Ionizing radiation induces blockade of c-Jun N-terminal kinase-dependent cell death pathway in a manner correlated with p21(Cip/WAF1) induction in primary cultured normal human fibroblasts

During radiotherapy of cancer, neighboring normal cells may receive sub-lethal doses of radiation. To investigate whether such low levels of radiation modulate normal cell responses to death stimuli, primary cultured human fibroblasts were exposed to various doses of gamma-rays. Analysis of cell viability using an exclusion dye propidium iodide revealed that the irradiation up to 10 Gy killed the fibroblasts only to a minimal extent. In contrast, the cells efficiently lost their viability when exposed to 0.5-0.65 mM H(2)O(2). This type of cell death was accompanied by JNK activation, and was reversed by the use of a JNK-specific inhibitor SP600125. Interestingly, H(2)O(2) failed to kill the fibroblasts when these cells were pre-irradiated, 24 h before H(2)O(2) treatment, with 0.25-0.5 Gy of gamma-rays. These cytoprotective doses of gamma-rays did not enhance cellular capacity to degrade H(2)O(2), but elevated cellular levels of p21(Cip/WAF1), a p53 target that can suppress H(2)O(2)-induced cell death by blocking JNK activation. Consistently, H(2)O(2)-induced JNK activation was dramatically suppressed in the pre-irradiated cells. The overall data suggests that ionizing radiation can impart normal fibroblasts with a survival advantage against oxidative stress by blocking the process leading to JNK activation.     

Targeted lipidomics using electron capture atmospheric pressure chemical ionization mass spectrometry

There is an increasing need to be able to conduct quantitative lipidomics analyses as a complement to proteomics studies. The highest specificity for proteomics analysis can be obtained using methodology based on electrospray ionization (ESI) or atmospheric pressure chemical ionization (APCI) coupled with liquid chromatography/tandem mass spectrometry (LC/MS/MS). For lipidomics analysis it is often necessary to be able to separate enantiomers and regioisomers. This can be very challenging when using methodology based on conventional reversed-phase chromatography. Normal-phase chromatography using chiral columns can provide dramatic improvements in the resolution of enantiomers and regioisomers. However, conventional ESI- and APCI-MS/MS has limited sensitivity, which makes it difficult to conduct studies in cell culture systems where only trace amounts of non-esterified bioactive lipids are present. The use of electron capture APCI-MS/MS overcomes this problem. Enantiomers and regioisomers of diverse bioactive lipids can be quantified using stable isotope dilution methodology coupled with normal-phase chiral chromatography and electron capture APCI-MS/MS. This methodology has allowed a lipidomics profile from rat epithelial cells maintained in culture to be delineated and allowed the effect of a non-selective lipoxygenase inhibitor to be assessed.     

Synthesis, crystal structures and magnetic properties of Cu(II) compounds bridged by the terephthalate ligand and hydrogen bonds

A 3D network [Cu(tmen)(tp)(H₂O)₂]_n (1) (tmen = N,N,N′,N′-tetramethylethylenediamine; tp = terephthalate) and a 2D sheet [Cu(pyrazole)₂(tp)]_n (2), featuring 1D chains interwoven by hydrogen bonds, have been prepared and characterized by means of X-ray analyses and magnetic measurements. For 1, coordinative zigzag chains contain Cu(II) centers capped by the chelate ligand tmen, in which the tetragonal structure is elongated due to Jahn–Teller distortion. Coordinated water molecules are hydrogen-bonded to two free carboxylate oxygens of tp bridges, leading to the observed 3D structure. The use of the non-chelating capping ligand pyrazole produced the covalent-bonded 1D linear compound 2 with hydrogen bonds. A severe octahedral distortion of the Cu(II) center arises from a small bite angle (52.3(1)°) of two carboxylate oxygen atoms of tp, which are in turn hydrogen-bonded to the N–H groups of pyrazole ligands coordinated to Cu(II) atoms in neighboring chains. Magnetic data were fitted with the high-temperature series expansion for the Heisenberg chain spin Hamiltonian H = −J∑_iS_i · S_i + 1 together with consideration of the molecular field approximation (zJ′). Both compounds interestingly exhibit ferromagnetic interactions with g = 2.17, J = 4.08 cm⁻¹, zJ′ = −0.28 cm⁻¹ for 1 and g = 2.09, J = 1.47 cm⁻¹, zJ′ = −0.04 cm⁻¹ for 2. By taking into account structural parameters of distances between Cu atoms, it is reasonably assigned that the ferromagnetic couplings (J > 0) in these systems originate from the hydrogen bonds. The spin density of the d_x²-y² orbital on a Cu(II) atom in a chain is propagated and induced over the d_z² orbital of another Cu(II) atom in an adjacent chain. This orbital orthogonality gives rise to such interactions. The negative zJ′ term suggests that the tp bridges communicate only tiny antiferromagnetic interactions.     

Determination of copper(II) in various samples by flame atomic absorption spectrophotometry after column preconcentration onto pulverized Amberlite XAD-4 loaded with N-benzoylphenylhydroxylamine

A sensitive technique for the determination of trace Cu(II) in various samples after column preconcentration by adsorbing onto pulverized Amberlite XAD-4 loaded with N-benzoylphenylhydroxylamine (BPHA) was developed. Several experimental conditions, such as the size of XAD-4, adsorption flow rate, pH of sample solution, and so forth, were optimized. The interfering effects of diverse concomitant ions were investigated. Al(III), Fe(III), Ni(II), and Co(II) interfered, but the interference by these ions was completely eliminated by adjusting the amount of XAD-4-BPHA resin to 0.30 g. The dynamic range, the correlation coefficient (R₂), and the detection limit obtained by the proposed technique were 1.0–60, 0.9953, and 0.83 ng/mL, respectively. For validating the technique, the aqueous samples (stream water, reservoir water, and wastewater), the diluted brass sample, and the plastic sample were used as real samples. Recovery yields of 94–102% were obtained. These measured data were not different from ICP-MS data at the 95% confidence level. This method was also validated by rice flour CRM (normal, fortified) samples. Based on the results of the experiment, it has been found that the proposed technique can be applied to the determination of Cu(II) in various real samples. The text was submitted by the authors in English.     

Chemical Constituents from the Root of Antidesma Pentandrum var. Barbatum

Investigation of the root extract of Antidesma pentandrum var. barbatum led to the isolation of seven new compounds, antidesmol ( 1 ), antidesmanins E ( 2 ) and F ( 3 ), antidesnone ( 4 ), antidesnol ( 5 ), barbatumols A ( 6 ) and B ( 7 ), together with 14 known compounds including sodium aristolochate‐I ( 10 ) and aristolochic acid‐I methyl ester ( 11 ).     

Low temperature carbene-to-carbene homologations

Since alkynes have higher symmetry than olefins, it is not easy to infer the mechanism of a triplet carbene’s addition to an alkyne by traditional product analysis studies. Specifically, no stereochemical information which might offer insight into the carbene’s spin state can be extracted from the cyclopropene products. In 1971, Hendrick, Baron, and Jones showed that diphenylcarbene reacts with terminal alkynes in solution to produce indenes via a “self-trapping” vinylcarbene. They also examined the diphenylcarbene reaction with disubstituted alkynes and found at most trace amounts of the “self-trapping” indene product. In this work, we report the direct observation by organic matrix EPR of the vinylcarbenes generated from triplet fluorenylidene and terminal alkynes. Our efforts to confirm the identities of these intermediates by independent synthesis, intermolecular trapping, and an intramolecular “self-trapping” method-halogen-migration-are also recounted. These findings are among the few instances in which fluorenylidene undergoes carbon-carbon bond formation rather than atom abstraction reactions in a low-temperature matrix, and in which the biradical adduct of a triplet carbene and a π-bonded substrate can be directly observed.     

The study on photoreflectance characteristic of semi-insulating GaAs surface region by its exposure to 6 MeV electron beam

Photoreflectance measurements were performed to investigate the optical properties in the electron beam irradiation semi-insulating GaAs(e-beam irradiation GaAs) and semi-insulating GaAs(SI-GaAs). A considerable increase of the PR amplitudes has been registered after the e-beam irradiation in comparison with the GaAs. It is that result of a higher electron scattering on the lattice defects created by the e-beam.     

Adsorption configuration and local ordering of silicotungstate anions on Ag(100) electrode surfaces

X-ray reflectivity, cyclic voltammetry, and scanning tunneling microscopy (STM) are used to examine the structure of alpha-SiW12O4(4-) or silicotungstic acid (STA) adsorbed on Ag(100) in acid solution. The voltammetry shows that STA passivates the Ag surface relative to electron transfer to a solution redox species. STM images reveal the formation of a series of lattice structures, one of which can be associated with a commensurate ( radical13x radical13)R33.69 degrees structural model. X-ray reflectivity measurements show uniquely that STA orients with its four-fold axis perpendicular to the Ag(100) surface and that the center of the STA molecule is 4.90 A above the top layer of the Ag substrate. Analysis of bond lengths leads to a footprint of STA on Ag(100), in which the four terminal O atoms are located near the hollow sites and have a Ag-O bond length of 2.06 A. This bond length is consistent with a strong covalent interaction between STA and the Ag surface.     

Coating of Tetraethylorthosilicate (TEOS)/Vinyltriethoxysilane (VTES) Hybrid Solution on Polymer Films

Tetraethylorthosilicate (TEOS)/vinyltriethoxysilane (VTES) hybrid materials were prepared and the hydrolysis and condensation reactions during processing were investigated by means of 29Si NMR solution spectroscopy. The variation of drying characteristics of the coating films was examined with respect to the tetraethylorthosilicate (TEOS)/vinyltriethoxysilane (VTES) ratio, as well as drying temperature, by FT-IR spectroscopy. It is shown that the TO mode of Si–O–Si stretching absorption was enhanced with increasing tetraethylorthosilicate (TEOS) content and drying temperature. Also, the wettability of the coating films on polymer films was independent of the solution composition but enhanced by the precoating of poly(4-hydroxystrene) (PHS) as a wetting agent. The adhesion between the coating and the films was also enhanced when the vinyltriethoxysilane (VTES) content in the coating solution was increased.