Modeling of the Permeate Flux during Microfiltration of BSA-Adsorbed Microspheres in a Stirred Cell

A study on the variation of the permeate flux was performed in a stirred cell charged with microspheres, to investigate the effects of the stirrer speeds (300, 400, and 600 rpm) and the BSA concentration (0.1, 0.2, 0.4, and 0.8 g/L) under constant pressure. The permeate flux increased over time before the saturation point, but it began to decrease after that point. An increase of the BSA concentration and the stirrer speed resulted in the rapid increase of the permeate flux. This is contrary to the observation of the conventional filtration experiments using a stirred cell. A resistance-in-series model was employed for the modeling of the permeate flux. The cake resistance (R(c), induced by the concentration polarization of microspheres) and the fouling resistance (R(f), induced by the adsorption of BSA inside the membrane pore) must be considered simultaneously for the modeling. These modeling results were in good agreement with the experimental data. These can be applied to the special system considering both R(c) and R(f) as well as the general filtration systems using a stirred cell. Copyright 2000 Academic Press.     

Synthesis and Structures of Titanosiloxane Cage Compounds

Reaction of (triphenylmethyl)silanetriol (1) with cyclopentadienyltitanium trichloride (CpTiCl₃) in the presence of triethylamine as a HCl scavenger gave both compounds of a partial open-cage type {[Ph₃CSiO(OH)]₃(Ph₃CSiO_3/2)(CpTiO_3/2)₄} (2) and cube type (Ph₃CSiO_3/2CpTiO_3/2)₄ (3). The 1:1 reaction of 1 and CpTiCl₃ in toluene solvent at reflux temperature for 3 d afforded compounds 2 (22%) and 3 (36%). When 1 is reacted with a 1.5 fold excess of CpTiCl₃ under the same conditions, compound 3 was obtained in high yield (81%) along with 2 in trace quantities. Compounds 2 and 3 were fully characterized by the analyses of ¹H, ¹³C, ²⁹Si NMR, IR, and FAB MS data. The solid-state structure of 3 was determined by a single crystal X-ray diffraction study. Compound 3 had shown to have catalytic activity for the oxidation of alkenes such as 1-octene, cyclooctene, and norbornene with t-butyl hydrogen peroxide. The effect of solvent was observed in this epoxidation reaction. The order of reactivity were decreased as follows: CHCl₃ > hexane THF.     

Sphingosine mediates FTY720-induced apoptosis in LLC-PK1 cells

FTY720, a synthetic sphingoid base analog, was examined as a new sphingosine kinase inhibitor, which converts endogenous sphingosine into its phosphate form. With 20 microM of FTY720, sphingosine accumulated in the LLC-PK(1) cells in a time- and dose-dependent manner. The FTY720 treated cells showed a high concentration of fragmented DNA, a high caspase-3 like activity and TUNEL staining cells. It was also found that the sphingosine and sphinganine level increased in a time- and dose-dependent manner within 12 h after the FTY720 treatment. The sphingosine kinase activity was reduced by FTY720 as much as other sphingosine kinase inhibitors, N, N-dimethylsphingosine (DMS), dl-threo-dihydrosphingosine (DHS). The fragmented DNA content as a result of the 20 microM of FTY720 treatment and by 5 microM of the exogenously added BSA-sphingosine complex indicated typical apoptosis. Under similar conditions, the accumulated sphingosine concentration in all the cells was almost identical even though the sphingosine distribution inside the cells was somewhat different. These results indicate that the FTY720 induced apoptosis is associated with the inhibition of the sphingosine kinase activity and is strongly associated with the successive accumulation of sphingosine.     

Chromatographic separation and mass spectrometric identification of positional isomers of polyethylene glycol-modified growth hormone-releasing factor (1-29)

A one-step chromatographic method capable of separating all isomers of polyethylene glycol (PEG)-growth hormone-releasing factor (GRF) (1-29) conjugates was developed. The unmodified GRF (1-29) and seven different isomers of PEG-GRF (1-29) conjugates were separated by using a simple reversed-phase HPLC method depending on the differences of hydrophobicity due to the number and site of PEG attachment. The PEGylation sites of all isomers of PEG-GRF (1-29) conjugates were identified by determining the molecular masses of the Lys-C digested fragments with matrix-assisted laser desorption/ionization time-of-flight mass spectrometry. This study is a first report for the separation of all PEG-conjugate isomers and would be useful for further studies to find the promising conjugate by evaluating biological activity and stability of each isomer.     

Electron paramagnetic resonance study of partially oriented clay platelets intercalated with copper(II) 1,4,8,11-tetraazacyclotetradecane

Electron paramagnetic resonance (EPR) spectra of powder and oriented films of montmorillonite, hectorite, and saponite intercalated with [Cu(cyclam)](2+) (cyclam = 1,4,8,11-tetraazacyclotetradecane) exhibit three components: an orientation-dependent component without hyperfine features, an orientation-dependent component with hyperfine features, and an orientation-independent component without hyperfine feature. EPR spectra of [Cu(cyclam)](2+)-saponite, which exhibit only two components and the best resolved hyperfine features, were simulated. The spectra indicate that a large portion of the saponite platelets are inclined to the glass surface, although they tend to align with their basal planes parallel to the glass surface. The orientation-dependent spectra could be simulated by introducing a Gaussian distribution with a standard deviation of 20 degrees for the inclination angle. The standard deviation may be used as a disorder parameter for the microcrystals assembled on glass plates. Spectral simulation also shows that the CuN(4) plane of [Cu(cyclam)](2+) is parallel to the clay layers. EPR spectra of some other partially oriented systems are also discussed.     

Langmuir monolayers of Co nanoparticles and their patterning by microcontact printing

In this paper, we describe an easy and reliable method for the production of patterned monolayers of Co nanoparticles. A two-dimensional monolayer of Co nanoparticles is fabricated by spreading a nanoparticle solution over an air-water interface and then transferring it to a hydrophobic substrate by using the Langmuir-Blodgett (LB) method. Transmission electron microscopy (TEM) was used to show that, with increasing surface pressure, the Co nanoparticles become well-organized into a Langmuir monolayer with a hexagonal close-packed structure. By controlling the pH of the subphase, it was found that a monolayer of Co nanoparticles with long-range order could be obtained. Further, by transferring the Langmuir monolayer onto a poly(dimethoxysilane) (PDMS) mold, the selective micropatterning of the Co nanoparticles could be achieved on a patterned electronic circuit. The electronic transport properties of the Co nanoparticles showed the ohmic I-V curve.     

Mg2Ru5B4 und Mg5Ru13B11, zwei ternäre Magnesium-Rutheniumboride mit Kanalstrukturen

Mg₂Ru₅B₄ and Mg₅Ru₁₃B₁₁, Two Ternary Magnesium Ruthenium Borides with Channel Structures The ternary borides Mg₂Ru₅B₄ and Mg₅Ru₁₃B₁₁, crystallizing in the orthorhombic space group Pbam, were prepared by reaction of the elementary components in sealed tantalum ampoules. Mg₂Ru₅B₄ (a = 1000.0(2) pm, b = 837,6(1) pm, c = 295.42(3) pm, Z = 2, R_W = 0.027 for 563 reflections) is homeotypic with Sc₂Ru₅B₄. The structure contains BRu₆-trigonal prisms, connected by faces and edges to form pentagonal channels filled with chains of magnesium atoms. Mg₅Ru₁₃B₁₁ (a = 2190.1(2) pm, b = 996.7(2) pm, c = 294.65(3) pm, Z = 2, R_W = 0.031 for 959 reflections) has a similar but so far unknown structure in which parts of the magnesium and boron atoms are disordered.     

Hydroxyl radical is the active species in photochemical DNA strand scission by bis(peroxo)vanadium(V) phenanthroline

Bis(peroxo)vanadium(V) complexes are widely investigated as anticancer agents. They exert their antitumor and cyctotoxic effects through inhibition of tyrosine phosphatases and DNA cleavage, respectively. The latter process remains poorly understood. The mechanism of DNA cleavage by NH(4)[(phen)V(O)(eta(2)-O(2))(2)] (phen = 1,10-phenanthroline) was investigated. Kinetic studies on DNA cleavage revealed that the complex is a single-strand nicking agent with no specificity. EPR experiments using 2,2,6,6-tetramethyl-4-piperidone (TMP) and 5,5'-dimethyl-1-pyrroline-N-oxide (DMPO) as spin-traps for singlet oxygen and hydroxyl radical, respectively, implicated hydroxyl radical production upon photodecomposition of bis(peroxo)vanadium(V). This was corroborated by benzoate inhibition of DNA strand scission and stoichiometric oxidation of 2-propanol to acetone upon irradiation of bis(peroxo)vanadium(V) phenanthroline. High-resolution polyacrylamide gel analysis of the vanadium cleavage reaction and [Fe(II)EDTA](2)(-)/H(2)O(2) resulted in comigration of "ladder" pattern bands, which superimposed when both reactions were run on the same lane. These findings identify hydroxyl radical produced from the photooxidation of the peroxo ligand on vanadium as the active species in DNA cleavage.     

Anatase-Rutile Transition of Precipitated Titanium Oxide with Alcohol Rinsing

The effect of alcohol washing on the anatase-rutile transition of precipitated titanium oxide was investigated using X-ray powder diffraction, Fourier-transform IR spectroscopy, and thermogravimetry. Alcohol (butanol) rinsing accelerated the anatase-rutile transition of precipitated titanium oxide powder so that the onset temperature of transition decreased drastically from 800 degrees C for water-washed powder to 550 degrees C for alcohol-rinsed powder. Alternation of transition kinetics and mechanisms by rinsing media could be confirmed from the analysis of temperature and time dependence of rutile content. The attributability of the chemical state of anatase after crystallization, which contained H(2)O, OH, and organic residues, to the change of transition kinetics with alcohol rinsing will be discussed. Two mechanisms, the effect of residual organics and/or H(2)O(OH), could be suggested on the basis of analysis of the difference between chemical states of water-washed anatase and alcohol-rinsed powder. Copyright 2000 Academic Press.     

Experimental and theoretical study on the olefin metathesis of alkenyl Baylis-Hillman adducts using second-generation Grubbs catalyst

[reaction: see text] We have investigated the olefin metathesis from alkenyl Baylis-Hillman adducts using second-generation Grubbs catalyst. In the experiment, the ring-closing metathesis (RCM) product could not be found, while the cross-metathesis (CM) products were found. The computational studies provided consistent explanations for the experimental result. The most limiting factor for the RCM process using second-generation Grubbs catalyst is caused by the high strain and steric effect in the metallacyclobutane intermediates.