Preferential Uniplanar Orientation of Cellulose Microfibrils Reinvestigated by the FTIR Technique

A simple detection method to observe the uniplanar orientation behavior of native cellulose microfibrils to the cell wall surface by using Fourier transform infrared (FTIR) spectroscopy in the transmission mode is reported. Four bands at 1372, 1355, 1337, and 1317 cm⁻¹ (the latter two have been mentioned previously by Liang and Marchessault (1960, J. Polym. Sci. 43: 85–100)) were found to be sensitive to such orientation: the two middle bands at 1355 and 1337 cm⁻¹ increase remarkably when the 0.60–61 nm lattice planes lie parallel to the cell wall surfaces. The reverse was true when the 0.53–54 nm lattice planes oriented preferentially. Polarization of the two bands at 1372 and 1355 cm⁻¹ was parallel, while that of the other two bands at lower wavenumbers, i.e., at 1337 and 1317 cm⁻¹, was perpendicular to the molecular axis of cellulose. These bands were assigned to OH-related motion, probably to in-plane OH bending, as reported by Maréchal and Chanzy (2000, J. Mol. Spectrosc. 523: 183–196).     

Single crystal EPR studies of the reduced active site of [NiFe] hydrogenase from Desulfovibrio vulgaris Miyazaki F

In the catalytic cycle of [NiFe] hydrogenase the paramagnetic Ni-C intermediate is of key importance, since it is believed to carry the substrate hydrogen, albeit in a yet unknown geometry. Upon illumination at low temperatures, Ni-C is converted to the so-called Ni-L state with markedly different spectroscopic parameters. It is suspected that Ni-L has lost the "substrate hydrogen". In this work, both paramagnetic states have been generated in single crystals obtained from the [NiFe] hydrogenase from Desulfovibrio vulgaris Miyazaki F. Evaluation of the orientation dependent spectra yielded the magnitudes of the g tensors and their orientations in the crystal axes system for both Ni-C and Ni-L. The g tensors could further be related to the atomic structure by comparison with the X-ray crystallographic structure of the reduced enzyme. Although the g tensor magnitudes of Ni-C and Ni-L are quite different, the orientations of the resulting g tensors are very similar but differ from those obtained earlier for Ni-A and Ni-B (Trofanchuk et al. J. Biol. Inorg. Chem. 2000, 5, 36-44). The g tensors were also calculated by density functional theory (DFT) methods using various structural models of the active site. The calculated g tensor of Ni-C is, concerning magnitudes and orientation, in good agreement with the experimental one for a formal Ni(III) oxidation state with a hydride (H(-)) bridge between the Ni and the Fe atom. Satisfying agreement is obtained for the Ni-L state when a formal Ni(I) oxidation state is assumed for this species with a proton (H(+)) removed from the bridge between the nickel and the iron atom.     

Effects of a nonplanar porphyrin rings on the spin-spin interactions in low-spin ferric porphyrin radical cationst

Low-spin ferric porphyrin radical cations formed by the oxidation of chloro(meso-tetraalkylporphyrinato)iron(III) followed by the addition of bulky 2-methylimidazole show antiferromagnetic coupling, which is interpreted in terms of the interaction between porphyrin a2u and iron d(xy), orbitals caused by the S4 ruffling of the porphyrin core.     

Chelate and intramolecular ion-pair formation: A guiding concept for structure/selectivity relationships in the liquid-liquid extraction of alkali and alkaline earth metal ions by anionic crown ether derivatives

Crown ether dyes with pendent anionic side-arms were synthesized for extractionspectrophotometry of alkali and alkaline earth metal ions. Dramatic changes in metal selectivity were obtained simply by changing the nature of the anionic side-arm on the same crown ether skeleton. A structure/metal selectivity relationship is discussed in detail in terms of “chelate” and “intramolecular ion-pair” formation. Small metal cations (high charge density) are preferred in the extraction by a crown ether reagent with a charge-localized anionic side-arm through the formation of a “chelate”. Large metal cations (low charge density) are preferred in the extraction by reagents with a charge-delocalized anionic side-arm through the formation of an “intramolecular ion-pair”. Steric restrictions imposed by the side-arm on the metal ion approaching the crown ether are also important factor in controlling the selectivity of these reagents.     

Difference in spin crossover pathways among saddle-shaped six-coordinated iron(III) porphyrin complexes

The electronic states of a series of saddle-shaped porphyrin complexes [Fe(OMTPP)L(2)](+) and [Fe(TBTXP)L(2)](+) have been examined in solution by (1)H NMR, (13)C NMR, and EPR spectroscopy and by magnetic measurements. While [Fe(OMTPP)(DMAP)(2)](+) and [Fe(TBTXP)(DMAP)(2)](+) maintain the low-spin (S = (1)/(2)) state, [Fe(OMTPP)(THF)(2)](+) and [Fe(TBTXP)(THF)(2)](+) exhibit an essentially pure intermediate-spin (S = (3)/(2)) state over a wide range of temperatures. In contrast, the Py and 4-CNPy complexes of OMTPP and TBTXP exhibit a spin transition from S = (3)/(2) to S = (1)/(2) as the temperature was decreased from 300 to 200 K. Thus, the magnetic behavior of these complexes is similar to that of [Fe(OETPP)Py(2)](+) reported in our previous paper (Ikeue, T.; Ohgo, Y.; Yamaguchi, T.; Takahashi, M.; Takeda, M.; Nakamura, M. Angew. Chem., Int. Ed. 2001, 40, 2617-2620) in the context that all these complexes exhibit a novel spin crossover phenomenon in solution. Close examination of the NMR and EPR data of [Fe(OMTPP)L(2)](+) and [Fe(TBTXP)L(2)](+) (L = Py, 4-CNPy) revealed, however, that these complexes adopt the less common (d(xz), d(yz))(4)(d(xy))(1) electron configuration at low temperature in contrast to [Fe(OETPP)Py(2)](+) which shows the common (d(xy))(2)(d(xz), d(yz))(3) electron configuration. These observations have been attributed to the flexible nature of the OMTPP and TBTXP cores as compared with that of OETPP; the relatively flexible OMTPP and TBTXP cores can ruffle the porphyrin ring and adopt the (d(xz), d(yz))(4)(d(xy))(1) electron configuration at low temperature. Therefore, this study reveals that the rigidity of porphyrin cores is an important factor in determining the spin crossover pathways.     

A novel method for determination of inorganic oxyanions by electrospray ionization mass spectrometry using dehydration reactions

Novel methods for the determination of inorganic oxyanions by electrospray (ES) ionization mass spectrometry have been developed using dehydration reactions between oxyanions and carboxylic acids at the ES interface. Twelve oxyanions (VO₃^?, CrO₄^2?, MoO₄^2?, WO₄^2?, BO₃^3?, SiO₃^2?, SiO₄^4?, AsO₄^4?, AsO₂^?, SeO₄^2?, SeO₃^2? and NO₂^?), out of 16 tested, reacted with at least one of four aminopolycarboxylic acids, i.e. iminodiacetic acid (IDA), nitrilotriacetic acid (NTA), trans‐1,2‐diaminocyclohexane‐N,N,N′,N′‐tetraacetic acid and triethylenetetramine‐N,N,N′,N″,N′″,N′″‐hexaacetic acid, at the ES interface to produce the dehydration products that gave intense mass ion responses, sufficient for trace analysis. As examples, trace determinations of Cr^VI and silica in water samples were achieved after online ion exchange chromatography, where the dehydration product of CrO₄^2? and NTA (m/z 290) and that of SiO₄^4? and IDA (m/z 192) were measured. The limits of detection of the respective methods were 17 nM (0.83 ng Cr/ml) for Cr^VI and 0.17 μM (4.8 ng Si/mL) for SiO₄^4?. Copyright © 2016 John Wiley & Sons, Ltd.     

Brush‐First ROMP of poly(ethylene oxide) macromonomers of varied length: impact of polymer architecture on thermal behavior and Li+ conductivity

The properties of polymeric materials are dictated not only by their composition but also by their molecular architecture. Here, by employing brush‐first ring‐opening metathesis polymerization (ROMP), norbornene‐terminated poly(ethylene oxide) (PEO) macromonomers ( MM‐n , linear architecture), bottlebrush polymers ( Brush‐n , comb architecture), and brush‐arm star polymers ( BASP‐n , star architecture), where n indicates the average degree of polymerization (DP) of PEO, are synthesized. The impact of architecture on the thermal properties and Li⁺ conductivities for this series of PEO architectures is investigated. Notably, in polymers bearing PEO with the highest degree of polymerization, irrespective of differences in architecture and molecular weight (~100‐fold differences), electrolytes with lithium bis(trifluoromethanesulfonyl)imide (LiTFSI) as an Li⁺ source exhibit normalized ionic conductivities (σ_n) within only 4.9 times difference (σ_n = 29.8 × 10^?5 S cm^?1 for MM‐45 and σ_n = 6.07 × 10^?5 S cm^?1 for BASP‐45 ) at a concentration of Li⁺ r = [Li⁺]/[EO] = 1/12 at 50 °C. © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 448–455