K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

Use of zwitterionic buffer additives to improve the separation of proteins in capillary zone electrophoresis

In CZE, the adsorption of the proteins on the capillary wall is a common problem. This paper describes the simple method of utilizing zwitterionic buffer additives to improve the separation of proteins in untreated fused silica capillaries at neutral pH. Three kinds of zwitterion are evaluated in the separation of acidic, neutral, and basic proteins, including their effect on protein efficiency, mobility, separation, and resolution; the difference between the effects of the different additives are also highlighted. The method has proved to be a possible means of reducing protein adsorption, especially for basic proteins.     

C~k连续的保形分段2k次多项式插值

1．引言在每个子区间上，通过插入至多一个内结点，Brodlie和Butt［1］给出了分段三次多项式保形插值算法，Randal［2］等讨论了分段五次多项式插值，作者［31讨论了一般分段奇次多项式的保形插值，并且给1了内结点的位置范围公式．这种插值方法完全解决了一般的分段奇次多项式的保形插值问题．关于分段偶次多项式的保形插值，大多数文献只讨论分段二次保形插值，这里要特别指出的是Shumake［4j导出了二次样条保凸的充要条件，并且给出了一个二次样条保形插值的方法．在每一个子区间上至多插入一个内结点，则一个二次插值样条就可得到．作…     

The 3-D FEL pulse propagation equation: An analytical treatment in the low-gain and small-signal regime

Summary In this paper we show that the transverse mode evolution of a FEL operating with short pulses can be treated, in the small-signal and low-gain regime, using a relatively simple mathematical technique leading to a potentially fast numerical algorithm. We also point out that analytical solutions can be obtained for the cases where the slippage length is small compared to the longitudinal bunch length.     

Yb原子高激发态的斯塔克光谱

采用ππ偏振激光，通过两步激发和光电离方法，在０－１５４Ｖ／ｃｍ电场范围内，测定了Ｙｂ原子ｎ－１８附近ｍ＝０的斯塔克光谱，首次把包含斯塔克效应的能量矩阵对角化方法推广到Ｙｂ原子，所获得的理论斯塔克图与实验结果基本符合，观察到低场中斯塔克簇随电场增加呈现线性结构以及＾１Ｐ１态与斯塔克簇在抗交叉过程中振子强度发生转移的现象，讨论了结构与量子亏损的关系。     

Theoretical Study of the Molecular Electrostatic Potential of C_(50)

1 INTRODUCTION All fullerenes made so far obey the isolated pentagon (IPR)[1], which governs the stability of fullerenes comprising hexagons and exact 12 pen- tagons. Smaller fullerenes, which violate the IPR, are predicted to have high instability and especially difficult isolation due to their condensed pentagons and increased strain. The production of smaller fullerene C36 has been reported[2]. However, the definite characterization of a C36-based solid is in doubt. Moreover, variou…     

带有边集限制的最均匀支撑树问题

本在无向网络中，建立了带有边集限制的最均匀支撑树问题的网络模型．中首先解决最均匀支撑树问题，并给出求无向网络中最均匀支撑树的多项式时间算法；然后，给出了求无向网络中带有边集限制的最小树多项式时间算法；最后，在已解决的两个问题的基础上解决了带有边集限制的最均匀支撑树问题．     

参数曲面保凸的一个定理

本文讨论了参数曲面的凸性，给出了参数曲面为凸的充要条件．并给出了具体的应用实例．     

Damage and fracture evaluation of granular composite materials by digital image correlation method

This paper presents the applications of digital image correlation technique to the mesoscopic damage and fracture study of some granular based composite materials including steelfiber reinforced concrete, sandstone and crystal-polymer composite. The deformation fields of the composite materials resulted from stress localization were obtained by the correlation computation of the surface images with loading steps and thus the related damage prediction and fracture parameters were evaluated. The correlation searching could be performed either directly based on the gray levels of the digital images or from the wavelet transform (WT) coefficients of the transform spectrum. The latter was developed by the authors and showed higher resolution and sensitivity to the singularity detection. Because the displacement components came from the rough surfaces of the composite materials without any coats of gratings or fringes of optical interferometry, both surface profiles and the deformation fields of the composites were visualized which was helpful to compare each other to analyze the damage of those heterogeneous materials. The project supported by the National Natural Science Foundation of China (10125211 and 10072002), the Scientific Committee of Yunnan Province for the Program of Steel Fiber Reinforced Concrete, and the Institute of Chemical Materials, CAEP at Mianyang