掺铥氟磷玻璃的结构、热学性质和光谱性质

制备了不同Al(PO3)3含量的掺铥系列氟磷玻璃,研究了其结构、热稳定性和光谱性质。随着Al(PO3)3含量的增加,该系列玻璃的密度降低,折射率增加,差热分析表明,转变温度、析晶起始温度、析晶峰温度和熔化温度增加。Al(PO3)3摩尔浓度在7%~9%时析晶稳定性最佳。采用归一化的拉曼光谱分析了材料的结构和声子状况,对于该系列氟磷玻璃,Al(PO3)3含量的增加不会影响声子能量,但使声子密度增大。测试了样品的吸收光谱,Tm3 的3H6→3F4在第三通信窗口的L波段有明显吸收。与在其它玻璃基质中相比,Tm3 的3F4能级对应能量偏高,3H4能级对应能量偏低,使得3H4→3F4跃迁波长较大,接近于增益迁移光纤放大器的放大波长。扎得奥菲而特(Judd-Ofelt)理论分析表明随着Al(PO3)3含量增加,离子强度参量Ω2增大,Ω6保持相对稳定,Tm3 的能级寿命降低。     

Unusual resistive switching induced by voltage in La0.7Sr0.3MnO3 thin films

The hysteretic and reversible resistive-switching effect was observed in La_0.7Sr_0.3MnO₃ films at room temperature. The resistive switching was found to be most obvious in films fabricated at 30 Pa oxygen pressure, and more distinct in films fabricated on SrTiO₃ substrates than those fabricated on LaAlO₃ substrates. Moreover, La_0.7Sr_0.3MnO₃ films fabricated at a certain oxygen pressure with indium electrodes showed double ‘8’ type current-voltage loops. Some of the results are explained by considering the influence of the interface effect, electrodes and oxygen vacancies, but the mechanism of the double ‘8’ type current-voltage loops remains an open question.     

考虑翻箱的场桥调度和提箱集卡数量的集成优化

在集装箱码头的进口箱堆场中,码头预约机制、待提箱的实时位置和场桥作业调度方案是制约堆场作业效率和堵塞情况的关键。为缓解进口箱堆场的拥塞情况并提高作业效率,在固定的预约时段内,考虑实时压箱量最少的翻箱规则,兼顾场桥间不可跨越和保持安全间距等现实约束,以场桥最长完工时间最小为目标,构建数学优化模型,设计了嵌入修复算子的改进遗传算法用于求解;通过算例实验验证了算法的有效性和方案的优越性,可为堆场实际作业提供决策参考。     

Thermal Performance of Laser Diode Array under Constant Convective Heat Transfer Boundary Condition

Three-dimensional heat transfer model of laser diode array under constant convective heat transfer coefficient boundary condition is established and analytical temperature profiles within its heat sink are obtained by separation of variables. The influences on thermal resistance and maximum temperature variation among emitters from heat sink structure parameters and convective heat transfer coefficient are brought forward. The derived formula enables the thermal optimization of laser diode array.     

ZnO/p-Si异质结的深能级及其对发光的影响

利用深能级瞬态谱(DLTS)和光致发光谱(PL),研究了ZnO/pSi异质结的两种不同温度(850℃,1000℃)退火下的深能级中心。发现850℃退火的样品存在3个明显的深中心,分别为E₁=E_v+0.21eV,E₂=E_v+0.44eV,E₃=E_v+071eV;而1000℃退火样品仅存在一个E₁=E_v+021eV的中心,且其隙态密度要比850℃退火的大。同时,测量了两个样品的PL谱。发现1000℃退火可消除一些影响发光强度的深能级,对改善晶格结构,提高样品的发光强度有利。     

过量Zn对β-Zn4Sb3热电性能影响的研究

采用真空熔融缓冷方法制备了单相β-Zn4Sb3以及含有过量Zn的β-Zn4Sb3块体热电材料.在300—700K的温度范围内测试了材料的电导率、Seebeck系数和热导率,研究了β-Zn4Sb3化合物中过量Zn的分布状态及其对材料热电性能的影响规律.结果表明：过量的Zn作为第二相较均匀的分布在β-Zn4Sb3的晶界上,随着Zn含量增加,材料电导率和热导率上升,Seebeck系数下降,Zn第二相的引入能有效提高材料的功率因子,Zn过量2at%的材料在700K时其ZT值达到1.10.     

二元Lennard-Jones液体的相分离过程及其扩散性质的分子动力学研究

采用分子动力学(MD)模拟方法,研究了二元体系中相分离过程、粒子的扩散系数以及相分离域尺寸大小随温度的变化规律.发现,相分离域随温度的生长过程可以分为两个阶段,分别是温度比较高的快速生长阶段和低温时的稳定生长阶段;相分离体系中系统的扩散激活能不是常数,而是一个随温度变化的函数,并且当温度高于60 K时,满足关系式E(T)=a+bT^c.讨论了组元尺寸的变化对相分离过程的影响.结果表明,随两组元中某一组元 关键词： 相分离 扩散 分子动力学模拟     

混合工质HFC134a/HCs替代R502的性能分析

针对目前R502主流替代工质R507和R404A存在的温室效应指数高、与矿物油互溶性差等缺点,提出了环保性能更好的三组近共沸混合工质R134a/R290、R134a/R1270和R134a/R290/R1270作为R502新型替代工质;并对其热物性、循环性能、安全性能和溶油性进行了计算分析。结果表明：除了压缩机排气温度偏高,这三组R134a/HCs混合工质的其它主要循环性能参数如压缩机压力比、容积制冷量和系统性能系数COP都优于R507和R404A,并且从理论上讲不存在可燃可爆的危险,同时可以与矿物油互溶,在替代R502方面更具有优势,其中R134a/R290/R1270在高热负荷下的综合性能最优良。     

High performance of N,P co-doped metal-free carbon catalyst derived from ionic liquid for oxygen reduction reaction

Journal of Solid State Electrochemistry - One-pot strategy to fabricate N, P co-doping carbon was developed based on the functional ionic liquid (IL) as the N, P, and C precursors. The IL featuring...     

The efficient in‐situ reduction and cyclization reaction of aromatic aldehyde, 1,3‐cyclopentanedione (tetronic acid), and nitro‐compound under SnCl2·2H2O‐THF medium

An efficient in‐situ reduction and cyclization reaction for the synthesis of pyrazolo[4,3‐f]quinoline, pyrazolo[3,4‐f]quinoline, and pyrazolo[3,2‐f]quinoline derivatives directly form 5‐nitroindazole, 6‐nitroindazole and 5‐nitroindole in the presence of SnCl₂·2H₂O was reported. Compared to traditional synthetic methods, this approach has the advantages of stable reagents, easy obtaining raw material, and high yields. In this research, SnCl₂·2H₂O is the efficient reducing agent for the in‐situ reduction and cyclization reaction of nitro‐compound. In addition, this process provided an alternative approach for the synthesis of target compounds.