOI MOSFET with dual gates and a recessed drain

A low specific on-resistance(Ron,sp) integrable silicon-on-insulator(SOI) metal-oxide semiconductor field-effect transistor(MOSFET) is proposed and investigated by simulation.The MOSFET features a recessed drain as well as dual gates,which consist of a planar gate and a trench gate extended to the buried oxide layer(BOX)(DGRD MOSFET).First,the dual gates form dual conduction channels,and the extended trench gate also acts as a field plate to improve the electric field distribution.Second,the combination of the trench gate and the recessed drain widens the vertical conduction area and shortens the current path.Third,the P-type top layer not only enhances the drift doping concentration but also modulates the surface electric field distributions.All of these sharply reduce Ron,sp and maintain a high breakdown voltage(BV).The BV of 233 V and Ron,sp of 4.151 mΩ·cm2(VGS = 15 V) are obtained for the DGRD MOSFET with 15-μm half-cell pitch.Compared with the trench gate SOI MOSFET and the conventional MOSFET,Ron,sp of the DGRD MOSFET decreases by 36% and 33% with the same BV,respectively.The trench gate extended to the BOX synchronously acts as a dielectric isolation trench,simplifying the fabrication processes.     

利用分形法表征光学元件中高频相位畸变

针对神光Ⅲ主机装置使用的光学元件,基于分形理论,分析中高频相位畸变的统计分布特征,指出其满足分数布朗随机场,并利用结构函数法对分形维数进行计算,统计结果显示,大口径钕玻璃片的分形维数在2.34~2.43之间。利用局部稳态的随机中点位移法,提出一种新的表征光学元件相位的方法,将分形维数作为参数,可衡量中高频相位畸变,对高功率激光光学元件的评价有参考意义。     

An experimental study of airfoil instability tonal noise with trailing edge serrations

This paper presents an experimental study of the effect of trailing edge serrations on airfoil instability noise. Detailed aeroacoustic measurements are presented of the noise radiated by an NACA-0012 airfoil with trailing edge serrations in a low to moderate speed flow under acoustical free field conditions. The existence of a separated boundary layer near the trailing edge of the airfoil at an angle of attack of 4.2 degree has been experimentally identified by a surface mounted hot-film arrays technique. Hot-wire results have shown that the saw-tooth surface can trigger a bypass transition and prevent the boundary layer from becoming separated. Without the separated boundary layer to act as an amplifier for the incoming Tollmien–Schlichting waves, the intensity and spectral characteristic of the radiated tonal noise can be affected depending upon the serration geometry. Particle Imaging Velocimetry (PIV) measurements of the airfoil wakes for a straight and serrated trailing edge are also reported in this paper. These measurements show that localized normal-component velocity fluctuations that are present in a small region of the wake from the laminar airfoil become weakened once serrations are introduced. Owing to the above unique characteristics of the serrated trailing edges, we are able to further investigate the mechanisms of airfoil instability tonal noise with special emphasis on the assessment of the wake and non-wake based aeroacoustic feedback models. It has been shown that the instability tonal noise generated at an angle of attack below approximately one degree could involve several complex mechanisms. On the other hand, the non-wake based aeroacoustic feedback mechanism alone is sufficient to predict all discrete tone frequencies accurately when the airfoil is at a moderate angle of attack.     

受激Raman谱中的宏观极化干涉

研究了Rb⁸⁵原子蒸气D1线系统中的受激Raman增益与损耗现象. 实验中观察到 随着抽运光失谐量的增大, 受激Raman谱明显地呈现出一个从增益到损耗的陡峭转变. 从缀饰态模型出发, 我们提出这是对探测光有相反贡献的不同速度原子群之间极化干涉的结果. 关键词： 受激Raman谱 电磁感应透明 极化干涉     

白光LED用Sr3LiMgV3O12:Eu3+单基质荧光粉的研究

采用高温固相法合成了一种新型单基质Sr3-2xLi1+xMgV3O12∶xEu3+荧光粉,研究了其在不同的合成温度及Eu3+掺杂浓度等条件下的发光性能。利用X射线衍射仪(XRD)、扫描电镜(SEM)和荧光光谱仪(PL)等对样品进行表征。荧光光谱表明Sr3-2xLi1+xMgV3O12∶xEu3+荧光粉具有与近紫外芯片相匹配的激发光谱,其宽阔的发射光谱(450～630nm)使得该类物质具有作为白光LED用单基质荧光粉的巨大优势。     

Oscillation of coercivity between positive and negative in MnxGe1-x：H ferromagnetic semiconductor films

Amorphous MnxGe1-x :H ferromagnetic semiconductor films prepared in mixed Ar with 20% H2 by magnetron cosputtering show global ferromagnetism with positive coercivity at low temperatures. With increasing temperature, the coercivity of MnxGe1-x :H films first changes from positive to negative, and then back to positive again, which was not found in the corresponding MnxGe1-x and other ferromagnetic semiconductors before. For Mn0.4Ge0.6 :H film, the inverted Hall loop is also observed at 30 K, which is consistent with the negative coercivity. The negative coercivity is explained by the antiferromagnetic exchange coupling between the H-rich ferromagnetic regions separated by the H-poor non-ferromagnetic spacers. Hydrogenation is a useful method to tune the magnetic properties of MnxGe1-x films for the application in spintronics.     

超声法制备碳量子点发光性能的影响因素分析

超声法制备碳量子点过程简单,成本低廉,不易产生二次污染,应用前景广泛。为优化超声法制备碳量子点的各工艺参数,制备了关键工艺参数不同的碳量子点样品,测试其发射与激发光谱,分析了量子点浓度,溶剂种类,辅助剂种类、浓度,超声功率、时间等参数对碳量子点发光性能影响。结果表明超声法制备的碳量子点具有激发光波长依赖性,发射峰位置随激发波长的变化而发生明显改变;碳量子点浓度增加,发光强度由于非辐射能量传递和团聚作用,先增大后减小;由于溶剂效应,碳量子点在乙醇中比在水中发光强度更强,波长更短,且浓度越大时波峰移动越明显;相比盐酸,以NaOH为辅助剂制备的碳量子点表面钝化程度高,发光强度强;增加辅助剂NaOH浓度可提高量子点表面钝化程度,增大发光强度;同等时间下增加超声功率或同等功率下适量增加超声时间,可制备更多的碳量子点样品,但超声时间过长,碳量子点容易发生团聚猝灭现象。以上影响因素分析为超声法制备碳量子点的工艺参数优化提供了理论基础,有利于碳量子点大规模低成本的生产应用。     

Reflection of Surface Plasmon Polaritons by a Corner Reflector of Negative Index Materials

A novel type of corner reflector for the reflection of surface plasmon polariton (SPP) is proposed. The reflector consists of two layers of compensatory media whose permittivity and permeability take opposite signs to that of the corresponding layer of the SP waveguide. By rigorously solving Maxwell's equations, the reflected SPP is proved to exist. The transverse wave vector of the reflected SPP is always antiparallel to that of the incident SPP and no phase retardation is introduced.     

Widely tunable long-period fiber grating with nm-thick higher refractive index film overlay

By introducing a four-layer step-index waveguide modeling, the characteristics of long-period fiber grating (LPFG) with an nm-thick film overlay, which has higher refractive index than that of fiber cladding are investigated in detail. The influence of both the overlay thickness and refractive index on the tuning ability of LPFG is analyzed. The numerical results demonstrate that spectral response of LPFG is divided into three distinct regions as the overlay deposition increases and the shift of resonant wavelength is drastic in some special thickness range. In conjunction with higher-order cladding mode coupling and fiber cladding etching, the sensitivity of LPFG to the overlay refractive index is enhanced significantly and over 120 nm resonant wavelength tunable range is achieved.