Optical characteristics of Cr and Nd codoped Y3Al5O12 ceramics

The optical characteristics of Cr³⁺ and Nd³⁺ codoped Y₃Al₅O₁₂ (YAG) ceramics are measured. These measurements are done using two pumping sources, a 808 nm laser diode (LD) and a Xe short-arc lamp, to simulate solar radiation. The specimens used are 0.1%Cr³⁺/1.0%Nd³⁺ and 3.0%Cr³⁺/1.0%Nd³⁺ (atomic%) codoped YAG ceramics. A Nd:YAG crystal doped with 1.0%Nd³⁺ is used as a reference. The saturation intensities of the Cr/Nd:YAG ceramics pumped by the LD are the same as that of the Nd:YAG crystal, while they are higher when they are pumped by the Xe lamp. The saturation intensities are for the 0.1% Cr-doped ceramic and for the 3.0%Cr-doped ceramic. The small signal gains of the 0.1%Cr-doped and 3.0%Cr-doped ceramics are measured and found to be 1.8 times and 7.0 times higher than that of Nd:YAG for the same intensity of solar pumping, respectively. The quantum efficiency of energy transfer from Cr³⁺ to Nd³⁺ is estimated to be 0.88±0.09 for the 0.1%Cr-doped ceramic and 0.67±0.08 for the 3.0%Cr-doped ceramic.     

Ni-P alloy-carbon black composite films fabricated by electrodeposition

Ni-P alloy-carbon black (CB) composite films were fabricated by electroplating and their microstructures and properties were examined. The CB and phosphorus contents of the composite films were also investigated. The CB particles were found to be embedded in the Ni-P alloy matrix. The CB content in the deposits increased, reached a maximum value of 0.77 mass% with increasing CB concentration in the bath up to 10 g dm⁻³, and then decreased with a further increase in the CB concentration in the bath. Both before and after heat treatment, the composite films had higher hardnesses and lower friction coefficients than the Ni-P alloy films. Both before and after heat treatment, the friction coefficient of 0.77 mass% CB composite films was about half that of Ni-P alloy films without CB.     

A graph-theoretic approach to a partial order of knots and links

We say that a link L₁ is an s-major of a link L₂ if any diagram of L₁ can be transformed into a diagram of L₂ by changing some crossings and smoothing some crossings. This relation is a partial ordering on the set of all prime alternating links. We determine this partial order for all prime alternating knots and links with the crossing number less than or equal to six. The proofs are given by graph-theoretic methods.     

Microstructure of Milled Mesophase Pitch-Based Carbon Fibers as an Anode Material for Li-ion Batteries

Abstract

The microstructure of milled mesophase pitch-based carbon fibers (mMPCFs) that have been developed as an anode material for Li ion batteries have been studied as a function of heat treatment temperature (HTT), by SEM, X-ray diffraction, and Raman spectroscopy. And the results obtained are compared with those by X-ray diffraction (XRD) and SEM observations, for the characterization of specific structural features of mMPCFs as a promising anode material.     

High pressure organic chemistry; XV. Non-catalyzed cleavage reaction of ethers with acyl halides

Abstract

A variety of cyclic and acyclic ethers are efficiently reacted with acyl chlorides or acyl bromides to afford the ether-cleaved compounds of ω-chloro-or ω-bromoesters under high pressure conditions. The reactivity of ethers is found to be roughly depend on the basicity of the ether oxygen atom.     

Design of New Reaction Fields for Spherical Polypyrrole Particle Synthesis

Summary: Polypyrrole conducting polymers have been investigated widely for various applications because of their thermal and environmental stability and good electrical conductivity. Using chemical oxidative polymerization for the synthesis of polypyrrole particles, the reaction rate is very fast. In this study, we designed two new reaction fields for the synthesis of spherical polypyrrole nanoparticles. In the first system, oxidative polymerization of monomer droplets infused in a water/oil (W/O) emulsion reaction field was investigated. The second system employed dispersed monomer in an aqueous solution with a low concentration of oxidant in which polymerization was augmented by ultrasonic irradiation. Effective control of the reaction rate was important for enabling the synthesis of fine spherical polypyrrole particles.     

Study of Neutron-Rich Hypernuclei by the (π −, K +) Reaction at J-PARC

We are planning to perform an experiment at J-PARC and produce new neutron-rich Λ hypernuclei by using the (π ^?, K ⁺) reaction (J-PARC E10). As the first step, we are planning to produce ${^6_{\Lambda}{\rm H}}$ hypernuclei with a ⁶Li target. To conduct this experiment, we are developing new detectors, those are scintillating fiber tracker, and silicon strip detector, for high rate operation to aim at increasing beam intensity up to 10⁷/spill. As a result of beam test in Jun 2012, we are going to use high-rate beam at least 10⁷/spill.     

Analysis of the nuclear quadrupole interaction of Disulfur Dichloride, S2Cl2

Pure rotational spectra of S₂³⁵Cl₂ and S₂³⁵Cl³⁷Cl have been observed using a Fourier-transform microwave spectrometer. An analysis of the hyperfine structure made by considering the nuclear spin statistics showed that S₂Cl₂ has C₂symmetry, where the hyperfine splittings due to the two Cl nuclei were analyzed precisely. The nuclear quadrupole coupling constants including the off-diagonal (χ_ab, χ_ac, χ_bc) components and the nuclear spin–rotation interaction constants associated with the two Cl nuclei have been determined for the first time. We have shown that the nuclear quadrupole interaction plays an important role in the ortho–para mixing.